ProtoQ FPV Harness Helper Installation
Contents
1. ProtoQ FPV Harness Helper Thank you for your purchase of the ProtoQ FPV Harness Helper This document is intended to help you quickly install your Harness Helper The FPV Harness Helper provides a quick and convenient way to change the configuration of your FPV wiring harness using easy to solder surface mount pads and jumpers For maximum OSD compatibility the FPV Harness Helper supports individual passthrough for both video and audio The FPV Harness Helper also supports power distribution across all attached devices Installation To install your FPV Harness Helper follow the simple directions below 1 e You will notice two solder jumpers on the top side of the board between the camera and OSD VTx ports They are labeled XosdVid and XosdAud e These jumpers when shorted pass either audio or video directly to the VTX bypassing the OSD e For example an OSD which only supports video should not have the video jumper solder bridged The audio jumper however should be soldered iY e You ll need to know what function each wire serves For example a camera may have a power video out audio out and ground lead e This pinout should be easily found in the user manual for the component e Wires which do not need to be connected should not be striped however it may be necessary to put a small amount of heat shrink around the exposed end so there is no chance of a short BP e Touch the soldering iron to each2. wire wait about a half second e Feeda small amount of solder into the wire until the bare wire is covered in a shiny coat of solder 7 e Touch the soldering iron to each pad on the FPV Harness Helper wait about a half second e Feed a small amount of solder onto the pad until a shiny bubble of solder has formed 6 nia ng See the reference images below to determine where to connect each wire e Since the FPV Harness Helper and wire have both been tinned there is no need to add more solder to the connection e Place the wire on top of the solder bubble on the FPV Harness Helper e Hold the soldering iron on the wire and solder bubble until the bubble goes molten e Hold the iron in the bubble for a half second then continue holding the wire in place and remove the iron 7 Use the included heatshrink tubing to cover the assembled board Design Contact Information x Design by Chris Seto Chris DragonLabs net Reference Figures Below PAG PAA AN E E A A awana PUTA P iin a FF tS y 3 a a ng I INQPIN HOF ING IAOPIN a Ti ka ITON g a annas Es i Figure 2 Top View FPV Harness Helper Actual Board Figure 3 Bottom View FPV Harness Helper Actual Board
Download Pdf Manuals
Related Search