IPC2 Owner`s Manual - fit-PC
Contents
1. IPC2 Owner s Manual IPC2 Owner s Manual February 2014 Introduction Package contents Hardware specifications IPC2 features Quick start guide Connecting IPC2 Booting Linux Booting Windows 7 Maintenance Opening service door Service bay BIOS Setup Utility Warranty and RMA Warranty RMA Tips for saving power General In Operating System For more information and to obtain the latest revision of this document please visit www fit pc com Introduction Package contents BA rele iy hed a To use IPC2 you will need IPC2 computer Power supply input 100 240VAC 50 60Hz 60W output 12VDC 5A DC plug lock Attachable Standard North American and EU plugs AC cord HDMI to DVI adapter Audio 3 5mm to RCA cable 2 WiFi antennas in some models Mini serial to DB9 female adapter cable e A display with DVI HDMI or DisplayPort input DVI HDMI or DisplayPort cable e USB keyboard and mouse Local resellers may supply IPC2 with other AC cord types Hardware specifications Processor Type Cores Clock speed TDP Chipset Memory Supported Storage Supported Graphics GPU Display Interface 1 Display Interface 2 Display Interface 3 Audio Codec Audio Output Audio Input Intel 4th Gen Core Celeron 2955U i3 4010U i5 4300U i7 4600U Haswell 64 bit dual core 1 4 2 1GHz turbo boost up to 3 3GHz depends on CPU 15W Mobile Intel 8 Series Lynx Point in MCP packa2. using provided cable 5 LAN IPC2 features two 10 100 1000BaseT Ethernet ports using standard RJ45 connectors Use a standard Ethernet cables to connect The connectors feature built in LEDs that are lit when a connection is detected WLAN 2 WLAN antennas are supplied in models with integrated WiFi and should be screwed into the standard SMA connectors USB There are 2 USB 3 0 ports 5 Gbps and 2 USB 2 0 ports on the back panel And additional 2 USB3 0 ports on the front panel All USB ports support current up to 1A Ports on the back are upside down note when connecting USB plugs Serial port Three RS232 mini serial ports is located on the back panel Mini serial to DB9 cable to connect to standard serial devices is supplied in the package Quick start guide Connecting IPC2 Turn off the display and connect it to the IPC2 HDMI connector use the HDMI to DVI adapter if needed e Connect the USB keyboard and mouse to USB 2 connectors Plug the Ethernet cable into the Ethernet connector e In IPC2 models with WiFi Mount the WiFi Antennas on the SMA connector by turning it clockwise repeatedly until the antenna holds firm e Insert the DC plug into the IPC2 DC in jack Rotate clockwise 90 to secure s Plug the speakers into the line out jack e Connect the power supply to the AC cord and plug the cord into AC outlet The front panel logo should light up as the IPC2 boots Booting Linux Linux lo
3. ads automatically on power up Upon boot you will be guided through the Linux Mint first boot setup procedure Booting Windows 7 Upon first power up you will be guided through the Windows Welcome procedure which is self explanatory The Windows 7 serial number is printed on the Windows 7 label on the bottom of your IPC2 Maintenance IPC2 requires no maintenance You should not take the IPC2 apart other than opening the service door Taking IPC2 apart will void its warranty The following operations can be conducted by the user Opening service door 1 Unscrew marked Philips screw at the bottom to release service door 2 Slide out service door until it stops about 10 mm 3 Service door is now detached Lift edge of service door to completely remove Re assemble in reverse order Hard disk connects by sliding in the service door Service bay x 2 2 The service bay provides easy access to hard disk RAM and mini PCle sockets incl WLAN module Hard disk is 2 5 7mm 9 5mm SATA It is screwed to service door by 4 screws 2 on each side It is recommended to use 5400 RPM hard disk or SSD 7200 RPM or higher is not recommended due to higher power consumption and risk of overheating RAM use DDR3L 1333 1600 SO DIMM modules Mini PCle the half size mini PCle is normally used for WLAN If you remove the WLAN module make sure to isolate the ends of antenna cables with some tape to avoid short circuit The
