AM/FM PROJECTION CLOCK RADIO USER MANUAL
Contents
1. The clock and timer memory continue running When the AC power resumes the clock switches back to AC again Please note The display will not exhibit time during power failure but the clock will keep correct time internally BATTERY CARE i Use only the size and type of batteries specified ii Do not mix old and new batteries iii Do not mix alkaline standard carbon zinc rechargeable nickel cadmium batteries or equivalent iv If the unit is not to be used for an extended period of time remove the batteries Old or leaking batteries can cause damage to the unit and may void the warranty v Do not try to recharge batteries not intended to be recharged they can overheat and rupture Follow battery manufacturer s directions vi Do not dispose of batteries in fire batteries may leak or explode vii Replace all batteries of a set at the same time RADIO OPERATION Set the AUTO OFF ON Switch 22 to the ON position Set the AM FM Band Switch 12 to the desired band Tune to the desired station with the Tuning Control 16 Adjust the volume level with the Volume Control 19 For best FM reception fully extend the FM Antenna Wire For best AM reception try turning the unit slowly until the best station reception is obtained 6 The radio can be switched off by setting the AUTO OFF ON Switch 22 to the OFF position AOUN CAUTION Do not connect the FM Antenna Wire to any exter2. installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment PROTECT YOUR FURNITURE This system is equipped with non skid rubber feet to prevent the product from moving when you operate the controls These feet are made from non migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture However certain types 3 of oil based furniture polishes wood preservatives or cleaning sprays may cause the rubber feet to soften and leave marks or a rubber residue on the fu
3. to when the alarm time is reached 2 Set the Volume Alarm Knob 19 to a desired volume level The radio will now turn on at the selected alarm time 3 To stop the radio sooner press the ALARM Set button 20 The radio will stop but the alarm remains set and will turn the radio on again at the same time on the following day 4 If you do not want the alarm to turn the radio on the following day set the AUTO OFF ON Switch 22 to the OFF position WAKE TO ALARM 1 Slide the Volume Alarm Knob 19 to the ALARM position until a click is heard The beep will now turn on at the selected alarm time 2 To stop the beep sooner press the ALARM Set button 20 The beep will stop but the alarm remains set and will turn the beep on again at the same time on the following day 3 If you do not want the alarm to turn the beep on the following day set the AUTO OFF ON Switch 22 to the OFF position SNOOZE FUNCTION 1 When your alarm beep or radio sounds you can press the Snooze Button 1 to extend the alarm time by 9 minutes The Beep or radio will then turn on again after 9 minutes 2 This will be repeated until the AUTO OFF ON Switch 22 is moved to the OFF position SLEEP TIMER OPERATION This clock radio is equipped with a sleep timer function that will switch off the radio automatically after a preset period from 1 minute up to 1 hour and 59 minutes 1 Press the Sleep Button 15 the
4. HELLO KITTY 1976 2012 SANRIO CO LTD AM FM PROJECTION CLOCK RADIO USER MANUAL KT2064 CAUTION Electrically Operated Product Please use care when plugging into AC outlet WARNING To reduce the risk of fire or electric shock do not expose this appliance to rain or moisture CAUTION Use of controls or adjustments or performance other than those specified may result in hazardous radiation exposure CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of un insulated dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operation and maintenance servicing instructions in the literature accompanying the appliance IMPORTANT SAFETY INSTRUCTIONS Read these instructions Keep these instructions Heed all warnings Follow all instructions Do not use this apparatus near water Cleaning Unplug this product from the wall outlet before cleaning Do not use liquid cleaners or aerosol cleaners Clean only with a dry cloth Do not bl
