Operating Instructions
Contents
1. scan speed When done click OK In the Display menu select Data Plot and again in the Display menu select Video and Graphics Note that the scales of the video image and the grid do not correspond Leveling the Stage VERY IMPORTANT Place Height Standard on the stage Press F3 to lower stylus and note final position of stylus relative to the grid Press F3 to raise stylus and using the thumbwheels move stage so a known level portion of the sample is a little to the right of the initial stylus position the stylus scans from left to right NEVER ADJUST THE STAGE WHEN THE STYLUS IS DOWN Press F4 to run a single scan and observe the white data line on the screen as the scan proceeds It should be level and follow the zero line If the scan slopes down up to the right move the large wheel under the stage clockwise counterclockwise and repeat until level Scanning the Sample Move the area to be scanned just to the back of the initial stylus position taking into account that the stylus moves a short distance before data is collected Press F4 to run a single scan If the scan is not in the desired location press Esc Abort to abort the scan and adjust the stage accordingly NEVER ADJUST THE STAGE WHEN THE STYLUS IS DOWN Once the scan is complete move the Measurement M and Reference R cursors to two known level points on either side of the area of interest In the Plot menu select Level To obtain a printable version of the screen inse2. Dektak Instructions DESCRIPTION This machine is used to measure the vertical surface profile of a sample A diamond tipped stylus is lowered onto the sample and the stage is slowly translated causing the stylus to move up and down vertically as it moves along the surface The vertical motion of the stylus is measured electrically and converted to a digital format Any sample with a reasonably hard surface hard baked photoresist is fine with a vertical range of 100 A to 655 kA can be measured Vertical resolution can be as low as 10 A Maximum sample thickness is 20 mm The profile can be viewed on the screen and saved to disk to be printed For information in addition to that provided here consult the user s manual Veeco Meteorology Group Dektak located in the characterization lab OPERATION PROCEDURE Initial Setup Press any key on the keyboard to wake up from screen saver Turn on the illumination intensity control knob directly above stylus on Dektak In Display menu select Video and Graphics Load sample on stage and move using thumbwheels until area of interest is in field of view on monitor Focus the camera lens to right of stylus In the Scan Programs menu select Scan Routine and click on any of the Scan Procedures to bring up a white window Enter the desired scan length The bottom profile hills amp valleys is usually best unless you are sure that the surface will have only one or the other as well as low or medium
3. rt your floppy disk and from the Print menu select either Plot or Plot and Summary This file can be printed from a Unix machine SHUTDOWN PROCEDURE When finished remove your sample and TURN OFF THE ILLUMINATION Leave the computer and the Dektak camera on WBJ JEP
Download Pdf Manuals
Related Search