ImageMate 12-in-1 Reader/Writer User Guide
Contents
1. 4 Pull the card out of the slot To remove the card on a Macintosh 1 Drag the untitled icon into the Trash 2 Pull the card out of the slot Disconnecting You don t need to shut down your computer to disconnect the ImageMate 12 in 1 Reader Writer but you should NEVER remove the device from the USB port without first reading the steps below If a drive window is open or the ImageMate 12 in 1 Reader Writer is active close any associated windows before attempting to remove the ImageMate Windows Use the hotplug icon in the notification area of the taskbar to safely stop the device V before unplugging it The notification area is on the right side of the taskbar where you usually see the time displayed These steps are not required for Windows 98SE or XP 1 In the notification area right click on the hotplug icon 2 Select the device you want to unplug then click STOP 3 When Windows notifies you that it is safe to do so unplug the ImageMate 12 in 1 Reader Writer from your computer Macintosh 1 Drag the ImageMate 12 in 1 Reader Writer untitled icon into the Trash 2 Unplug the device Troubleshooting For FAQs on error messages please go to our website at http www sandisk com retail support asp For assistance by phone please call toll free 866 SANDISK 866 726 3475 M F 7AM till 4 PM PST you can find local European phone numbers at www sandisk com Limited Warranty SanDisk warrants that this product wil2. SEQUENTIAL DAMAGES ANY FINANCIAL LOSS OR ANY LOST DATA OR IMAGE EVEN IF SANDISK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU IN NO EVENT WILL SANDISK S LIABILITY EXCEED THE AMOUNT PAID BY YOU FOR THE PRODUCT The information in this manual is subject to change without notice SanDisk shall not be liable for technical or editorial errors or omissions contained herein nor for incidental or consequential damages resulting from the furnishing performance or use of this material This documentation may not be copied reproduced translated or reduced to any electronic medium in whole or in part without prior written permission from SanDisk SanDisk the SanDisk logo and CompactFlash are trademarks of SanDisk Corporation registered in the United States and other countries Store Your World in Ours and ImageMate are trademarks of SanDisk Corporation RS MMC is a trademark of the MultiMediaCard Association SanDisk is an authorized licensee of the SD miniSD and MultiMediaCard trademarks SmartMedia is a trademark of Toshiba Corporation Memory Stick Memory Stick PRO Memory Stick Duo and Memory Stick PRO Duo are trademarks of Sony Corporation The USB IF Logo is a trademark of Universal Serial Bus Implementers Forum Inc Other brand names mentioned herein are for identification purposes
3. ansferred from or to the card If the LED is not on check to make sure the ImageMate 12 in 1 Reader Writer is connected and the media is inserted properly NEVER remove the media when the green LED is FLASHING Using it on a PC with the button application 1 Insert the Media Card 2 Press the button on the reader 3 The Media Card Companion application will load 4 f you wish to save the files to your PC choose the Transfer all Files button This will allow you to either copy or move the files to the PC 5 f you wish to Select Rename Print E mail or use Screen Saver for any or all of the photos choose the Use Photo Tools Icon Using it on a PC without the button application Here is the way to create a Folder on your Desktop and Copy and Paste your photos to it 1 How to create a FOLDER on your Desktop A Place your mouse pointer somewhere on the Desktop but not on an icon B Click once with the RIGHT mouse button move your mouse pointer over NEW then click FOLDER with the LEFT mouse button C This will create a NEW FOLDER on your Desktop At this time you can name anything you like i e My Pictures or Photos by typing the name in When you are finished typing press the ENTER key on your keyboard Now the folder name is saved 2 How to copy and paste your photos into a folder A Double click on the icon My Computer B Double click on the removable disk drive for the ImageMate 12 in 1 Reader Writer i e F or G o
4. e e Samisk A ImageMate 12 in 1 Reader Writer User Guide Model Number SDDR 89 Product Description The Multi Function Hi Speed USB 2 0 Reader Writer CompactFlash Type I II SD miniSD MultiMediaCard RS MMC Memory Stick Memory Stick PRO Memory Stick Duo Memory Stick PRO Duo SmartMedia and xD Congratulations Congratulations on your purchase of the ImageMate USB 2 0 12 in 1 Reader Writer With a simple USB cable the ImageMate 12 in 1 Reader Writer can quickly move multimedia data and large files to and from your computer The ImageMate 12 in 1 Reader Writer supports both Hi Speed USB 2 0 and Full Speed USB 1 1 and is backward compatible with USB 1 1 ports The ImageMate 12 in 1 Reader Writer is easy to use You don t have to turn off or restart your computer to attach it and you don t need to open your computer for any reason And since the ImageMate 12 in 1 Reader Writer is powered by the USB connection an AC DC power adapter is not required In most cases all you need to do is plug the ImageMate 12 in 1 Reader Writer in and get going System Requirements Connection e USB 2 0 port for Hi Speed data transfer or USB 1 1 port for Full Speed data transfer Operating System Support e Windows e Windows 98SE driver installation required e Windows ME e Windows 2000 e Windows XP e Macintosh e OS 9 2 e OS 10 1 2 Unpacking Package Contents e ImageMate 12 in 1 Reader Writer with docking station st
