HM Seamless Control Instruction V2
Contents
1. n MASTER REMOTE CONTROL GUIDE STEP 1 Ensure that the power supply to the firebox is switched on STEP 2 To ignite your Seamless press and release the power PWR button This will begin the ignition sequence which will purge the air from the firebox for approx 30 seconds before igniting the burner Ensure that your remote is set to MANUAL this will be displayed at the bottom of your LCD screen once you press the PWR button To switch between MANUAL and AUTO press the A M button for Auto programming and time setting refer to the 7000 series thermostat user manual STEP 3 Press the A M button to switch between thermostat and flame only setting Flame only decorative setting is indicated by a flame icon in the middle panel or your remote Thermostat setting is indicated by your desired temperature in the middle panel of your remote To adjust the fan flame setting simply use the up or down button to change the set temperature Next to set the temperature you will notice a small 1 2 or 3 which indicates the level of the fan amp flame Level 1 being the lowest and 3 the highest The picture of the flame will also adjust to indicate which level you are on As you increase the gap between the set temperature and then room temperature the level of the flame amp fan will increase As the room temperature gets closer to the set temperature the flame amp fan will modulate down to a lowe2. r level Once the room temperature has reached your set temperature the back burner amp fans will turn off until the room drops below the set temperature again STEP 4 To turn off your Seamless press the power button PLEASE NOTE Fan will continue to run until firebox cools down This is a basic guide only for complete instructions on the use of your Enviro refer to the Customer operating information amp instruction guide along with the 7000 series thermostat user manual www heatmaster com du
Download Pdf Manuals
Related Search