MOEN DN6892BN Installation Guide
Contents
1. Place mirror assembly over the mounting posts on the wall Setscrews facing down Tiahten setscrews Cleaning Instructions To preserve the fine finish of this product clean only with a soft damp cloth Dry well Do not use commercial or abrasive cleaners a Stock Number Oval Tilting Mirror By Creative Specialties 25300 AL MOEN DRIVE e NORTH OLMSTED OH 44070 CORPORATE HEADQUARTERS 800 321 8809 e FAX 800 848 6636 INTERNATIONAL 440 962 2000 FAX 440 962 2726 CUSTOMER SERVICE USA 800 882 0116 FAX 888 379 2720 Copyright Creative Specialties International 2005 Literature BA12702. Sage Technical Specification Oval Tiltinc Mirror DN6892 Stock Numbers q DN6892BN Oval Tilting Mirror Brushed Nickel Finish Oval Tilting Mirror posts are constructed of zinc and mirror is constructed of 5MM thick glass O Go eaha Specialties Internationa Diaa oP T z 579 0 F oe oe Gane fb Of hed 4 Installation Instructions 1 Position the mounting template on the wall in the desired location Using a level align the template and tape it to the wall 2 Using a 4 diameter drill bit drill 4 holes as indicated on the template 3 Remove template from the wall 4 Remove the screws and washers from each of the 4 wall anchors in the hardware kit Set the screws and washers aside for later use 5 Insert the hollow wall anchors into the 4 holes in the wall by lightly tapping with a hammer until flush 6 Remove mounting posts from end post assembly by loosening each setscrew 7 One ata time place each mounting post over the wall anchors with notch facing down Insert the screws and washers through the slots in the mounting posts and into the wall anchors To activate the wall anchors turn screws until you feel increased resistance Loosen the 2 small screws on each of the end posts 0 With the back of the mirror facing you slide the end posts into position on the mirror See figure 1 Align the screws with the holes in the back plates Tighten all 4 screws 11
Download Pdf Manuals
Related Search