5. ect the Button Application setup exe file and click OK Follow the on screen directions Connecting Connecting the ImageMate 12 in 1 Reader Writer to the USB port is simple You don t need to turn off or restart your computer when attaching the ImageMate 12 in 1 Reader Writer Since the ImageMate 12 in 1 Reader Writer is powered by the USB connection an AC DC power adapter is not needed Before connecting the ImageMate 12 in 1 Reader Writer complete the device driver installation See INSTALLING There are two ways to connect your ImageMate 12 in 1 Reader Writer to your computer 1 Insert the ImageMate 12 in 1 Reader Writer into the Docking Station Connect the Docking Station cable to your computer 2 Use the extra Travel USB cable to connect your ImageMate 12 in 1 Reader Writer to a computer directly the Docking Station is not required in this case When the ImageMate 12 in 1 Reader Writer is connected for the first time your computer may display a message that the device is being installed may vary slightly depending on your operating system Windows Disk Icons When you connect the ImageMate 12 in 1 Reader Writer on a Windows operating system four removable disk icons representing the media slots show in My Computer with newly assigned drive letters Macintosh Disk Icons When you connect the ImageMate 12 in 1 Reader Writer on a Macintosh operating system removable disk icons labeled no name representing the media slot
6. g the ImageMate 12 in 1 Reader Writer to your computer you may need to install the device driver You can skip this section if your operating system is Windows XP ME Windows 2000 with Service Pack 3 or Mac OS 10 1 2 and proceed to Installing the Button Application Install the Windows 98SE and Windows 2000 driver for systems with Windows 2000 and with SP1 or SP2 installed 1 Insert the CD included with the ImageMate 12 in 1 Reader Writer into the CD ROM of your computer 2 Left click on the START menu and open the RUN menu Click BROWSE to locate the drive letter of your CD ROM 3 Select the setup exe file and click OK Follow the on screen directions Install the Macintosh 9 2 X driver 1 Install the CD included with the ImageMate 12 in 1 Reader Writer into the CD ROM of your computer 2 Double click the CD ROM icon on the desktop and then run the USB Reader Installer application for your Macintosh operating system The Read Me file opens first 3 Click Continue 4 Inthe Installer Dialog select USB Reader Installer in the drop down menu and then click Install to install the device driver 5 Follow the on screen directions Installing the Button Application Media Card Companion only for Windows 1 Insert the CD included with the ImageMate 12 in 1 Reader Writer device into the CD ROM of your computer 2 Left click on the START menu and open the RUN menu Click BROWSE to locate the drive letter of your CD ROM 3 Sel
7. l be free from material defects in design and manufacture and will substantially conform to the published specifications under normal use for two years from your date of purchase subject to the conditions below This warranty is provided to the original end user purchasing from SanDisk or an authorized reseller and is not transferable Proof of purchase may be required This product must be used with memory cards that are compliant with the specifications of the CompactFlash Card Association the SD Card Association the MultiMediaCard Association or miniSD RS MMC Memory Stick Memory Stick PRO Memory Stick Duo Memory Stick PRO Duo SmartMedia and xD Picture Card requirements as applicable use with any other product voids this warranty SanDisk is not responsible for any failure or defect caused by any third party product or component whether authorized or not This warranty does not apply to any third party software provided with the product and you are responsible for all service and repair needed for such software This warranty is void if the memory card is not used in accordance with the product instructions or if it is damaged as a result of improper installation misuse unauthorized repair modification or accident To obtain warranty service contact SanDisk at 1 866 SanDisk or send an email to support SanDisk com You must return the product in tamper resistant packaging freight prepaid as instructed by SanDisk You must obtain a tracki
