TENSION ARM / CONTROL ARM
Contents
1. Place the Rewinder DIRECTION switch in the desired position according to which direction you want to rewind the labels 3 Place the REWIND SLIT Switch in the REWIND position and set the TORQUE ADJUST about 1 3 rotation from fully CCW as an initial setting 4 Start your printer and observe how the labels are being rewound 5 Adjust the TORQUE Control as needed to provide more or less faster or slower rewind power As the Rewinder winds up the labels the Tension Arm will rise eventually causing the Rewinder to turn off As the printer feeds more labels that need to be rewound the labels and the Tension Arm will drop down turning on the Rewinder again 6 A weight can be placed on the Tension Arm if desired to control the rewind web tension USE POWER UNWINDING UCATSs Refer to your Unwinder User Manual LC n 1 LABELMATE 69 AVENUE ALPHONSE XIII 1180 BRUSSELS BELGIUM TEL 322 375 69 60 FAX 322 375 38 96 brussels labelmate com www labelmate com Tel 49 0 40 840 509 0 Fax 49 0 40 840 509 29 LABELMATE User_TA 06 07 www jrdrucksysteme de2. TENSION ARM CONTROL ARM Tension Arm for CAT TA Rewinder Control Arm for UCA T 2 UCAT 40 Unwinders e CAT 2 TA CAT 40G TA On demand Rewinding Turns Off When Labels Stop Coming from Your Printer e UCAT 2 UCAT 40 On demand Unwinding Turns On When Printer Needs Labels CAT 2 TA STANDARD UCAT 40 e KEEP MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE e SET UP Drucksysteme Janz amp Raschke GmbH Osterbrooksweg 71 D 22869 Schenefeld Email kontakt jrdrucksysteme de h UCAT 40 The Tension Arm Control Arm is to be mounted vertically CAT 2 TA CAT 40G TA The Tension Arm can be mounted facing either right or left depending on which side the labels are coming from UCAT 2 The Control Arm can be mounted facing either right or left depending on which side the labels need to go to 2 Remove and keep the large Screw from the end of the Tension Control Arm Shaft the small Shaft below the main Motor Shaft 3 Loosen the Set Screw at the end of the Tension Control Arm and position the Arm with the Set Screw facing the flat on the Tension Control Arm Shaft 4 Tighten the Set Screw facing the flat on the Shaft 5 Re insert and tighten the Tension Control Arm Shaft Screw snugly into the Tension Control Arm Shaft The Unit is now ready for use USE POWER REWINDING CATs 1 Run the label web to be rewound under the Rewinder Tension Arm and onto the take up label Core on the Rewinder 2
Download Pdf Manuals
Related Search