PARKHOUSE HEALTHCARE - Hjelpemiddeldatabasen
Contents
1. AGAINST A SOLID SURFACE RETURN PUMP TO VOUR SERVICE PROVIDER NOTE ALL CIRCUIT DIAGRAMS AND PARTS ARE AVAILABLE FROM PARK HOUSE HEALTHCARE BUBBLE MATTRESS SVSTEM TROUBLESHOOTING PROCEDURES FAULT THINGS TO SOLUTION TO IF STILL NOT DESCRIPTION CHECK PROBLEM WORKING 1 THE PUMP IS MAINS IS PLUGGED PLUG IN RETURN PUMP SHOWING NO IN TO SERVICE INDICATORS TO SAY MAINS ARE TURNED TURN ON PROVIDER THAT IT IS ON ON FRONT SWITCH IS TURN ON ON FUSES ON THE SIDE REPLACE WITH A PUMP ARE NOT 1 AMP FUSE BLOWN FUSE IN THE PLUG REPLACE WITH A BLOWN 3 AMP FUSE 2 THE LOW THE HOSES ARE RECONNECT RETURN RESSURE LIGHT IS ALLCONNECTED HOSES SYSTEM TO ON AND NOT GOING THERE ARE NO RETURN YOUR OUT LEAKS IN THE MATTRESS TO PROVIDER MATTRESS SYSTEM YOUR SERVICE PROVIDER 3 THE PUMP IS DISCONNECT HOSES RETURN PUMP TO RETURN ON BUT NOT FROM PUMP TO SEE IF YOUR SERVICE SYSTEM TO INFLATING THE AIR IS COMING OUT PROVIDER YOUR MATTRESS SERVICE PROVIDER THE HOSES ARE ALL CONNECTED RECONNECT HOSES THERE ARE NO OBVIOUS AIR LEAKS IN THE MATTRESS SYSTEM RETURN MATTRESS TO YOUR SERVICE PROVIDER WARNING MAXIMUM PATIENT WEIGHT 100 kgs WARNING ELECTRICAL EQUIPMENT CAN BE HAZARDOUS IF MISUSED ONLY AUTHORISED TECHNICAL PERSONNEL SHOULD REMOVE THE PUMP FOR MAINTENANCE WARNING DO NOT USE THIS PUMP IN THE2. PRESENCE OF FLAMMABLE GASES WARNING BEFORE CLEANING THE UNIT ENSURE THAT THE ELECTRICAL SUPPLY TO THE PUMP HAS BEEN DISCONNECTED PLEASE REMOVE THE PLUG FROM THE POWER SUPPLY WARNING IF THE PUMP IS SWITCHED OFF FOR WHATEVER REASON THE MATTRESS WILL DEFLATE CAUTION DO NOT USE THIS SYSTEM AS A MEANS FOR LIFTING THE PATIENT TRANSPORT amp STORAGE CONDITIONS NOT TO GO OUTSIDE THE FOLLOWING RANGES IN A PERIOD NOT EXCEEDING 15 WEEKS AN AMBIENT TEMPERATURE RANGE OF 40 C TO 70 C A RELATIVE HUMIDITY RANGE OF 10 TO 100 INCLUDING CONDENSATION PRODUCT DESCRIPTION The Bubble is an alternating mattress overlay system used in the prevention and treatment of pressure ulcers By using the established principles of alternating therapy the Bubble offers patients a comfortable and relaxing support surface which can both prevent breakdown and enhance healing The Bubble power unit is both lightweight and compact and features a visual low pressure indicator and a factory set pressure control The mattress unit alternately inflates and deflates throughout the 9 5 minute alternating cycle In the event of cardiac arrest rapid deflation is achieved by disconnecting the hoses from the pump GUARANTEES AND WARRANTIES 4 Warranty Extended warranties can be purchased from Park House Healthcare for more information contact Customer Services on Tel 0845 066 333 5 Claims Relating to Guarantee or Warranty I
3. the foot end of the bed 2 Place the support surface on top of the existing mattress with the cell uppermost 3 Connect the tubes leading from the mattress to the outlet Ports Inflation tubes should be at the foot end of the bed on the pump Note The Bubble pump must oniv be used with the Bubble mattress 4 Tuck end flaps under the mattress 5 Connect the pump to the mains power supply and switch on the pump At this stage both the mains power and low pressure indicators will illuminate 6 Cover the support surface with a looselv fitting sheet 7 When the low pressure indicator has extinguished patient may be placed on the support surface and further bedding added Operating Functions a CPR Requirement If rapid deflation of the mattress is required simplv disconnect the two hoses from pump b Infection Control Should the mattress become infected then please refer to our disinfection protocol for appropriate cleaning processes DISINFECTION PROTOCOL The following guidelines are suggested Park House Healthcare Ltd as suitable infection control procedures Further information is available PUMPS General cleaning mav be effected bv using a cloth dampened with a mild detergent and water solution This approach mav be followed either by wiping with a sodium hypochlorite solution to a dilute of 1000 ppm or by using an alcoholic wipe DO NOT use hyper carbonate or phenol based cleaning solutions DO NOT use a
4. CONTENTS GENERAL SAFETV WARNINGS PRODUCT DESCRIPTION INSTALLING VOUR SVSTEM CLEANING YOUR SYSTEM DISINFECTION PROTOCOL ANNUAL MAINTENANCE WARRANTV TROUBLESHOOTING SAFETV Before vou use vour Bubble Mattress Overlav Svstem please familiarise vourself with the information in this user manual Keep this manual in a handy place for future reference For vour safetv and the efficient performance of the svstem the following precautions should be observed MAXIMUM WEIGHT LIMIT 100 kgs Do not expose the pump to liquids of anv kind Alwavs protect the svstems from open flames Avoid the use of Phenol based solutions when cleaning Store the svstem in a clean and drv environment Do not store in direct sunlight NOTE The pump in this svstem is fitted with a functional earth and is labelled accordingly Double insulation See instructions As labelled accordingly for use gt D D BF equipment There is a possibility of electro magnetic interference with other devices If so increase distance between devices BUBBLE MATTRESS SYSTEM TROUBLESHOOTING ALTERNATING PROCEDURE FAULT THINGS TO SOLUTION TO IF STILL NOT DESCRIPTION CHECK PROBLEM WORKING 4 THE THERE ARE NO UNTWIST ANV RETURN SYSTEM TO SYSTEM DOES KINKS IN THE KINKS FOUND YOUR SERVICE NOT APPEAR TUBING RUNNING PROVIDER TO BE DOWN THE SIDE 5 THE PUMP IS OPERATING NOISILV THE PUMP IS NOT RESTING
