User Manual
Contents
1. MUST be HDCP compliant when the video source is HDCP compliant NOTE If there is no signal detected from the HDMI port the baud rate will automatically slow down to 9600 bps The LED indicators are described in Table 2 1 Slide switch Auto Normal Long Reach settings Normal The extension distance of HDMI signal over CAT5 6 is up to 360 feet 110 m for 1080p and 270 feet 80 m for 4K x 2K Long Reach The extension distance of HDMI signal over CAT5 6 will be increased up to 500 feet 150 m for 1080p but the unit can not transmit 4K x 2K resolution Auto power saving The extension distance of HDMI signal over CAT5 6 is the same as Normal but the unit can automatically save energy for increasing efficiency use Page 5 Page 62. corresponding LAN is active Ls Status LED TX Lights blue when the TX link is active Lights green when power is on Flashes blue and green when the transmitter is in power saving mode Status LED RX Lights blue when the RX link is active Lights red when power is on Flashes blue and red when the receiver is in power saving mode T1 R1 RJ 45 connector Connects to Ethernet devices T2 R2 HDMI connector T2 Connects to an HDMI video source R2 Connects to an HDMI display T3 R3 RJ 45 connector Uses CAT5e 6 for connection between two units T4 R4 Serial port T4 DCE Connects to a computer R4 DTE Connects to a serial device IR1 in IR remote jack Connects to an IR receiver IR1 out Connects to an IR transmitter IR2 in Connects to an IR receiver IR2 out Connects to an IR transmitter P Power supply Applies power to the unit Slide Switch Slide Switch Auto Power Saving Normal Long Reach 3 Installation Before installation power off all devices that will be connected to this system Make sure that all devices you will connect are properly grounded Place cables away from fluorescent lights air conditioners and machines that are likely to generate electrical noise Using EIA TIA 568B compliant CAT5e 6 cable connect the video source to the Transmitter Unit and connect the monitor to the Receiver Unit LAN ports Also use industry standard CAT
3. 5e 6 cable EIA TIA 568B compliant between the Transmitter Link Port and Receiver Unit Link Port After all devices are connected attach the provided power cord to an appropriate power source and plug the opposite end into the power connector on the transmitter or receiver CAUTION The CAT5e 6 cables that connect the Transmitter and Receiver Units carry electrical current and should not be plugged into other devices because they may cause damage to them We strongly recommend marking the CAT5e 6 cables you are using with this product at both locations for easy identification Ethernet switch GND PWR IR RS 232 HDMI IN All network RS 232 HDMI OUT All network IP camera TV Ethernet CAT5 cable up to 500 feet 150 m HDMI cable PWR GND IR Slide switch Slide switch Figure 3 1 Typical installation NOTE For phantom power only one power adapter is required to power the entire system You can connect the power adapter to either the transmitter unit OR the receiver unit 4 Operation The extender units have LEDs that light when data is being exchanged between the Transmitter Unit and the Receiver Unit For a high quality output signal make sure you are using a high quality video source cable and display device NOTE The system will disable the video output signal if it detects non HDCP compliant display s when playing the HDCP video source All the connected output displays
4. Extend the distance up to 500 feet 150 m over CAT5e or higher cable with a single PSU 4K HDBaseT HDMI Extender VX HDMI HBP TX VX HDMI HBP RX Order toll free in the U S Call 877 877 BBOX outside U S call 724 746 5500 FREE technical support 24 hours a day 7 days a week Call 724 746 5500 or fax 724 746 0746 www blackbox com E mail info blackbox com Customer Support Information Chapter 3 Installation 724 746 5500 blackbox com VX HDMI HBP TX RX Chapter 2 Overview 724 746 5500 blackbox com VX HDMI HBP TX RX Copyright 2015 Black Box Corporation All rights reserved Black Box and the Double Diamond logo are registered trademarks of BB Technologies Inc HDBaseT is a trademark of HDBaseT Alliance Any third party trademarks appearing in this manual are acknowledged to be the property of their respective owners FREE Live 24 7 Tech Support is just 60 seconds away 724 746 5500 blackbox com VX HDMI HBP TX and VX HDMI HBP RX version 3 Chapter 4 Operation Chapter 2 Overview 724 746 5500 blackbox com Page 2 VX HDMI HBP TX RX 100BASE T Ethernet Pass Thru enables the extender to simultaneously distribute HDMI and Ethernet streaming video from source to display Uses low cost standard CAT5e 6 LAN cable Complies with HDCP and is Blu ray ready s Supports Deep Color HD 3D video and HD audio formats Supports resolutions up to 4K 4096 x 2160 Uses