5. display will show 0 59 sleep time At the same time radio will come on and stay on for 59 minutes 2 To shorten the SLEEP time to less than 0 59 press the Sleep Button 15 together with the Minute Button 13 until the desired SLEEP time is shown on display To set at the maximum sleep time of 1 59 press the Sleep Button 15 The display will show 0 59 sleep time While holding the SLEEP button press the HOUR button The display will show 1 59 sleep time and the radio will begin to play After 1 hour 59 minutes the radio will shut off automatically To set the Sleep Timer between 0 59 and 1 59 press the Sleep Button 15 together with the HOUR button till it shows 1 59 Then press the Sleep Button 15 together with the Minute Button 13 until the desired SLEEP time is shown on display After the preset SLEEP time has elapsed the radio will switch off automatically To switch if off before the preset SLEEP time has elapsed press SNOOZE BUTTON SLEEP AND WAKE TO RADIO f Set the desired alarm time as described in the section SETTING THE ALARM TIME and set the ON OFF AUTO FUNCTION SWITCH to the AUTO position Set Sleep time as described in SLEEP TIMER OPERATION The radio will switch off after the preset sleep time has elapsed and radio alarm will switch on next day at the preset time CARE AND MAINTENANCE le 2 3 Cl
6. ean the unit with a soft damp never wet cloth Solvent or detergent should never be used Avoid operating your unit under direct sunlight or in hot humid or dusty places to reduce the risk of fire or electric shock Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors For better Clock Display clarity avoid operating the unit under direct sunlight or in strong room illumination Unplug the unit from the electrical power outlet immediately in case of malfunction THIS PRODUCT IS NOT A TOY 90 DAY LIMITED WARRANTY AND SERVICE VALID IN THE U S A ONLY SPECTRA MERCHANDISING INTERNATIONAL INC warrants this unit to be free from defective materials or factory workmanship for a period of 90 days from the date of original customer purchase and provided the product is utilized within the U S A This warranty is not assignable or transferable Our obligation under this warranty is the repair or replacement of the defective unit or any part thereof except batteries when it is returned to the SPECTRA Service Department accompanied by proof of the date of original consumer purchase such as a duplicate copy of a sales receipt You must pay all shipping charges required to ship the product to SPECTRA for warranty service If the product is repaired or replaced under warranty the return charges will be at SPECTRA s expense There are no other express warranties other than tho
7. nal antenna SETTING THE CLOCK TO THE TIME OF DAY Press the TIME SET BUTTON at the same time together with HOUR SET BUTTON for hour setting or MINUTE SET BUTTON for minute setting SETTING THE TIME AND FOCUSING THE PROJECTION CLOCK 1 Set the Projection ON OFF Switch 11 to ON 2 To set the hours simultaneously press and hold the Hour Button 9 and the Time Button 10 Keep them depressed until the desired hour digits are displayed 3 To set the minutes simultaneously press and hold the Minute Button 23 and the Time Button 10 Keep them depressed until the desired minute digits are displayed 4 Focusing Adjust the projection clock clarity by turning the Focus Adjustment Knob 8 until the projected time is clearly shown on the ceiling or wall 5 To turn the projector off set the Projection ON OFF Switch 11 to OFF Note The LED Digital Clock and the Projection Clock must be set separately ll The projected time is visible on a ceiling or wall in a darkened room The maximum projection distance is 3 9 feet 91 cm 2 74 m SETTING THE ALARM TIME Press the ALARM SET BUTTON at the same time together with HOUR SET BUTTON for hour setting or MINUTE SET BUTTON for minute setting ALARM OPERATION Set the AUTO OFF ON Switch 22 to the AUTO position The AUTO Indicator 4 will light WAKE TO RADIO 1 Set the radio Tuning Control Knob 16 to the station you wish to listen
8. ock any ventilation openings Install in accordance with the manufacturer s instructions 8 Do not install near any heat sources such as radiators heat registers stoves or other apparatus including amplifiers that produce heat OP OT Co NO al 1 Ti 12 18 19 20 Do not defeat the safety purpose of the polarized or grounding type plug A polarized plug has two blades with one wider than the other A grounding type plug has two blades and a third grounding prong The wider or the third prong is provided for your safety If the provided plug does not fit into your outlet consult an electrician for replacement of the obsolete outlet Protect the power cord from being walked on or pinched particularly at plugs convenience receptacles and the point where they exit from the apparatus Only use attachments accessories specified by the manufacturer Use only with a cart stand tripod bracket or table specified by the manufacturer or sold with the apparatus When a cart is used use caution when moving the cart apparatus combination to avoid injury from tip over Unplug this apparatus during lightning storms or when unused for long periods of time Refer all servicing to qualified service personnel Servicing is required when the apparatus has been damaged in any way such as power supply cord or plug is damaged liquid has been spilled or objects have fallen into the apparatus the apparatus has been exp
