User manual
Contents
1. on the top of the Bluetooth speaker to adjust volume EN 11 Charge the iPad The docked Pad begins to charge as soon as the unit is connected to AC power Play from an external device You can also listen to an external audio player through the Bluetooth speaker 1 Connect a 3 5mm audio cable to e the AUDIO IN socket on the back of the Bluetooth speaker e the headphone socket on an external audio player 2 Start music play on the external audio player 3 Use on the top of the Bluetooth speaker to adjust volume 5 Prod U ct Dimensions W x H xD information Speaker e Microphone Weight dos e With Packing e Product information is subject to change without prior e Main Unit notice Specifications Amplifier Rated Output Power 2X SW RMS Signal to Noise Ratio gt 0dB Aux in Link 600 mV RMS 20 kohm Speakers Speaker Impedance 4 ohm Speaker Driver 7Omm full range Sensitivity gt 84dB 1m 1W Bluetooth Bluetooth version V2 1 EDR Frequency band 2 402 2 480 GHzISM Band Range 10m free space General information AC power 100 240 V 50 60 Hz Operation Power 20 W Consumption 300 x 162 x 148mm 162 x 333 x 162mm 2 5 kg 1 5kg EN 6 Troubleshooting Warning Never remove the casing of this device To keep the warranty valid never try to repair the system yourself If you encounter problems when using this dev2. 2002 96 o Please inform yourself about the local separate collection system for electrical and electronic products Please act according to your local rules and do not dispose of your old products with your normal household waste Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health R Your product contains batteries covered by the European Directive 2006 66 EC which cannot be disposed with normal household waste Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health Information about the use of batteries w Caution e Risk of leakage Only use the specified type of batteries Do not mix new and used batteries Do not mix different brands of batteries Observe correct polarity Remove batteries from products that are not in use for a longer period of time Store batteries in a dry place Risk of injury Wear gloves when handling leaking batteries Keep batteries out of reach of children and pets Risk of explosion Do not short circuit batteries Do not expose batteries to excessive heat Do not throw batteries into the fire Do not damage or disassemble batteries Do not recharge non rechargeable batteries Environmental information All unnecessary packaging has been omitted We have tried to make the packag
3. and Bluetooth speaker are within the the effective operation range that is approximately 10 meters 30 feet e Press and hold 3 on the top of the Bluetooth speaker for more than 10 seconds to set up wireless connection manually Howling or echo from the wireless microphone e Adjust volume e Increase the distance between the microphone and speaker or adjust the angle of the microphone towards the speaker No response from the Bluetooth speaker e Disconnect and reconnect the AC power plug and then switch on the device again PHILIPS Specifications are subject to change without notice 2012 Koninklijke Philips Electronics N V All rights reserved AEA7000_ UM 10 V1 0
4. with the wireless microphone in case automatic pairing fails Dock for iPad SOFTWARE UPGRADE not for use by end users AUDIO IN e Connect an external audio player through a 3 5mm audio input cable not supplied AC MAINS e AC power socket EN 3 Get started Always follow the instructions in this chapter in sequence Connect power pa Caution e Risk of product damage Make sure that the power supply voltage corresponds to the voltage printed on the back of the unit e Risk of electric shock When you unplug the AC power cord always pull the plug from the socket Never pull the cord Before you connect the AC power cord make sure that you have completed all the other connections e Connect the AC power cord to e the AC MAINS socket on the back of the Bluetooth speaker e the wall power socket Switch on the Bluetooth speaker e Press on the top of the Bluetooth speaker L The power indicator lights up white e To switch the unit to standby mode press on the top panel e To switch the unit on from standby mode press again Tip e Ifthe speaker stays idle for more than 15 minutes it switches to standby mode automatically Install replace microphone batteries RA Caution e Risk of explosion Keep batteries away from heat sunshine or fire Never discard batteries in fire Danger of explosion if batteries are incorrectly r
5. Always there to help you Register your product and get support at www philips com welcome AEA7000 Question Contact Philips User manual PHILIPS Contents 1 Important Safety Notice Your Wireless Microphone and Bluetooth Speaker Introduction What s in the box Overview of the unit Get started Connect power Switch on the Bluetooth speaker Install replace microphone batteries Play Sing along through the wireless microphone Play from a Bluetooth enabled device Play and charge your iPad through the dock connector directly Play from an external device Product information Specifications Troubleshooting O1 U1 al al Sl NNN 11 12 13 13 14 EN 1 Important Safety Information for Europe Know these safety symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL cou N The exclamation mark calls attention to features for which you should carefully read the supplied literature to prevent operating and maintenance problems The lightening bolt symbol indicates uninsulated components within the product that can cause an electric shock To reduce the risk of fire or electric shock do not expose the product to rain or moisture and do not place any objects filled
