USER MANUAL - Opentip.com
Contents
1. fun simply dood products for real life USER MANUAL Model No 9020CT Pure Fun e Ure Race Car Jumper Trampoline gt N Age Recommendation 4 10 Do not allow more than one person on this product at any time Adult supervision is required ADULT ASSEMBLY REQUIRED Please read all the instructions before using this product Consult a physician before beginning any exercise program or strenuous activity The contents of this package are not suitable for children under 3 years of age Contains small parts which may cause choking 75 LBS MAXIMUM WEIGHT RATING IMPORTANT MESSAGE PLEASE READ WARNING CHOKING HAZARD Small Parts NOT for children under 3 year of age ADULT ASSEMBLY REQUIRED WARNING While every attempt is made to ensure the highest degree of protection in all equipment we cannot guarantee freedom from injury The user assumes all risks of injury due to use All merchandise is sold on this condition which no representative of the company can waive or change Please read these warnings and the information in this manual in its entirety Failure to comply with the following instructions may increase the risk of serious injury and or death WARNINGS IMPORTANT PLEASE READ e This unit must be assembled and disassembled by ADULTS ONLY e This Trampoline is suitable for use by most children 4 to 10 YEARS OF AGE e DO NOT exceed the MAXIMUM WEIG2. PC Bolt 12 PC Nut 12 PC S i E i 1 1 Place a Frame Leg 5 against a Frame Section 16 Ensure that the grooved side of the frame section is facing inwards parallel with the open end of the Frame Leg see below for ASS E M BLE FRAM E Clarification Line up one of the Bolt holes in the Frame Leg to the corresponding hole in the Frame Piece Thread 1x Bolt 7 through the Frame Leg and Frame Section so that the threaded end points down towards the plastic Leg Cap Place a Washer 8 on the Bolt End and loosely secure with a Hex Nut 9 Take another Frame Section and secure it to the remaining hole in the Frame Leg using the above instructions Continue assembling the frame as described above Washer 12 PC DO NOT FULLY TIGHTEN NUT BOLT COMBINATIONS UNTIL THE ENTIRE FRAME IS Mat 1 PC ASSEMBLED ALSO NOTE THAT BEFORE THE SPRINGS AND MAT ARE ATTACHED THE Springs 30 PC FRAME MAY NOT BE COMPLETELY CIRCULAR ONCE THE SPRINGS ARE ATTACHED TO THE MAT THIS WILL CAUSE THE FRAME TO CONFORM TO ITS PROPER CIRCLE SHAPE 2 Once the Trampoline frame is complete and you have tightened all the bolts securely flip the trampoline over and install the mat Center the Logo on the mat so it is perpendicular to any one of the legs and begin to attach the springs using the Spring Tool Using the Spring Tool Place the end of the spring which is more closed onto the V Ring sewn into the Trampoline Mat Next Hook the end of the spring w
3. BLED THE HANDLE PIECES ON THE WRONG LEGS REMOVE THE HANDLE BASES AND SWAP THE SIDES THEY ARE ATTACHED TO
4. HT limit of 75lbs 35kgs regardless of age e FOR INDOOR HOME USE ONLY This Trampoline is designed for indoor family residential use It is NOT intended for use outdoors or in commercial applications and or use in public areas such as schools parks nurseries day schools day cares etc e ALWAYS locate this equipment on a stable level surface AT LEAST 7 feet away from any structure obstruction or possible hazard s such as walls pools power lines overhangs other playground equipment driveways hard surfaces and or roadways e Children must be supervised at all times when using this equipment DO NOT leave children unattended at any time e DO NOT attach items to the trampoline not specifically designed for this purpose Especially in the case of jump ropes chains clotheslines pet leashes and cables These may cause a strangulation or physical hazard e This Trampoline is NOT for adult or adolescent use e DO NOT allow more than one child on the Trampoline at any time e DO NOT allow children to wear glasses or helmets when using the Trampoline e DO NOT allow the padding cover of this trampoline to become wet If accidental spillage occurs immediately blot this with a moist paper towel and allow to dry e DO NOT allow children to wear loose fitting clothing clothing with straps loops backpacks or wear and or hold accessories with straps or loops or any article of clothing or accessory with sharp edges which may present a haza
5. e logo This will be where the nose on the head is located It is important to keep this seam as close to the chosen leg as possible during assembly of the trampoline cover For ease of assembly it is recommended that another adult assist during this step While attaching this cover ensure that the mesh safety skirt stays flat against the springs Once attached place the foam ring on top of the black cover fabric Next fold the red top fabric of the Race Car cover in the same fashion which you attached the black fabric base keeping the foam ring centered on the trampoline S il E I 3 4 Fold the Side Skirt sewn to the top cover down so it covers the frame of the trampoline Begin to tuck the white side skirt padding on the inside of the Side Skirt fabric between it and the trampoline legs Carefully tuck the top of the padding up into the sewn seam of the top skirt fabric and the top padding Do not tie the Skirt ends yet Leaving these ASS EM BLE S D ties free tie the inner strings on the padding to the strings on the inside of the cover skirt fabric SKI RT FAWN D Finally attach the foam loops sewn into the bottom of the Side Skirt to the legs of the trampoline HANDLES PARTS NEEDED Side Skirt Foam Padding 1 Hand Rail Bases 2 Center Handle 1 5 Attach the Handrail Bases to the Trampoline by first removing the plastic Leg Cap from the Legs they are to be placed on Next Slide the Handrail Ba