9. osed to rain or moisture does not operate normally or has been dropped This apparatus shall not be exposed to dripping or splashing water and that no object filled with liquids such as vases shall be placed on the apparatus Main plug is used as disconnect device and it should remain readily operable during intended use In order to disconnect the apparatus completely the main plug should be disconnected from the main socket outlet completely Battery shall not be exposed to excessive heat such as sunshine fire or the like The marking information is located at the back of the apparatus The Caution Marking is located at the back of the apparatus Danger of explosion if battery is incorrectly replaced Replace only with the same or equivalent type CAUTION TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF AC PLUG TO WIDE SLOT FULLY INSERT SD AC Outlet AC Plug COMPLIANCE WITH FCC REGULATION This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential
10. rniture To prevent any damage to your furniture we strongly recommend that you purchase small self adhesive felt pads available at hardware stores and home improvement centers everywhere and apply these pads to the bottom of the rubber feet before you place the product on fine wooden furniture FUNCTIONS AND CONTROLS 1 Snooze Button 13 Minute Button for LED Display 2 Projector 14 Hour Button for LED Display 3 PM indicator 15 Sleep Button 4 Auto Indicator 16 Tuning Control Knob 5 Rating Label 17 FM Antenna Wire 6 Battery Compartment 18 AC Power Cord 7 LED Display 19 Volume Alarm Knob 8 Focus Adjustment Knob 20 Alarm Set Button 9 Hour Set Button for Projector 21 Time Set Button for LED Display 10 Time Set Button for Projector 22 AUTO OFF ON Switch 11 Projection ON OFF Button 23 Minute Set Button for Projector 12 AM FM Band switch POWER CONNECTION Plug the AC power cord to a household outlet AC source This unit is equipped with a battery back up system it requires 3 pieces of 3V flat lithium battery CR2025 not included Insert the battery in the battery compartment making certain that the positive and negative and battery terminals are attached to the corresponding terminals on the plate in the battery compartment If an AC power failure occurs the clock automatically switches to the battery power supply
11. se stated herein This warranty is valid only in accordance with the conditions set forth below 1 The warranty applies to the SPECTRA product only while a It remains in the possession of the original purchaser and proof of purchase is demonstrated b It has not been subjected to accident misuse abuse improper service usage outside the descriptions and warnings covered within the user manual or non SPECTRA approved modifications c Claims are made within the warranty period 2 This warranty does not cover damage or equipment failure caused by electrical wiring not in compliance with electrical codes or SPECTRA user manual specifications or failure to provide reasonable care and necessary maintenance as outlined in the user manual 3 Warranty of all SPECTRA products applies to residential use only and is void when products are used in a nonresidential environment or installed outside the United States This warranty gives you specific legal rights and you may also have other rights which vary from state to state TO OBTAIN SERVICE please remove all batteries if any and pack the unit carefully and 10 send it freight prepaid to SPECTRA at the address shown below IF THE UNIT IS RETURNED WITHIN THE WARRANTY PERIOD shown above please include a proof of purchase dated cash register receipt so that we may establish your eligibility for warranty service and repair of the unit without cost Also include a note with a descrip
12. tion explaining how the unit is defective A customer service representative may need to contact you regarding the status of your repair so please include your name address phone number and email address to expedite the process IF THE UNIT IS OUTSIDE THE WARRANTY PERIOD please include a check for 15 00 to cover the cost of repair handling and return postage All out of warranty returns must be sent prepaid It is recommended that you contact SPECTRA first at 1 800 777 5331 or by email at custserv spectraintl com for updated information on the unit requiring service In some cases the model you have may be discontinued and SPECTRA reserves the right to offer alternative options for repair or replacement SPECTRA MERCHANDISING INTERNATIONAL INC 4230 North Normandy Avenue Chicago IL60634 USA 1 800 777 5331 To register your product visit the link below to enter your information http Awww spectraintl com wform htm 0512 Printed in China 11 KT2064 HO09
Download Pdf Manuals
Related Search