6. apparatus from the power Risk of overheating Never install this apparatus in a confined space Always leave a space of at least four inches around this apparatus for ventilation Ensure curtains or other objects never cover the ventilation slots on this apparatus Mains fuse This information applies only to products with a UK mains plug This product is fitted with an approved molded plug If you replace the fuse use one with e the ratings shown on the plug e a BS 1362 approval and e the ASTA approval mark Contact your dealer if you are not sure about What type of fuse to use Caution To conform with the EMC directive 2004 108 EC do not detach the plug from the power cord Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the users authority to operate the equipment C 2150 This product complies with the radio interference requirements of the European Community This product is in compliance with the essential requirements and other relevant provisions of Directive 1999 5 EC A copy of the EC Declaration of Conformity DoC is available in the packaging ao Your product is designed and manufactured with high quality materials and components which can be recycled and reused R When this crossed out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive
7. aratus Write the numbers here Model No Serial No Introduction With the Philips wireless microphone and Bluetooth speaker you can e dock your iPad onto the speaker to sing along with music from the app The Voice On Stage through the wireless microphone With the Bluetooth speaker you can e play music from a Bluetooth enabled device that supports A2DP Advanced Audio Distribution Profile e charge or play music from your iPad directly through the dock connector e play music from other audio devices through the AUDIO IN socket What s in the box Check and identify the contents of your package e Wireless microphone e Bluetooth speaker e AC power cord e 3 X AAA batteries e Quick start guide e Safety sheet Overview of the unit Wireless microphone AO Line out socket e To use the microphone separately connect to the MIC input socket of an existing Hi Fi system Q Battery compartment 3 OFF ON e Switch the microphone on or off 4 Power indicator e Light up red when the wireless microphone is switched on e Flash red when the battery level is low Bluetooth speaker EN 5 GIO e Turn the unit on off Power Bluetooth indicator e Indicate the power Bluetooth status e Adjust volume e Press pair with a Bluetooth enabled device that supports A2DP Advanced Audio Distribution Profile e Press and hold pair
8. eplaced Replace only with the same or equivalent type Batteries contain chemical substances so they should be disposed of properly 1 Open the battery compartment and take out the battery cartridge 2 Insert 3 x AAA batteries supplied into the cartridge with correct polarity as indicated EN 7 3 Push back the battery cartridge then close the battery compartment e Ifyou are not going to use the microphone for a long time remove the batteries e New batteries installed in the microphone support up to 30 hours of continuous use When the power indicator flashes red it indicates that the power level is low and you need to replace the batteries 4 Play Sing along through the wireless microphone Note The effective operation range between the wireless microphone and Bluetooth speaker is approximately 10 meters 30 feet 1 Dock your iPad onto the Bluetooth speaker L gt A prompt pops up on the Pad screen asking you to Install the relevant app 2 Tap YES on the prompt to install the app The Voice On Stage from Apple App Store 3 After successful installation run The Voice On Stage on the iPad Slide the OFF ON switch on the wireless microphone to the ON position gt The Bluetooth indicator on the Bluetooth speaker flashes blue hb The wireless microphone starts to pair with the Bluetooth speaker automatically gt After succe
9. h a Bluetooth enabled mobile device make sure that no Pad is docked or you have stopped music play and exited The Voice On Stage on your docked iPad To pair with a new mobile device you can press to remove the existing Bluetooth connection To play from a Bluetooth enabled device make sure that you are not playing music from your iPad docked on the Bluetooth speaker 1 2 Press 3 on the top of the Bluetooth speaker L gt The Bluetooth indicator flashes blue 0 e x Enable Bluetooth on your device that supports A2DP Advanced Audio Distribution Profile 3 Select PHILIPS AEA7000 10 on your Bluetooth enabled device and if necessary Play and charge your iPad input 0000 as the paring password through the dock connector L gt After successful pairing and connection the Bluetooth indicator on the speaker turns solid blue and the Compatible iPad speaker beeps twice directly This unit supports play and charge of the following iPad models e New iPad e Pad2 e Pad Load the iPad e Dock your iPad Y 4 7 4 Start music play on your Bluetooth enabled device To remove the iPad e Pull the iPad out of the dock Listen to the iPad 1 Make sure that the iPad has been loaded correctly 5 Use on the top of the Bluetooth 2 Start music play on your iPad speaker to adjust volume L gt The connected iPad starts to play 3 Use
