Indoor/Outdoor RECHARGEABLE LAMP
Contents
1. VEC1376RL_Manual_030405 3 4 05 6 11 PM Page 4 If you suspect the bulb is burned out check if the lamp will operate when powered using the AC charger adapter If Low brightness is selected and the bulb won t light it probably needs to be replaced You will need a new replacement bulb Vector part VEC193 The globe assembly that contains the bulb is in two halves To remove the top halt of the globe the three flanges under the shade must be unscrewed from the three supports that fasten the shade to the globe They can be removed without tools SUPPORTS FLANGE 1 Make sure the lamp is turned OFF 2 Reach under the shade and unscrew counterclockwise all three flanges until they slide down the supports Lift off the shade and top half of the globe and set them aside Using a cloth grasp the bulb pull it straight up and dispose of it properly Using a clean cloth remove the bulb from its package Avoid touching it with bare skin Note the two pins and the small holes on the bulb socket Insert the two pins of the bulb into the socket and make sure they are fully seated Briefly turn on the lamp to test operation of the new bulb Locate the shade and top half of the globe and reattach the flange threads one at a time in the shade assembly 10 Continue to tighten clockwise so the globe is secure DO NOT OVERTIGHTEN e A high quality G4 base 6 volt 10 watt bulb may be used if a VEC193 bulb is not a2. a new or reconditioned unit of the same or comparable design The repaired or replaced unit will then be warranted under the terms of the remainder of the warranty period The customer is responsible for the shipping charges on all returned items after 30 days During the warranty period manufacturer will be spel for the return shipping charges LIMITATIONS This warranty does not cover accessories bulbs fuses and batteries defects resulting from normal wear and tear including chips scratches abrasions discoloration or fading due to usage or exposure to sunlight accidents damage during shipping to our service facility alterations unauthorized use or repair ses misuse abuse failure to follow instructions for care and maintenance fire flood and Acts of God If your problem is not covered by this warranty call our Technical Support goa aed toll free at 866 584 5504 for general repair information and charges if applicable You may also contact us through maan our website at www vectormfg com Only use the AC DC adapter included with the unit for charging and operation Do not expose the charging adapter cords to extreme heat Do not crush cut or pull the charging adapter cords AC DC adapter is intended for indoor use only Pon ee This is not a toy keep away from children STATE LAW RIGHTS This warranty gives you specific legal rights Some states do not allow limitations on how long an implied warranty lasts o
3. rechargeable battery 1 Using household 120 volt AC 60 Hz power and the AC DC power adapter charger included with the unit If the AC that Hanae the lamp is subject to interruptions or power surges the charger adapter should be disconnected when the lamp is not in use or being recharged Note The lamp will operate from 3 hours High brightness setting up to 8 hours Low brightness setting on a fully charged battery VEC1376RL_ Manual 030405 3 4 05 6 11 PM Page 2 Using the 120 Volt AC DC Power Adapter Charger to Power the Lamp the 120 Volt AC DC power adapter charger s barrel connector into the Recharge Port located on the base of the lamp see below n e Plug the AC DC power adapter charger s plug into a powered 120 volt AC wall outlet Make sure that the AC charger adapter is powered from the correct AC source It must only be powered from 110 volts AC 60 Hz The AC charger adapter is rated for indoor use and must be kept dry Only use the supplied AC charger adapter with this lamp Substituting this AC charger adapter for another may damage the lamp s internal charging circuits and wid the warranty OPERATING INSTRUCTIONS The lamp is controlled by the Brightness Selector pushbutton see page 2 Pressing the selector once turns the lamp on at a High brightness pushing it again sets the brightness to Low Pushing it a third time turns the lamp OFF CARE AND MAINTENANCE Cleaning Over time