8. ng confirmation number which you may be required to provide to SanDisk SanDisk will at its option repair or replace the product with new or refurbished product of equal or greater capacity and functionality or refund the purchase price The warranty duration on replaced product will be that time period remaining on the original product THIS CONSTITUTES SANDISK S ENTIRE LIABILITY AND YOUR EXCLUSIVE REMEDY FOR BREACH OF THIS WARRANTY SanDisk does not warrant and shall not be responsible for any lost data or images contained in any product including in any returned product regardless of the cause of the loss SanDisk s products are not warranted to operate without failure SanDisk products should not be used in life support systems or other applications where failure could threaten injury or life This warranty gives you specific legal rights and you may also have other rights which vary by jurisdiction THE FOREGOING IS SANDISK S SOLE WARRANTY SANDISK DISCLAIMS ALL OTHER EXPRESS AND IMPLIED WARRANTIES TO THE FULLEST EXTENT PERMITTED BY APPLICABLE LAW THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO THE DURATION OF THE EXPRESS WARRANTY SOME JURIDSICTIONS DO NOT ALLOW LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU IN NO EVENT SHALL SANDISK OR ANY AFFILIATED OR SUBSIDIARY COMPANY BE LIABLE UNDER ANY CIRCUMSTANCES FOR ANY DIRECT INDIRECT OR CON
9. only and may be trademarks of their respective holder s 2004 SanDisk Corporation All rights reserved
10. orage media not included e Installation CD with Windows 98SE driver button application Media Card Companion and User Guide e Extra USB travel cable e User Guide Checking 1 Unpack the packaging Make sure you have everything listed in the PACKAGE CONTENTS Check your system requirements Refer to SYSTEM REQUIREMENTS or the outside of the packaging 3 Locate the USB port on your computer See UNDERSTANDING Understanding What s a USB port The Universal Serial Bus USB port is an easy way to connect a new device like the ImageMate 12 in 1 Reader Writer to your computer Connecting a device to the USB port doesn t require that you open your computer to install an add in card or set complicated switches You just plug it in and get started How do find the USB port The USB ports are often located on the front or back of your PC or on a USB hub Ona laptop computer or a Macintosh the USB port may be located on the side The USB port looks like this What is the difference between Hi Speed USB 2 0 and Full Speed USB 1 1 Hi Speed USB 2 0 supports the transfer of data up to 480 megabits per second Mbps and Full Speed USB 1 1 supports data transfer up to 12 Mbps Hi Speed USB 2 0 provides a dramatic improvement in data transfer performance compared to Full Speed USB 1 1 USB 2 0 is backward compatible with USB 1 1 ports The ImageMate 12 in 1 Reader Writer supports both USB 2 0 and USB 1 1 Installing Before connectin
11. r maybe E Now you should see a DCIM folder that stands for Digital Camera Images C Double click on the DCIM folder Now you should see your camera folder i e 100Olymp or 100Canon or 100Fuji D Double click on the camera folder Now you should see your pictures or picture file names depending on what Operating System you are using E Goup to the menu bar where it says EDIT and click on SELECT ALL You will see all your pictures HIGHLIGHTED F Go back to EDIT and now click COPY Close or minimize this window G Double click on the folder you created on your Desktop go to EDIT then click PASTE and you should see the pictures being copied to the folder H To View your Pictures Double click on the File name and the Picture will open up Using it on Macintosh without the button application The button application is not compatible with the Macintosh operating systems 1 Connect the ImageMate 12 in 1 Reader Writer to the USB port on your Mac do not connect to Monitor or Keyboard 2 To transfer files place a card into the Reader Writer unit A new drive will appear on your desktop called untitled 3 Drag and drop files to and from the new drive as you would to any other disk or folder Removing Card To remove the card in Windows 1 Double click on the icon My Computer 2 Right click on the corresponding ImageMate 12 in 1 Reader Writer drive icon 3 Select Eject this is not needed for Windows 98SE or XP
12. s show on desktop when media is inserted Using The ImageMate 12 in 1 Reader Writer has four media slots Each slot can be used for two or four types of media When you install the ImageMate 12 in 1 Reader Writer you will see four new removable drives appear The new drive letters represent the following memory types 1st new removable drive CompactFlash I II 2nd new removable drive SmartMedia xD 3rd new removable drive SD miniSD MultiMediaCard RS MMC 4th new removable drive Memory Stick Memory Stick PRO Memory Stick Duo Memory Stick PRO Duo Inserting Media To install media into one of the Reader Writer s slots insert the connector end of the card stick sD Memory Stick miniSD Memory Stick PRO Do not force the media into the slot MultiMediaCard Memory Stick Duo RS MMC Memory Stick PRO Duo For CompactFlash I II SD miniSD MultiMediaCard RS MMC Memory Stick Memory Stick PRO Memory Stick Duo and Memory Stick PRO Duo CompactFlash insert with memory card label facing the SanDisk CompactFlash Il logo on the side of the ImageMate 12 in 1 Reader Writer For SmartMedia xD insert with gold plated side facing the SanDisk logo on the side of the ImageMate 12 in 1 Reader Writer SmartMedia xD LED Activity e When the ImageMate 12 in 1 Reader Writer is installed correctly the amber LED turns on e The four smaller green LEDs turn on when a media type is inserted e The four smaller green LEDs blink when data is tr
Download Pdf Manuals
Related Search