Home

warning

1. INSTALLATION INSTRUCTIONS X cy A Soeaker Stand Model MS 03 Load Capacity 4 5kg 9 9lbs NOTE Read entire instruction sheet before you start installtion and assembly A WARNING Do not begin to installation of the product on you have read and understand the instructions and warnings contained in this Installation Sheet If you have any question regarding any of the instruction or warning Please contact your local distributor Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components Never exceed the Maximum Load Capacity Always use an assistant or mechanical lifting equipment to safely lift and position equipment Tighten screws firmly but do not over tighten Over tightening can damage the items greatly reducing their holding power e This products intended for indoor use only Use of this product outdoors could lead product failure and personal injury 1 Component Checklist IMPORTANT Ensure you have received all parts against the component checklist prior to installing If any parts are missing or faulty telephone the special franchiser for a placement Speaker Stand Base x1 Mounting Plate 1 x1 Mounting Plate 2 x1 Plastic Cover x1 A Pillar x1 B Package M M5x12 x4 M5x16 x1 Steel Isolation Spike x4 M A M B M C C Rubber Footpad x4 M6 N
2. sive pad on the mounting plate Peel the other side of the backing paper on the mounting Self adhesive pad Then place the speaker on the center of the mounting plate as shown in fig 5 1 and fig 5 2 Maintenance Once you have mounted the stand and the speaker check that they are sufficiently secure and safe to use You should check whether screws are fixed well each two months If you have any doubts regarding the installation please consult our retailer or service department for detail 54 6
3. ut x4 Self Adhesive Pad x4 M D M E M F Tools required Phillips Head Screw driver 200mm length exclude the handle Socket and Wrench 2 Attachment of footpad to metal base Attachment of speaker stand base to pillar For hard floor placement Insert pillar from the bottom of speaker stand base and turn pillar to align to mounting hole Secure them with Place speaker stand base A upside down on ground and paste rubber footpad on the 4 holes as shown in fig 1 1 M5x12 M A screw Then tighten the screw but do not over tighten the base over isolation spikes can scratch floors use caution Please ensure cable outlet on top of pole is in line with channel in base as shown in fig 2 1 1b For carpet placement Place speaker stand base A upside down on ground and thread steel isolation spikes M C through M6 nut M E in the 4 holes Adjust the height of speaker stand base by screwing the nut as request as shown in fig 1 2 Mounting plastic cover Cover the speaker stand with the plastic cover E through pillar as shown in fig 3 1 34 4 4 Mounting plate Attach mounting plate to the top of pillar with the appropriate combination of screw M B Make sure mounting plate is level Then tighten the screw but do not over tighten as shown fig 4 1 fig 4 2 H Mounting speaker Remove the backing paper so the adhesive is exposed Then place the adhe

warning

Contents

Download Pdf Manuals

Related Search

Related Contents