MOEN YG5418ORB Installation Guide
Contents
1. 00 e FAX 440 962 2726 CUSTOMER SERVICE USA 800 882 0116 WWW CSI MOEN COM Copyright CSI Bath Furnishing Division of Moen 2006 Literature BA11252. Kingsley Technical Specification Grab Bar na Numbers YG5412CH 12 Grab Bar Chrome Finish q YG5412BN 12 Grab Bar Brushed Nickel Finish q YG5412ORB 12 Grab Bar Oil Rubbed Bronze Finish q YG5418CH 18 Grab Bar Chrome Finish q YG5418BN 18 Grab Bar Brushed Nickel Finish q YG5418ORB 18 Grab Bar Oil Rubbed Bronze Finish q YG5424CH 24 Grab Bar Chrome Finish q YG5424BN 24 Grab Bar Brushed Nickel Finish q YG5424ORB 24 Grab Bar Oil Rubbed Bronze Finish q YG5430CH 30 Grab Bar Chrome Finish q YG5430BN 30 Grab Bar Brushed Nickel Finish q YG5436CH 36 Grab Bar Chrome Finish q YG5436BN 36 Grab Bar Brushed Nickel Finish Grab Bar posts and bars are aluminum Skirt Rings are brass Compliance CSI grab bars meet or exceed the applicable requirements of the following standards ANSI A117 1 ASTM F446 CSA B45 CSA B651 Load Tested to withstand 300 lbs when securely installed per instructions 12 long grab bars are intended for vertical installation only red pectalth International YJ MOEN Buy it for looks Buy it for life O YG5400 Dimensions B2 950 Installation Instructions Tools Required 1 8 drill bit and drill Phillips screwdriver Tape and Level Hardware kit contents 6 screws 1 Please note that all screws must mount into a wood stud 2 Pull up and slide the skirt ring away fr
3. om the hub end to expose the mounting screw holes on both hubs 3 Locate the studs behind the wall by using a stud sensor or another stud locating method Place the grab bar on the wall where desired so that all the mounting holes are positioned over a wood stud Use a level if desired to verify placement 4 With a pencil mark all six mounting hole locations 5 Remove the grab bar from the wall and drill 1 8 diameter pilot holes at the six marked screw locations If desired apply silicone caulk to the back of the grab bar hubs to guard against water penetration 6 Mount the grab bar using all 6 of the 10 x 2 long wood screws provided Tighten screws until secure 7 Slide the skirts back into place and press onto the hubs to secure Note Grab bars are to be mounted to a secure surface Creative Specialties International shall not accept responsibility for any and all damage caused by lack of wall strength or improper installation It is the responsibility of the architect builder and installer to ensure that the mounting area is secure and that proper mounting hardware is used for installation Cleaning Instructions To preserve the fine finish of this product clean only with a soft damp cloth Dry well Do not use commercial or abrasive cleaners Stock Number Grab Bar By Creative Specialties 25300 AL MOEN DRIVE e NORTH OLMSTED OH 44070 800 321 8809 FAX 800 848 6636 INTERNATIONAL 440 962 20
Download Pdf Manuals
Related Search