OPERATING INSTRUCTIONS
Contents
1. SPECIFICATIONS Tracking system 1 beam laser Laser pickup Semiconductor laser D A conversion 8 times oversampling digital fillter 1 bit DAC Frequency response 20 20 000 Hz Outputs PHONES stereo jack 3 5mm 20mW 20mW 32 ohms at 1 kHz Input DC 4 5V for external power from AC adaptor Power DC 3V from Alkaline batteries 2 x AA or LR6 Not included DC 2 4V from the rechargeable batteries Not included Dimensions 142 x 29 H mm 5 16x 1 1 8 inches Weight 280 grams 9 8 oz without batteries Supplied accessory Stereo headphones 1 AC adaptor 1 The specifications and external appearance of this unit are subjected to change without notice BEFORE PLAYBACK HOLD switch Release the HOLD switch to OFF position before playback When not using the unit set the HOLD switch to the ON position Accidentally pressed button will not a function If buttons are pressed when the HOLD I itch is set to the ON ition HOLD light Bees switch is set to the ON position ight on ES om i the display Turning on and off Turning the power on Press PLAY PAUSE Power is turned on and playback starts Turning off the power If no new operations are done within 30 second from the end of last operation the power is turned off automatically Auto power off function you can turn off the power before it is automatically turned off by pressing W STOP Standby mode When a2. suddenly moved from a cold place toa warm one it may cause in condensation on the pickup lens and malfunction or playback difficulties should this occur leave the unit for a few hours then try playback again MAINTENANCE To clean the lens If the lens become dirty the player will skip or not play If this occurs clean the lens in the following manner To remove dust or dust particles first use a camera lens blower brush to blow a few times to loosen particles then gently brush the lens clean finish by blowing the lens again Note Take care not to get too much solution on the swab which could flow into the unit and cause damage Pressing too strongly with the swab could scratch or break the lens To clean the discs Before playing wipe the disc from the center out with a cleaning cloth After playing store the disc in its case USING ON DRY CELL USING ON RECHARGEABLE BATTERIES Q BATTERIES Open the battery compartment and insert two LRG eBe sure to use size AA Ni Cd 1 2V rechargeable size AA alkaline batteries with the and marks batteries which are commercially available correctly aligned Be sure to read the instructions of the purchased rechargeable batteries before use Battery replacement Before charging the batteries close the disc The battery indicator in the display according to compartment you cannot charge the batteries the remaining power of the batteries Replace th
3. DENVER DM 54 40 SECOND ANTI SHOCK PORTABLE CD PLAYER WARNING TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE PLAYBACK Connect the supplied headphone tothe PHONE jack 1 Release HOLD to OFF position 2 Place a disc 3 Press PLAY PAUSE Playback starts from the first track BASIC OPERATION To stop Press W STOP To pause Press PLAY PAUSE To resume press it again To search for the beginning of a track Press or gt Tolocate a desired passage Keep 4 or gt i Pressed Release the button until the start of desired passage MODE KEY NORMAL REPEAT ONE REPEAT ALL SHUFF INTRO REPEAT ONE 1 t light on display and will repeat the track you selected REPEAT ALL ALL light on display and will repeat entire tracks INTRO INTO light on display and will play the first 10 seconds of each track SHUFF SHUFF light on display Plays every tracks in random order ANTI SHOCK light on display until Press again then change to normal play DISC If no diSC then diSC is display PROGRAM 1 Press PROGRAM key Then PROG 00 start flashing 2 3 Press skip searched ke or key to search the track no When desired track is display press PROGRAM key to register Then track no display to 00 again Repeat 2 3 up to 20 tracks after register 20 tracks display shows the first regist
4. e while it is opened batteries whens__llights If the unit remains in use after lights the operation will stop 1 Insert the rechargeable batteries with the and marks correctly aligned If the cover of the battery compartment2 When recharge please switch the recharge button to on after recharging or in other condition switch comes off to off otherwise the CD player will be damaged 3 Connect the AC adaptor Note on dry cell batteries to DC 4 5 V jack Do not mix the different types of batteries or an to a wall outlet old battery with a new one e To prevent the risk of electrolyte leakage or explosions never recharge the batteries apply heat to them or take them apart When not using the batteries remove them to pre vent needless battery wear 4 Press STOP to start charging After charging disconnect the AC adaptor e Time to recharge the batteries Recharge the batteries when lights If the unit remains in use after lights the current operation ile a will stop If liquid leaks from the batteries wipe thoroughly to Battery recharged battery side remove ATTENTION The rechargeable batteries are recyclable At the end of their useful life it may be illegal to dispose the batteries into the municipal waste stream under various state and local laws Check with your local solid waste officials in your area for details about recycling options or proper disposal AA LR6 X2
5. ered track Registered tracks can be check by press PROGRAM key And it can be changed by repeat 2 3 Press play key then PROG stops flashing and starts playing Open the door or power off to clean programing DENVER OPERATING DM 54 INSTRUCTIONS 40 SECOND ANTI SHOCK PORTABLE CD PLAYER CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure This compact disc player is classified as a CLASS 1 LASER product CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT Invisible laser radiation when open and interlocks defeated Avoid exposure to beam PRECAUTIONS To maintain good performance Do not use the unit in places which are extremely hot cold dusty or humid In particular do not use or keep the unit in following places e in a high humidity area such as a bathroom e near a heater in an area exposed to direct sunlight e g inside a parked car where it can become extremely hot near sources of strong magnetism such as televi sions speakers or magnets e where there is a lot of movement or vibration such as on a car dashboard or an unstable shelf CONNECTION TO AN EXTERNAL UNIT Q Use a commercially available connection cord which has a 3 5mm stereo plug at one and two phono plugs at the other end Connect the stereo plug to the LINE OUT jack of the u
6. n operation finishes the unit goes into standby mode until the auto power off function automatically turns off the power To enter standby mode press p gt PLAY PAUSE to start playback then press m STOP Adjusting the sound Volume Turn the VOLUME control to adjust the volume X BASS Switch on the X BASS for extra bass emphasized Inserting a disc 1 Push the OPEN switch to open the disc compartment 2 Place a disc in the center with the label side facing up 3 Close the disc compartment To remove the disc Pick up the disc holding its edge while pressing the pivot gently DENVER SUBJECT TO MODIFICATION WITHOUT NOTICE
7. nit and connect the phono plugs to the analog input AUX terminals of the external unit NOTE Turn off the power of both units before connection DO NOT connect to the PHONES inputs of an amplifier with a built in phonoequalizer amplifier Adjust the volume and BASS on this unit For safety Do not attempt to disassemble this Laser rays f rom the optical pickup are dangerous to the eyes e Make sure that pins or other foreign objects do not get inside the player Take care not to drop the unit or subject it to strong shocks To keep dust from the pickup lens keep the disc compartment lid closed after use Never touch the lens e If you hear no sound when playing a disc DO NOT turn the volume up high because the music could suddenly begin at high volume To avoid hurting your ears or damaging the speakers turn the volume control to the lowest level before starting playback and slowly turn it up to the desired level Note on listening with the headphones e Listen at moderate volumes to avoid hearing damage Do not wear the headphones while driving or cycling It may create a traffic hazard e You should use extreme caution or temporarily discontinue use in potentially hazardous situations such as walking jogging etc CAUTION Listening to headphone stereo at full power for extended periods of time can result in hearing damage Do not touch pickup lens Note on condensation If the unit is
Download Pdf Manuals
Related Search