5. better than coiled 4 Solid cable works better than stranded cable Using stranded cable or cable with 24 AWG or lower diameter may affect the maximum transmission distance 5 Patched cables can result in signal loss and can shorten transmission distance For optimal transmission distance we recommend using only one cable without any intermediate patches between transmitter and receiver units Other Notices 1 EMI or RFI may cause fuzzy or snowy screens on monitors and TVs If this happens restart the displays 2 Because the system transmits large amounts of data the temperature on the unit will increase Do not open the transmitter or receiver unit They contain no user serviceable parts 3 If you are not a registered installer do not tamper with the transmitter and receiver units They are housed in a protective sealed enclosure 2 4 Hardware Description Figure 2 1 shows the front panel of the transmitter or receiver Figures 2 2 and 2 3 show the back panels Table 2 1 describes their components La Ls Figure 2 1 Transmitter or Receiver s front panel P IR1 out IR1 in T4 Slide T3 T2 T1 Switch Grounding Figure 2 2 Transmitter s back panel P IR2 out IR2 in R4 Slide R3 R2 R1 Switch Grounding Figure 2 3 Receiver s back panel Table 2 1 Transmitter and receiver s components ID in Fig 2 1 2 3 Component Description La 3 LAN LEDs LED 1 2 or 3 lights yellow when the
6. bidirectional LAN and serial communications Supports IR extension Line Powered A single power supply connects to either the transmitter or receiver Compact size easy to set up simple to install Ideal for hotels conference rooms control rooms digital signage airports shopping malls surveillance cameras and whole home networking applications 2 2 What s Included Your package should include the following items If anything is missing or damaged contact Black Box Technical Support at 724 746 5500 or info blackbox com 1 Transmitter Unit 1 Receiver Unit 1 48 V 0 83 A power adapter with cord This user s manual 2 sets of foot pads 1 IR external sensor kit Chapter 2 Overview 724 746 5500 blackbox com Page 3 VX HDMI HBP TX RX Chapter 2 Overview 724 746 5500 blackbox com Page 4 VX HDMI HBP TX RX Chapter 1 Specifications Chapter 2 Overview 724 746 5500 blackbox com Page 1 VX HDMI HBP TX RX 1 Specifications Enclosure Metal IR Extension Transceiver 1 Receiver 1 Maximum Extension Distance 500 feet 150 m at 1920 x 1080p 270 feet 80 m at 4096 x 2160 Maximum Video Resolution Up to 4K 4096 x 2160 User Controls 1 Slide switch Auto Power Saving Normal Long Reach Connectors Transmitter 3 RJ 45 Ethernet ports 1 DB9 F DCE Receiver 3 RJ 45 Ethernet ports 1 DB9 M DTE Indicat
7. ors Transmitter 4 LEDs 1 dual color Status LED 3 single color LAN LEDs Receiver 4 LEDs 1 dual color Status LED 3 single color LAN LEDs Power 1 48 VDC power supply PoE provides power from Tx to Rx Size 5 5 H x 3 4 W x 1 4 D 14 x 8 5 x 3 4 cm Weight Transmitter 1 10 lb 0 502 kg Receiver 1 08 lb 0 493 kg Distance depends on the characteristics and quality of the cable and the type of HDMI source and display 2 Overview 2 1 Features Compatible with HDBaseT PoH standard Sends an HDMI signal to multimedia displays over CAT5e 6 cable up to 500 feet 150 meters from the source using only a single PSU HDBaseT technology ensures reliable transmission and superb video quality Transmits full uncompressed 4K video and audio over cable User Manual You might also need HDMI cable Serial cable 2 3 Cabling Requirements HDMI transmission over CATx Ethernet cabling is susceptible to electromagnetic interference EMI or radio frequency interference RFI This may occur if the extender units are too close to fluorescent lighting or power cabling Follow these precautions 1 Place cables away from fluorescent lights air conditioners and machines that are likely to generate electrical noise 2 Shielded cable is recommended and will improve performance in applications with a high level of EMI or RFI 3 For superior video quality uncoiled cables work
Download Pdf Manuals
Related Search