User Manual Coach Watch W226
Contents
1. ISFORT User Manual Coach Woetch Wee CONTENTS KEYS AND FEATURES OPERATING THE WATCH STOPWATCH MODE see re COUNTDOWN MODE ALARM MODE asian BATTERY REPLACEMEN Tu CARE AND MAINTENANCE KEYS AND FEATURES NN Warm Tip 52 The watch will be in the power saving mode after your purchase Please press the LIGHT and RESET buttons for 2 seconds at the same time to exit it 51 FEATURES Time Function hour minute second date week 12 24 hour format 2 time zone Stopwatch Function 10 laps memory stopwatch range 0 23h 59min 595 Countdown Function countdown range 0 99h 59min 59s Alarm Function Dual Alarm EL backlight press S2 in any case to activate 3s backlight Power Saving Press 51 and 53 at the same time and hold for 25 at any mode to enter power saving mode press S2 and S4 at the same time and hold for 2s to exit from the power saving mode to time mode OPERATING THE WATCH TIME MODE Operation Press 51 to enter into Stopwatch Mode Press S3 to switch between week month display Press 54 to turn on and off the key beep Press 54 and hold for 2 seconds to the 2 time zone T2 Time setting 1 Press S2 for 2 sec to enter Time Setting Mode with flashing ADJ shown 2 Press S1 to switch the setting items in the following order Hour Minute Second Year Month Day 12 24H 3 Press 53 54 key to increase decrease the value Press and hold 53 54 to increase decrea2. e rapidly 5 Press 52 to confirm the setting and go back to the alarm mode Note If there is no operation for 20 seconds in the setting mode it will confirm the setting and go back to alarm mode automatically Alarm 2 Same as Alarm 1 BATTERY REPLACEMENT WE STRONGLY RECOMMEND TAKING YOUR STOPWATCH TO A LOCAL JEWELER TO HAVE BATTERY REPLACED TO AVOID POSSIBILITY OF PERMANENTLY DAMAGING OF THE STOPWATCH When the LCD becomes dim replace with a new type CR2032 battery Warning Keep batteries away from children If swallowed contact a doctor or emergency personnel immediately Batteries contain chemical substances They should be disposed of properly according to local regulations CARE AND MAINTENANCE Never attempt to disassemble or service your unit it will void the warranty Protect the unit from extreme heat shocks magnetic fields electrical noise and exposure to direct sunlight long time Unit can be wiped clean with a lightly moistened cloth Apply mild soap to the area if there are stubborn stains or marks Do not expose the unit to strong chemicals such as gasoline clean solvents acetone alcohol insect repellents as they may damage the unit s seal case and finish not swing the stopwatch Do not drop or step on the stopwatch Do not wash the stopwatch or touch it with wet hands Store the unit in a dry place when you are not using it Keep the stopwatch out of reach of young childre
3. n X 8
4. se the value rapidly In setting SECOND while the value is less than 30 seconds press 53 54 will decease it to zero otherwise will add 1 min 4 Press 52 to confirm setting and return to Time Mode 5 When in the 2 time zone T2 only the hour and min can be set TIME MODE Note If there is no operation for 20 seconds it will back to Time Mode automatically STOPWATCH MODE Instruction The first Line Show the No of Lap recorded The Second Line Display Minute Second The Third Line Display 1 100 second Note When the value is up to 60 mins the second line will display hour amp min while the third line shows second Operation Press S3 to Start Stop stopwatch function During counting press 54 to record lap time up to 10 laps When stop the counting press 54 to clear the data and back to stopwatch mode STOPWATCH MODE Data Recall Press 52 to enter Data Recall Mode when counting or stop counting Press 53 54 to go through the recorded time data Press 52 to exit the data recall mode and back to stopwatch mode Note Unless starting a new measurement the recorded time would not disappear even you press S4 to clear the data COUNTDOWN MODE Instruction When the countdown time is over 60mins it will count down with the unit of 15 on the contrary it will count down with the unit of 1 100 s The default countdown time is 1 hour When counting down to the last 5s it will be a
5. short beep alerting you every second When the time is up there will be a long beep sound instead and then starts counting up Operation 1 Press 53 to start stop counting COUNTDOWN MODE 2 When stop counting press 54 to reset the counting Setting the countdown time 1 Press 52 for 2 sec to enter countdown time setting with flashing ADJ shown 2 Press S1 to switch the setting items hour minute second 3 Press 53 54 key to increase decrease the value Press and hold 53 54 to increase decrease the value rapidly 4 Press 52 to confirm the setting and go back to the countdown mode Note If there is no operation for 20 seconds in the setting mode it will confirm the setting and go back to Countdown Mode automatically ALARM MODE Instruction 1 Dual Alarm Alarm 1 and Alarm 2 2 Alarm duration 60s 3 When it alarms the symbol of alarm will be flashing displayed Press any key to stop the alarm while it is ringing Operation 1 Press S3 to select Alarm 1 or Alarm 2 2 Press 54 to turn on off the alarm 3 Turning on the alarm the symbol of alarm will be displayed on the ALARM MODE upper right corner On the contrary the symbol will disappear Alarm Setting 1 In Alarm Mode press 52 and hold for 2 seconds to enter alarm setting mode 2 Press 51 to switch the setting items hour minute 3 Press 53 54 key to increase decrease the value 4 Press and hold 53 54 to increase decrease the valu
Download Pdf Manuals
Related Search