Instruction Manual - North American Cable Equipment
Contents
1. switching inputs to the amplifier 4 Do not use any chemical solvents to clean the speaker Use only a damp cloth with mild cleanser Direct burial wire or conduit In most cases direct burial of the wire to the speaker should suffice It may be necessary to use conduit to protect the speaker cable from the elements Always check with your local building and electrical codes to ensure you are in compliance For 8 ohm operation cut wires here Use RED wire for input use the BLACK wire for input Common CONNECTIONS WIRING BLACK COMMON BLUE 2 WATTS 70V 4 WATTS 100V GREEN 4 WATTS 70V 8 WATTS 100V YELLOW 8 WATTS 70V 16 WATTS 100V ORANGE 16 WATTS 70V 32 WATTS 100V BROWN 32 WATTS 70V NO 100V Connections can be protected using one of the following methods Solder wires together and use waterproof heat shrink tubing to seal them Use weatherproof wire connectors Make connections with immersion resistant crimp splices Use Ggrease wire caps Connection This speaker can be configured for use with 8 ohm amplifiers or 70V 100V amplifiers If using a 70V 100V amp use the black wire as common and then the appropriate colored wire to match the power and voltage of the amplifier If using an 8 ohm amplifier cut the red and white wires where they join then use the BLACK wire for common and the RED wire for Positive Precautions Most speaker damage is caused by using an amplifier with2. UNDERPOWERING VS OVERPOWERING es 2 CHANNEL AMPLIFIER WITH 8Q OUTPUT Observe correct Polarity for maximum Bass performance 2 SPEAKERS PER CHANNEL CONNECTED IN PARALLEL TECHNIAL SPECIFICATIONS Model SD LPSPKR 6 5 Frequency Resp 10dB Hz 80 20K Sensititivy 1W 1M dB 88 Impedance ohm 8 RMS power watts 60 Peak power watts TO Tanca tacos 70V 32 16 8 4 2W amp 8ohms 100V 32 16 8 4 2W amp Bohms Enclosure material LLDPE Environment IP56 Product Dimensions mm 320x230x270 ymphonic SD LPSPKR 6 5 User Manual Introduction Thank you for purchasing this Symphonic Designs SD LPSPKR 6 5 outdoor speaker Please read these instructions carefully before installation IMPORTANT Symphonic Designs has made every effort to provide accurate and detailed instructions for this product s installation and use Should you have any questions or doubts about the correct way to wire or use this speaker please call Symphonic Designs tech support at 610 429 1821 Choose 3 for tech support then choose 5 for Symphonic Designs and other NACE Brands Read these instructions carefully before installation or use of this product 1 When these speakers are installed outdoors unsure that the wiring is properly routed concealed or buried to ensure that it is not cut by typical landscaping maintainenance 2 Ensure the speakers sit firmly where placed and cannot tip over 3 Turn down the volume level when
3. too little power An overdriven amplifier clips the signal sending distortion to the speakers Clipping is usually audible distortion and clicks can be heard If you hear clipping turn down the source material until the clipping stops Damage caused by improper use or powering of the speakers is not covered by the warranty EXAMPLE OF 70V 100V SYSTEM CONFIGURATION 70V 100V Illesso lll Amplifier 5 SPEAKERS CONNECTED IN PARALLEL USING I6W TAPS Symphonic Designs www symphonicdesigns com 800 429 1821 press 3 then 4
Download Pdf Manuals
Related Search