4. full size mini PCle is available for any use BIOS Setup Utility Entering BIOS Setup Utility Turn off the IPC2 Turn on while holding down the F2 key See http www fit pc com wiki index php Main Page Warranty and RMA Warranty CompuLab guarantees products against defects in workmanship and material for a period of 60 months from the date of shipment e Your sole remedy and CompuLab s sole liability shall be for CompuLab at its sole discretion to either repair or replace the defective product at no charge This warranty is void if the product has been altered or damaged by accident misuse or abuse RMA Keep the original package for shipping in case of hardware failure In case of HW failure of an IPC2 under warranty please contact the seller of that IPC2 Please provide the following required information IPC2 serial number e Name of purchaser e Address e Problem description If the IPC2 was purchased directly from CompuLab please email rma fit pc com Tips for saving power General Working without a connected display automatically disables the graphics controller saving power Disconnect external USB devices when not in use In Operating System Use power scheme as follows e Turn of monitor after several minutes not in use e Turn off hard disk after several minutes not in use e System standby after an hour not in use C FE IPC2 Manufacturer CompuLab Ltd This device compl
5. ge 2x SO DIMM 204 pin DDR3L SDRAM memory slots Up to 16GB 2x 8GB DDR3L 1600 1 35V only 1x SATA up to 6 Gbps SATA 3 0 for internal 2 5 HDD SSD 2x mSATA slot up to 6 Gbps SATA 3 0 Intel HD 4400 Graphics Triple display mode supported HDMI 1 4a up to 4096 x 2304 24 Hz DisplayPort 1 2 up to 3200 x 2000 60 Hz HDMI 1 4a up to 4096 x 2304 24 Hz Realtek ALC888 VC2 HD audio codec Analog stereo output Digital 7 1 2 channels S PDIF output 3 5mm jack Analog stereo Microphone input Digital S PDIF input 3 5mm jack 3 Networking LAN Wireless Connectivity USB Serial SIM Special I O Expansion Advanced Technologies vPRO AMT CPU Virtualization Special Functionality Operating System Supported Operating Conditions Input Voltage Power Consumption Operating Temperature Enclosure Material Cooling Dimensions Weight Package Warranty Notes 2x GbE LAN ports LAN1 Intel 1218 GbE PHY MAC integrated into the chipset RJ 45 LAN2 Intel 1211 GbE controller RJ 45 WLAN 802 11ac 2 4 5GHz dual band Intel 7260HMW Bluetooth 4 0 4x USB 3 0 2x USB 2 0 3x Serial communication ports COMO Full RS232 via mini serial connector COM1 2 wire RS232 via mini serial connector COM3 2 wire RS232 via mini serial connector 1x micro SIM slot 6 pins N A Half size mini PCle socket Full size mini PCle socket2 Yes Intel vPRO Technology Yes Intel Active Management Technology Yes Au
6. ies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation Statement Changes or modifications to this equipment not expressly approved by the party responsible for compliance CompuLab Ltd could void the user s authority to operate the equipment Statement NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur ina particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver
7. is connected Consult the dealer or an experienced radio TV technician for help 10
8. to On Wake on LAN Wake on Timer PXE Boot Watchdog Windows 7 8 32 bit and 64 bit Linux 32 bit and 64 bit Embedded OS Unregulated 10 15VDC input 6W 24W 1 Commercial HDD models 0 C 50 C SSD models 0 C 70 C 2 Extended TE SSD models only 20 C 70 C 3 Industrial TI SSD models only 40 C 70 C Die Cast Aluminum Passive Cooling Fanless Design 19cm x 16cm x 4cm 1150gr 5 years 1 Nominal input voltage 12V 2 Shared with mSATA 3 For products purchased since 1 Jan 2013 4 For use with mini PCle Cellular Modem module 5 Supported on LAN1 only 4 IPC2 features ko o C C eae Front panel The features of the front panel of IPC2 depend on specific FACE Module used and are documented separately Power IPC2 has a tactile power push button It is used for turning on off the PC and for standby resume when supported by the operating system A push of at least 5 seconds will always turn off the IPC2 Display IPC2 has triple display interface with support for triple head 1 2x HDMI with audio support 2 1x DisplayPort To connect IPC2 to a DVI display use the provided HDMI to DVI D adapter Use a DVI cable to connect the adapter to the display Audio There are 2 standard 3 5mm jacks on the back panel Right Stereo line in using a standard 3 5mm plug e S PDIF 7 1 in using provided cable Left Stereo line out using a standard 3 5mm plug S PDIF 7 1 out
Download Pdf Manuals
Related Search