20150616 ~ FORBO-EUROCOL-NL ~ 650-eurostar-fastcol
Contents
1. thickness Substrate e 650 Eurostar Fastcol is suitable for any type of subfloor that has a good tensile and compression strength The subfloor should also be even clean permanently dry and free from grease and dirt and other pollutions according to the requirements of BS 8203 or DIN 18 365 In advance always seek our technical data sheets In doubt about the application ask for technical advice User manual Working conditions Required surrounding temperature 18 23 C Temperature for material and subfloor min 15 max 20 C Relative humidity 40 80 Directions for use e Apply the adhesive on the material and the subfloor e g stairs PVC rubber with the enclosed texture roller and let dry completely e Drying time of the adhesive can considerably be reduced to approx 20 minutes by using a ventilator with an fan of approx 20 C Without a device the drying time is 1 2 hours at 20 C e After drying of the adhesive the open time is still approx 4 hours e Itis possible to pre roll the material approx 4 days before fixing On the day of fixing roll the subfloor with 650 Eurostar Fastcol and let dry In case both adhesive layers are dry and the open time has expired an optimal adhesion can be realised by heating these adhesive layers with e g a welding dryer infrared radiator or gas flame for a short period Place both heated adhesive parts together and press carefully Afterwards it is possible t2. eurocol eurocol eurostar fastcol 650 EUROSTAR FASTCOL Very low VOC emission and powerful dispersion based contact adhesive with a strong lt Product Typification Basis Superior polymer dispersion Colour Cream Consistency Thick liquid Very low VOC emission Emicode EC 1 plus Powerful enough to bear high tensions High initial adhesion strength Reactivate through warmth Tool included Performances Specific weight 1 36 kg l Flammability Non flammable Consumption 250 g m per coat Application For the two sided fixing of carpet on stairs PVC nosing PVC adhesive skirting rubber nosing hollow skirting of hard floor covering cork floor covering wall covering with a foamed back for sport halls Working Process Storage Store cool and free from frost Recommended temperature between 15 25 C Tools Texture roller included Open time Na droging van de lijm ca 4 uur Latency After total drying of the adhesive place adhesive parts together Drying 24 hours time Drying Depending on temperature and relative humidity Drying time at an airflow of approx 20 C is approx 20 minutes Drying time without a device is 1 2 hours Shelf Life 12 months in unopened packaging The mentioned values have been established in our laboratory and must be considered as guidelines in view of possible variations in climatic circumstances subfloor compositions and layer
3. o make adjusments by heating the material are again and subsequently press carefully The adhesion of the fixing depends on the application of sufficient adhesive texture roller Remove fresh adhesive spots immediately with water Underfloor heating systems 650 Eurostar Fastcol can be applied on underfloor heating systems The startprotocol of the floorheating needs to be completly executed in accordance with the directives of the supplier Turn off the heater 24 hours before installation Do not heat again until at least 24 hours after installation in steps of maximum 5 C water temperature per day Quality and guarantee Environment and health Hazard Class None Safety and environment Safety data sheets of Forbo Eurocol products according to EEG guideline 91 155 MSDS Available on request Articles Texture roller with synthetic holder included Article Definition Packaging EAN code 650 Eurostar Fastcol 7 5 kg 8 710345 650106 the strong connection
Download Pdf Manuals
Related Search