4. A LY 4 Charge until the green Recharge LED flashes then goes from lit to unlit indicating the battery is fully charged Battery charging times will vary depending on whether the unit is in the OFF or Low brightness setting and the discharge status of the battery Monitor the green Recharge LED In the OFF setting allow at least 10 hours for complete recharging if battery is discharged Battery Replacement The deen pare battery is contained in the base of the lamp It should be replaced when it will no longer hold a charge Before replacing the battery disconnect the 120 volt AC DC Power Adapter Charger from the AC outlet You will need a 6 volt 6 amp hour replacement battery Vector part VEC199 and a small Phillips screwdriver The procedure to replace the battery is as follows 1 Set the lamp on its side 2 Peel back the rubber pad on the bottom of the lamp base and remove the four screws located there Separate the base bottom from the top Observe the RED wire and BLACK wire battery connections Lift the battery away from the base and circuits Remove the slide off connectors from the battery tab connectors Note that the tabs are different sizes to avoid confusion Dispose of the disconnected battery properly Place the RED and BLACK wire connectors on the new battery making sure the RED wire connector is on the POS terminal and the BLACK wire connector is on the NEG terminal 9 Check lamp fo
5. Denokaemgti i h sal Faa adarna d This Vector Manufacturing Ltd product is warranted to the original purchaser only to be free of defects in a idl at E jog E i a ec iis aed j AE l materials and workmanship for one year from the date of nig al without additional charge The 3 Do not immerse the lamp in water See the Care and Maintenance section on page 2 for cleaning warranty does not extend to subsequent purchasers or users Vector Manufacturing Ltd will not be instructions responsible for any amount of damage in excess of the retail Sah tgs idee of the product under any circumstances Incidental and consequential damages are specifically excluded from coverage under this warranty This product is not intended for commercial use This warranty does not apply to accessories or damage to units from misuse or incorrect installation Misuse includes wiring or connecting to improper polarity power sources RETURN REPAIR POLICY Defective products other than accessories may be returned postage hes to Vector rl ay salt poa e Man S that P t o m Manutacturing within 30 days of the date of purchase will be replaced tree of charge It such a product is returned ae than 30 days but less than one a from the Soe date Vector Aa vill repair SAVE THESE INSTRUCTIONS the unit or at its option replace it free of charge If the unit is repaired new or reconditioned replacement parts may be pee at Vector Manufacturing s option A unit may be replaced with
6. dust or fingerprints may accumulate on the lamp If necessary clean the lamp with a soft clean oil free cloth moistened with window cleaner Do not use alcohol based cleaners on the plastic surfaces as this will eventually cause surface clouding If the inside of the plastic guard becomes dirty disassemble as you would for bulb replacement see page 4 and clean with window cleaner Battery Care There is a direct trade off between lamp brightness and battery charge duration The lamp will operate longer in the Low brightness setting Operating your lamp while it is connected to a 120 volt AC power source through the supplied AC DC Power Adapter Charger does not expend battery power Your lamp battery cannot be overcharged if left continuously connected to the charger adapter Battery Recharging The lamp should be recharged after each use or every 60 days if not used or if the battery becomes discharged When the lamp becomes dim when the Brightness Selector is set to High the battery has become discharged To recharge the battery 1 Make certain the lamp is in the OFF or Low brightness setting The lamp cannot be recharged in the High brightness setting 2 Connect the 120 volt AC DC Power Adapter Charger as described in the Powering the Lamp section on page 2 where you will also find other powering charging directions and recommendations 3 The green Recharging LED will light to indicate the battery is charging 2 Z
7. ere sa teema dde piaia a e e E e E E 1 Powering the Lamp 2622 2 6s44oeeenFas odode eeO end Che edhe ee Ke eS 1 Operating INSWUCHONS ss 2nntec bbe e oho G wm So hte eee a Doe a Oe me Re AS 2 Care and Maintenance 0 0 eee eae 2 a i onc ene Sao ame eas oe obi e rb thee eee nooo ee a aoe neha 2 BGNeTY COE 2 ha ha pub ade bos ooo SORE aE a whe wl nee 2 Bulb Replacement 20 eee teas 3 SPECIICCHONS awa ohn bn domed oedoheadherbecu stow aneme Aue lt 6 oe ase 4 INTRODUCTION Thank you for purchasing the VECI376RL Indoor Outdoor Rechargeable Lamp Please read this manual carefully before use to ensure optimum performance and avoid damage to the unit itself or power sources from which it operates FEATURES