Haier HR-170T/A User's Manual
Contents
1. Haier MODEL HR 170T A REFRIGERATORS OPERATING INSTRUCTIONS x The manufacturer keeps on developing various types of refrigerators so he has the right to modify designs products and technical data without further notice VC532007 No 0060507900 FIGURATION OF THE REFRIGERATOR Py a S m ow 1 Low bottle support 2 High bottle support 3 Vegetable box 4 Shelf 5 Drip tray 6 Evaporator 7 Thermostat 8 Light Switch The manufacturer reserves the right to improve the product from time to time without further notice NOTICE The power supply for appliance is 220 240V 50Hz Single phase It is not recomended to use any extention cords Connect the appliance with a properly earthed three wire plug and socket with a special use Never store anything dangerous in the appliance such as combustibles exposives strong acid and alkali etc SETTING UP The appliance can be placed with its rear panel directly against the wall For a good air circulation the vent grille at the back of the worktop must not be blocked It should be placed on flat and firm ground lest it gives off higher noise than usual Poorly ventilated rooms are unsuitable Avoid positioning the appliance in direct sunshine or exposed to similar sources of heat LAMP AND LAMP REPLACEMENT Lamp 220 240V 15W Lam2. duce to disconnect the energy consumption appliance from CLEANING power supply Clean the interior The appliance can only be cleaned at drawn network plug Clean it as described with lukewarm water containing a little detergent In any case do not use hot water corrosive scouring agent and anything rough NOTE Do not use anything rough In the event of power failure try to keep the appliance closed for cleaning above to prevent to maintain the odours from refrigeration as long forming inside as possible 4 5
3. p holder E14 lamps exceeding 15W must not be used When replacing the lamp Unplug to disconnect the power and remove the water tray Press the positioning pin of the lamp with left hand and release the shade from the lamp holder by sliding it to the right side Turn the lamp anti clockwise for removing Replace the water tray Light Shade ELECTRICAL DIAGRAM Thermostat Overload Starter a PTC In the event of a fault occurring during operation check first if the fault is due to an operation error You can repair the following faults yourself 1 It is not switched on properly or mains plug properly inserted The appliance does in the socket not run 2 The thermostat knob is turned to position 0 3 Supply voltage is too low 1 The appliance is too full of food 2 The appliance is located too near The temperature inside a source of heat the appliance is not 3 The door is not properly closed or low enough is opened too frequently 4 The vent grille is covered over eee ace The appliance is not standing from the appliance securely on the ground If none of these circumstances applies and you are not able to repair the fault please Contact the service point THERMOSTAT The knob graduation 0 1 2 3 4 5 6 7 does not stand for concrete temperature The smaller the numbers the higher the temperature in the compartment and vice versa Usually i
4. t s better to put the thermostat in Pos 1 Pos 4 Pos 0 shows the power is cut off STORING FOOD The temperatures in different positions inside the refrigerator are different due to different refrigeration distribution Thus when store food select proper position to meet your needs The coldest position is D Temperature from low to high in order as D00 ICE MAKING When making ice add water to the ice tray until 4 5 full with the grid in it and place it on the bottom of the ice chamber Twist the tray or place it briefly in warm water to remove the ice cubes NOTE Do not use a knife and the like when removing the ice tray eal NOTES ON STORAGE DEFROSTING Where necessary food should be packed in bags avoiding giving When defrosting switch off off strong odours or getting wet the appliance Remove food from or dry the ice chamber it will be i defrosted automatically When Aremm defrosting process has been Do not store food too full in completed the drip tray should the appliance Allow space among be depleted Replace the food the packages of food for a and switch on the appliance perfect refrigerating NOTES Hot food or liquid must be allowed If the appliance The appliance door to cool to room temperature remains out of should be opened as before placing in it use for some time little and briefly pull out the plug as possible to re
Download Pdf Manuals
Related Search