10. ice check the following points before requesting service If the problem remains unsolved go to the Philips Web page www philips com support When you contact Philips make sure that the device Is nearby and the model number and serial number are available No power to the Bluetooth speaker e Make sure that the AC power plug of the device is connected properly e Make sure that there is power at the AC outlet e Asa power saving feature the speaker switches to standby mode automatically after staying idle for more than 15 minutes Switch on the speaker again see Switch on the Bluetooth speaker on page 7 No power to the wireless microphone e The batteries may be installed incorrectly or drained Install or replace the batteries properly see Install replace microphone batteries on page 7 e Asa power saving feature the microphone switches to standby mode automatically after staying disconnected from the speaker for more than 15 minutes To switch it on again you need to slide the OFF ON switch on the microphone to the OFF position and then back to the ON position No sound or poor sound e Adjust volume e Check the Bluetooth connection e Check whether you have started music play on the connected device Failed to set up connection between the microphone and speaker e Check whether both the wireless microphone and Bluetooth speaker are switched on e Make sure that the wireless microphone
11. ing easy to separate into three materials cardboard box polystyrene foam buffer and polyethylene bags protective foam sheet Your system consists of materials which can be recycled and reused if disassembled by a specialized company Please observe the local regulations regarding the disposal of EN 3 packaging materials exhausted batteries and old equipment Made for iPad Made for iPad means that an electronic accessory has been designed to connect specifically to iPad and has been certified by the developer to meet Apple performance standards Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards Please note that the use of this accessory with iPad may affect wireless performance iPad is a trademark of Apple Inc registered in the U S and other countries The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG Inc and any use of such marks by Philips is under license Note The type plate is located on the back of the unit 2 Your Wireless Microphone and Bluetooth Speaker Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your product at www philips com welcome If you contact Philips you will be asked for the model and serial number of this apparatus The model number and serial number are on the back of the app
12. ssful pairing and connection the Bluetooth indicator turns solid blue 7 Find and download a tutorial from The Voice On Stage then tap SING for how to sing along through the wireless microphone and Bluetooth speaker EN 9 MY SONGS FROM THE SHOW T _ The Voice Australia The Voice UK s The Voic The Voice La Plus Belle Voix This Love Time After Time lt Toxic Trouble True Colors Select a song from The Voice On Stage and sing along through the wireless microphone Use on the top of the Bluetooth speaker to adjust volume Tip If automatic pairing fails press and hold on the speaker for more than 10 seconds to pair the microphone with the speaker manually If the wireless microphone remains disconnected from the Bluetooth speaker for more than 15 minutes it switches to standby mode automatically To switch it on again you need to slide the OFF ON switch on the microphone to theOFF position and then slide back to the ON position You can use controls available on the app to adjust sound effects If you experience howling or echo try to increase the distance between the microphone and speaker or adjust the angle of the microphone towards the speaker EN Play from a Bluetooth enabled device e The effective operation range between the Bluetooth speaker and your Bluetooth enabled device is approximately 10 meters 30 feet To pair wit
13. with liquids such as vases on the product Read these instructions Keep these instructions Heed all warnings Follow all instructions Do not use this product near water Clean only with dry cloth ISS ROTC TORS Do not block any ventilation openings Install in accordance with the manufacturer s instructions Do not remove the casing of this product mM EN 9 Do not expose the product to dripping splashing water rain or high humidity Keep this product away from direct sunlight naked flames or heat 41 Do not install near any heat sources such as radiators heat registers stoves or other electrical equipment including amplifiers Do not place any other electrical equipment on the product on the product e g objects containing liquids burning candles 13 Do not place any sources of danger This product may include batteries Please refer to safety and disposal instructions for batteries in this user manual 15 Where the mains plug or an appliance coupler is used as the disconnect device the disconnect device shall remain readily operable PM Warning Never remove the casing of this apparatus e Never lubricate any part of this apparatus Never place this apparatus on other electrical equipment e Keep this apparatus away from direct sunlight naked flames or heat e Ensure that you always have easy access to the power cord plug or adaptor to disconnect this
Download Pdf Manuals
Related Search