Table of Contents - Laser Pros International
Contents
1. For HP Internal Use Only Copyright Hewlett Packard Company 2006 This document contains proprietary information that is protected by copyright All rights are reserved No part of this document may be photocopied reproduced or translated to another language without the prior written consent of Hewlett Packard Company First Edition March 2006 Second Edition March 2007 Warranty The information contained in this document is subject to change without notice Hewlett Packard makes no warranty of any kind with regard to this material including but not limited to the implied warranties of merchantability and fitness for a particular purpose Hewlett Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing performance or use of this material Content Management Department Large Format Printing division Hewlett Packard Espanola S A Avda Graells 50 08190 Sant Cugat del Valles Spain WARNING The procedures described in this manual are to be performed by HP qualified service personnel only Electrical Shock Hazard Serious shock hazard leading to death or injury may result if you do not take the following precautions Ensure that the ac power outlet mains has a protective earth ground terminal Disconnect the Printer from the power source prior to performing any maintenance Prevent water or2. The level in the HP Waste Ink Bottle should be checked by visual inspection to prevent overflow If the waste ink level is above the indication line the bottle must be replaced with an empty HP Waste Ink Bottle The use of safety glasses and gloves is recommended when performing cleaning and maintenance operations Table of Contents Troubleshooting 1 1 System Error Codes 2 1 Head Adiustment 3 1 Maintenance Mode 4 1 Adjustments and Calibrations 5 1 Print Quality 6 1 Parts and Diagrams 7 1 Removal and Installation 8 1 Preventive Maintenance 9 1
3. any other liquids from running onto electrical components or circuits or through openings in the enclosure Electrostatic Discharge Refer to the beginning of Chapter 4of this manual for precautions you should take to prevent damage to the Printer circuits from electrostatic discharge Safety Symbols General definitions of safety symbols are given immediately after the table of contents WARNING The Warning symbol calls attention to a procedure practice or the like which if not correctly performed or adhered to could result in personal injury Do not proceed beyond a Warning symbol until the indicated conditions are fully understood and met CAUTION The Caution symbol calls attention to an operating procedure practice or the like which if not correctly performed or adhered to could result in damage to or destruction of part or all of the product Do not proceed beyond a Caution symbol until the indicated conditions are fully understood and met Service Manual HP Designjet 9000s Series Printers invent MA Using this Manual Purpose This Service Manual contains information necessary to test calibrate and service m HP Designjet 9000s Series Printers Model Q6665A For information about using these printers refer to the corresponding User and Quick Reference Guides Readership The procedures described in this Service Manual are to be performed by HP Certified
4. e printer may result in electrical shock fire and susceptibility to electromagnetic interference Ink and fluids used in the Cleaning and Maintenance Kits are combustible Do not use or store within 8 meters 25 feet of open flames sparks or other sources of ignition Switch power OFF remove the power cords from the electric outlets and allow the printer to cool before attempting to remove any panels or covers The printer contains high voltage and hot components Removal of panels or covers may result in exposure to electric shock and burns Do not allow metal or liquids except those used in HP Cleaning and Maintenance Kits to touch the internal parts of the printer Doing so may cause fire electric shock or other serious hazards When shutting down the entire system always turn OFF the printer switch as well as the heater switch breaker Use only an HP Waste Ink Bottle The bottle must be installed according to instructions or waste ink may overflow An HP Waste Ink Bottle must always be installed before turning the printer ON Automatic and manual service cycles produce waste ink that must be contained in an HP Waste Ink Bottle Always use both hands to remove and carry an HP Waste Ink Bottle Keep the HP Waste Ink Bottle upright Do not place on tables or shelves where it could fall invent Waste ink is combustible Keep an HP Waste Ink Bottle containing waste ink away from open flames sparks or oth
5. er sources of ignition Never store waste ink in a glass container Never pour waste ink into a container filled with other chemicals The HP Waste Ink Bottle contains organic solvents and must be disposed of in compliance with all local state and federal regulations Always securely replace the cap on a full or partially full the HP Waste Ink Bottle after removing it from the printer to prevent ink spills invent CAUTION Treat any media paper used cleaning and maintenance supplies and wipes soaked with ink as combustible materials Handle and dispose of properly Do not clean the printer with benzene or paint thinner This may damage the paint Wipe the printer clean with a soft cloth A cloth moistened with a neutral detergent may be used Do not allow liquid to enter the printer This may create risk of fire and electrical shock and cause a malfunction Never touch the printhead nozzles They can be easily damaged or clogged Do not touch heater surfaces in the paper path This may cause burns Take care when touching printer components near the heaters HP Ink Cartridges must be installed before the Install By printed on the cartridge Use of the Ink Cartridge 3 months beyond the Install By date may cause deterioration in print quality or a printer malfunction Do not separate the cap from a new HP Waste Ink Bottle The cap is needed to properly seal the HP Waste Ink Bottle for disposal
6. service personnel only Part Numbers Part Numbers for Printer options accessories and service parts are located in Chapter 7 Conventions A small arrow gt is used to indicate other parts of the Service Manual where you can find information related to the topic you are consulting Safety Precautions The following Warnings and Cautions are presented in this Service Manual and must be observed Follow the instructions marked with these symbols Failure to follow the guidelines marked A with this symbol could result in severe WARNING personal injury or death Failure to follow the guidelines marked AN CAUTION with this symbol could result in minor 21 personal injury or product and or peripheral damage WARNING Inks used in the printer and liquids in the HP Cleaning and Maintenance kits contain an organic solvent ethylene glycol monobutyl ether acetate CAS No 112 07 2 Observe all local state and federal regulations related to the handling use storage and disposal of organic solvents Avoid contact between ink and skin eyes and clothing Immediately wash skin with soapy water Remove clothing soaked with ink from contact with skin Use an approved eye wash station if ink is splashed into eyes and consult a doctor if necessary If an approved eye wash station is unavailable flush eyes with cold water and consult a doctor if necessary Be sure the printer is well grounded Failure to ground th
Download Pdf Manuals
Related Search