Optoma BM-3300ST project mount
Contents
1. Optoma MOUNTING INSTRUCTIONS FOR SHORT THROW PROJECTOR MOUNT Assemble wall plate amp attach assemble to wall 1A 1B Secure Boom Arm To Wall Plate CAUTION NOTE This mount is designed to take projectors up to a weight of 33lbs For safety reasons the mount has been tested with a dead weight loading of 165lbs It is recommended that if the installation is at risk of being subjected to greater loads then you should additionally tether the mount to the ceiling using the tether point highlighted below The tether point uses an M6 thread which can accept any M6 fixing such as an eye bolt or hook MODEL No BM 3300ST FN OPTBM3300ST Max Weight Loading 33lbs Assemble projector mounting plate to the 16 stud adapter plate using x4 M8 washers A amp x4 M8 nuts B For ease of installation mount bracket on wall using position 1 and mark other positions using a spirit level Remove fixing from position 1 remove bracket and drill other positions Use Fixings suitable for your type of wall construction Use All available fixing points If in any doubt of the suitability of the wall it s construction or what type of fixings to use consult a qualified builder or installer Tether Point Read these instructions carefully before installing your equipment Install the mount in a suitable location using fixings which are appropriate for the wall material and structure Consult a qualified builder if you are in any doubt2. as to the structural integrity of the wall Use all available fixing points Do not attempt to alter or modify any part of the wall mount or it s attachments Do not use if any parts are broken or appear to be damaged Tighten all bolts and fixings securely Only use fixings provided with this bracket Do not mount your projector near to sources of heat or moisture Always have a minimum of two persons to install the projector and the mount Projector Mount Assembly Kit x8 x3 A M8 M6 washer e Q B M8 nut x4 e C M8 x 16mm x4 o D M6 x 12mm x2 Adjust Length Of Mount Transit screw Hi First remove i 4 Re insert after adjustment Cx2 F Es Bx3 Attaching Optoma 212 305 306 605 610ST Projectors a Optoma 212ST 305ST 306ST Series Fixing Kit Optoma 212ST D M3 x 20mm Optoma 305ST 306ST D M4 x 20mm x3 qe E Mounting Bobbin x3 C F 2 5mm Allen Key G M4 x 16mm x2 Also Required p ad Fine Adjust Position The following adjustments labelled below can be made to fine tune position to correct any discrepancy in the installation or mounted surface a To fine tune the length and tilt of the mount loosen bolts slide mount to required position and re tighten bolts b To fine tune the le
3. vel of the projector use the four adjustment thumb wheels on the spring loaded cradle Do not fully unwind the thumb wheels c To fine tune height position of the projector loosen the boom assembly screws and slide the projector to required position Then re tighten all four screws d The integrated level indicates that the mount arm is at 0 This does not necessarily mean the projector is level with the screen so other adjustments may need to be made Specifications Throw distance Adjustment Compatibility N ow _ 46 535mm to 1350mm Approx dependent on fixing positions 100mm Fine length adjustment 5 Tilt Adjustment with integral level 4 point vernier adjustment tilt and yaw 100mm Height Adjustment at wall Optoma ZX212ST ZW212ST X305ST W305ST X306ST amp W306ST C mE Ul uL Min 690mm Max 1375mm A 214 25mm
Download Pdf Manuals
Related Search