5. gistered Approved code Certificate No 8019 ISO Certificate No 8019 Whitehall 26 Business Park CE Certificate No CA001810 Heathfield Lane Birkenshaw Master Indemnity Assurance No IFA2433 0451 CCI West Yorkshire BD11 2HW UK Tel 0845 0600 333 Fax 0845 0600 334 Email sales parkhouse hc com International Tel 44 0 1274 475000 International Fax 44 0 1274 475046 International Email international parkhouse hc com Copyright Park House Healthcare Ltd 2010 Web www parkhouse hc com Due to its policy of continued developed and improvement Park House Healthcare Ltd reserves the right to amend any details and specification without notice Park House Healthcare BUBBLE Mattress Overlay System User Manual
6. n the event of a fault being discovered within the period the customer shall notify the Company at the earliest opportunity If upon inspection the Company accepts liability then the equipment shall be repaired or replaced immediately If the Company does not accept liability it shall inform the customer of its reasons for declination and provide the customer with an estimate of both the repair or replacement cost The Company reserves the right to alter or amend this document without notice GUARANTEES AND WARRANTIES Pumps Pump Models have a guarantee for a period of 1 vear following the date of despatch Mattress Mattresses are guaranteed for a period of 6 month effective from the date of despatch Guarantee The Companv guarantees to repair or replace anv equipment issued to its customers which is found to be faultv during the relevant guarantee or warrantv period The Companv s guarantees are subject to the following conditions a That the equipment has been used for the purpose for which it was intended b That the usage has been on a fair wear and tear basis c That the Company s cleaning disinfection guidelines have been followed d That the Companv s maintenance guidelines have been followed e That maintenance has been carried out bv a suitable qualified person BRIEF OPERATING PROCEDURES BUBBLE ALTERNATING MATTRESS SVSTEM Installation 1 Unpack the system and place the pump at
7. ny abrasive compounds or cleaning pads MATTRESS During general use the mattress and tube set may be cleaned by using a mild detergent solution Wherever there is staining or body fluids on the mattress including cells and tubing then a sodium hypo chlorite solution to a dilution of 1000 ppm should be used following through cleansing with soap and water Do not use phenol based solutions CAUTION During cleaning procedures suitable protective clothing should be worn Ensure that mains power supply to the pump has been disconnected prior to cleaning ANNUAL MAINTENANCE Inspect all Filters If filter is dirty clean with a vacuum cleaner If filter is still dirty then replace with a new one Check that the timer is rotating if not then replace Remove timer top and clean all dust and grease off with a cloth Use a screwdriver to get into all the grooves on the gear drive cog The whole timer assembly should be replaced every three years of service Ensure that all the hoses inside and outside the pump are kink and split free If any splits are found replace the tubes Ensure that all the hoses inside and outside the pump are not brittle If any tubes are brittle then replace the tubes Check that all indicators are working if not then replace the faulty indicators New Corporate Headquarters opened in October 2006 The Companv Founded in 1984 Park House Healthcare Ltd is recognised as one of the leading manufactu
8. rers of specialist pressure relieving and pressure reducing equipment in the U K Park House Healthcare Ltd has an extensive product portfolio and the facilitv to customise products to suit customer needs whilst offering solutions in pressure care postural management and moving and handling Emploving over 100 full time staff at our 60 000 sq ft state of the art Corporate Headquarters in West Yorkshire Park House Healthcare are proud to offer in house manufacturing a full product audit and decontamination service and a network of distribution centres as part of our continued commitment to Customer Care 24 hour care 365 davs a vear dedicated internal personnel manage specific regions and divisions ensuring one on one personal customer service at all times With distributors in 25 over countries Park House Healthcare are a trulv international companv and we place important emphasis on providing high levels of customer care to ensure we exceed customer expectations at all times Additional support nationwide is available through our service centres situated strategicallv around the country Park House Healthcare Ltd is a respected member of the British Healthcare Trade Association and has BS EN ISO 9001 and EN 46002 accreditation which is the specific quality standard for Medical Devices All products are CE marked in accordance with the European Directive 93 42 EEC CE EEI Park House Healthcare Park House Healthcare Ltd Re
Download Pdf Manuals
Related Search