6. hich is more open with the spring tool and pull the tool towards you until the spring extends to the corresponding hole Push the spring down into the hole with your palm making sure you do not pinch your other fingers in the spring or against the frame Installing the Springs Using compass points as a general reference install two springs at N and S and then an additional two at E and W Once installed count the holes in the top rail and ensure these match up to the available V Rings sewn into the mat Note You may have to move a spring over a space or two to ensure that it is properly matched to its V Ring Continue installing the springs by placing 2 on either side of the N spring and then 2 on either side of the S spring followed by two on either side of the E and W springs Installing the springs in this fashion will ensure that the mat is kept evenly centered and will greatly assist in ease of attaching the springs Once complete fold the mesh safety skirt down so it is covering the springs You may need to place a few weights such as several books on this skirt for a few minutes while it flattens against the frame STEP 2 ATTACH COVER AND PADDING PARTS NEEDED Race Car Cover 1 Inner Padding 1 3 Begin to attach the Race Car cover to the trampoline by locating the large seam in the center of the black fabric see diagram on right Line this seam up to the leg that is located directly above the Trampolin
7. loth Do not jump on the trampoline after cleaning until completely dry e If the paint is chipped we recommend you lightly rub the damaged area and cover using a non toxic enamel paint e f the cover becomes dirty or needs washing remove the foam insert top foam and side skirt foam If possible spot wash the cover If necessary you may hand wash the trampoline cover but please be aware that this will affect the efficiency of the flame retardant applied to to it DO NOT Machine Wash or Tumble Dry Always allow to air dry IMPORTANT While no regular maintenance is required you must inspect the trampoline before each use and replace any worn defective or missing parts The following conditions could repre sent potential hazards Missing improperly positioned or insecurely attached frame padding Punc tures frays tears or holes worn in the bed or frame padding Deterioration in the stitching or fabric of the bed or frame padding Broken or missing springs A bent or broken frame A sagging jump mat or sharp protrusions on the frame or suspension system Cease using trampoline immediately and secure it against unauthorized use if any of these conditions are present Question The Handrail ends do not point in the right direc FREQU ENTLY tion cannot assemble the center handrail piece are the holes drilled wrong QU ESTIONS Answer IF THE HANDLE PIECES DO NOT SEEM TO BE ORIENTED IN THE CORRECT DIRECTION YOU MAY HAVE ASSEM
8. rd or become snagged or caught on the Trampoline during use Serious injury and or accidental strangulation may occur e DO NOT place objects on or under the trampoline or allow people and pets to stand or sit on near or under the unit e DO NOT allow children to sit or stand on the frame pad edge or attempt to hang or swing from the hand rail this presents a tipping hazard and can cause serious injury e Never allow a child to jump from or onto this trampoline from any other object or surface area e Children must ALWAYS jump while securely centered on the Trampoline mat It is recommended that children always keep a firm grip on the handrail during exercise e DO NOT store this item outside or in extreme humidity or temperatures e ALWAYS secure the Trampoline against unauthorized and unsupervised use e t is not recommended that this trampoline is used while wearing shoes Additionally children should always wear socks when jumping to prevent injury to feet e Before each use of this product inspect this unit for any worn defective or missing parts Although this Trampoline is made to take a lot of wear over time parts may need to be replaced It is important to check the unit to ensure the Springs Frame Padding and Safety Skirt are undamaged and secure and all parts are in good condition If any loose cracked missing or otherwise damaged components are found cease use of this item immediately and secure it from una
9. ses up onto the unit and secure by replacing the Leg Cap Join the Handrail Bases together by snapping the Center Handle piece into place Lastly the the strings at the ends of the padding and side cover around the leg using the fabric loops sewn into the padding NOTE If you are unable to attach the center handle piece switch the sides the Handrail Bases are attached to aes S i z p A 6 To attach the head of the Race Car to the trampoline first slide the remaining leg through the loop sewn into the center of the back of the head Next tie the bottom side panel of the head to the Handrail Bases Next attach the sides of the head using the velcro straps Lastly secure this assem ASS EM BLE bly using the ties at the top of the side panels HEAD and ACCESSORIES PARTS NEEDED Race Car Head 1 Race Car Wheels 4 License Plate Insert 1 6 To attach the wheels to the side panel of the Race Car first peel the backing off of the hook and loop straps on the rear side of the wheels if present Affix to the side panel of the skirt using these straps Next remove the license plate from the sleeve and insert into the clear plastic pocket on the rear of the unit Note Visit pureglobalbrands com for information on how to obtain a personalized license plate Al N TE N AN C F Your kids trampoline is designed to be very low maintenance e f any part of the trampoline frame requires cleaning simply wipe with a damp c
10. uthorized use until the issue has been corrected and or replacement parts obtained Failure to do so may result in injury and or void your warranty e Please read and refer to other warnings and use information in the Trampoline instructions before use Dispose of all packaging materials safely and per local ordinance PRIOR TO ASSEMBLING PARTS LIST Trampoline When you are ready to start make sure that you have the correct tools at hand and adequate space for assembly Please refer to the following pages for part descriptions and numbers The assembly instruction uses these descriptions and numbers as reference Make sure you have all parts listed IMPORTANT USE GLOVES TO PROTECT AGAINST PINCH POINTS DURING ASSEMBLY Enclosed are the current specifications and product features available at time of printing however changes may be made in equipment availability specifications and features without notice Tools Required Included Spanner Wrench Allen Wrench Spring Tool TRAMPOLINE EXPLODED 16 PartNo Description ty PartNo Description Jawy a Trampoline Mat fa Hexnut 12 2 Loft Handie w Foam 1 Spring 30 3 Right Handle wi Foam 1 Spring Too 4 Center Handie w Foam 1 Wrenn h Ss Frameteg fe Allen Key M 6 tegep l Enacap 2z z eet Handie Base Insert 4 a Washer Frame Section 6 a ee PARTS NEEDED Frame Legs 6 PC Frame Pieces 6
Download Pdf Manuals
Related Search