e Contains an ultra bright replaceable 10 watt quartz halogen bulb e Powered by a proven technology high density spill proof sealed lead acid battery e Supplied with a UL listed 120 Volt AC DC charger adapter e Can be operated at Low brightness setting while recharging e Can be recharged up to 500 times before battery replacement e Use indoors as well as outdoors e High Low brightness selector e Rubber cap seals recharge port to keep out moisture and dust e Recharge LED indicator shows charging status CONTROLS AND FUNCTIONS FRAME DESIGN GLOBE QUARTZ HALOGEN BRIGHTNESS i SELECTOR PUSHBUTTON RECHARGE HIGH LOW OFF PORT POWERING THE LAMP The lamp can be powered in one of two ways 1 Using the
8. r operation by pressing the Brightness Selector 10 Place the battery in the base and reassemble the base 11 Replace the four screws DO NOT OVERTIGHTEN Press the rubber pad back in position 12 Charge the new battery as instructed above Battery Disposal Non Spillable Sealed Lead Acid Battery This battery is fully recyclable and should be accepted at any location that accepts common automotive starter batteries Examples of places that accept these batteries are county or YY municipal recycling drop off centers scrap metal dealers and retailers who sell automotive replacement lead acid starter batteries For more information on recycling this battery call toll free 877 288 7722 A WARNINGS Do not dispose of the battery in fire or expose the battery to fire or intense heat This may result in an explosion e Before disposing of the battery protect exposed terminals with heavy duty electrical tape to prevent shorting which can result in injury or fire Bulb Replacement The supplied 10 watt quartz halogen lamp is a projection quality bulb Operating the lamp at full brightness for long periods reduces the bulb s life O GH KR o N CONTAINS SEALED NON SPILLABLE BATTERY 3 As a
9. r the exclusion or limitation of incidental or consequential damages so the exclusions or limitations stated herein may not apply This warranty gives the purchaser specific legal rights other rights which vary from state to state may apply TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT Contact Vector Manufacturing Technical Support by telephone fax or mail see below We suggest that you keep the original packaging in case you need to ship the unit When returning a product include your name address phone number dated sales receipt or copy and a description of the reason for return and product serial number After repairing or replacing the unit we will make every effort to return it to you within four weeks WARRANTY ACTIVATION Please complete Warranty Activation Card and mail to Vector Manufacturing Enter VEC1376RL as Model and Indoor Outdoor Rechargeable Lamp as Product Type All Vector Manufacturing Ltd products must be registered within 30 days of purchase to activate this warranty Mail the completed registration form along with a copy of the original sales receipt to ATTN CUSTOMER SERVICE 4140 SW 28th Way Ft Lauderdale FL 33312 e TOLL FREE 866 584 5504 FAX 954 584 5556 e BD030405 As ary VEC1376RL_Manual_030405 3 4 05 6 11 PM Page iv TABLE OF CONTENTS ee e e E TEE E EEE EE EE 1 PoE nh ueaeuhe ha car Peee OER PRe hoot a eRe E awe ee ee Controls ana FUNCUCNS ir
10. vailable SPECIFICATIONS Power AC charger adapter 110 volt AC to 7 2 volt DC 1650 mA UL Listed class 2 power supply nH KK SO CO N O amp O Battery VEC 1996 volt 6 Amp Hour sealed lead acid Bulb VEC193 See Note Weight 4 75 lbs 2 15 kg Height 13 75 in 34 9 cm Shade Diameter 9 25 in 23 5 cm Base Width Depth 6 0 in 15 24 cm 2005 VECTOR MANUFACTURING Ltd FT LAUDERDALE FL 33312 MADE IN CHINA 4 VEC1376RL ECTOR The Freedom of POWER w Indoor Outdoor RECHARGEABLE LAMP USER S MANUAL amp WARRANTY INFORMATION IMPORTANT SAFETY INFORMATION SAVE THESE INSTRUCTIONS TO REDUCE THE RISK OF INJURY USER MUST READ AND UNDERSTAND THIS INSTRUCTIONAL MANUAL THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS PRODUCT PLEASE RETAIN FOR FUTURE REFERENCE 4140 S W 28th Way Ft Lauderdale FL 33312 Toll Free 866 584 5504 www vectormfg com VEC1376RL_Manual_030405 3 4 05 6 11 PM Page ii ran ae PLEASE READ THIS USER S MANUAL COMPLETELY FOR ALL SAFETY AND ONE YEAR LIMITED WARRANTY REGISTRATION FORM WARNING INSTRUCTIONS This limited warranty program is the only one that applies to this product and it sets forth all the CAUTIONS responsibilities of Vector Manufacturing Ltd regarding this product There is no other warranty other than 1 Do not operate or charge the lamp in rain or damp conditions those described herein 2
Download Pdf Manuals
Related Search