english 1 Proper use, warranty 2 Safety instructions
Contents
1. Before using the machine for the first BA time read the operating manual and keep it for later use and to pass on to any subsequent users Observe all safety instructions on to the machine WARNING Dangerous for children and others The machine may not be used by X persons including children under O 14 years of age with limited physi cal sensory or mental capabilities or with a lack of experience and knowl edge unless they are supervised by a responsible person or are instructed by them on the use of the machine Children must be Supervised to ensure they do not play with the machine Do not leave the document shredder switched on when it is unattended HSM 11 WARNING Risk of injury Do not reach into the paper feed slot eK Risk of injury from being pulled in 7T Keep long hair loose articles of cloth ing ties scarves jewellery etc away from feed opening Material with the tendency to form loops e g tapes i strapping material etc must not be shredded oh Beware of injury when using the CD splitter Wear goggles when destroying CDs in ma chines without a separate CD cutting unit WARNING Dangerous mains voltage Improper handling of the machine can lead to an electric shock Before you insert the power plug make sure that the voltage and frequency of your power supply comply with the information on the name plate Make sure that the power p2. Notes Manual reversing If you press the reverse button the cutting unit runs in reverse and switches off after 2 sec onds even if you keep the button pressed To reverse manually release the button and press it again If the shredder is already running forward pressing the button immediately reverses it Shredded material container Both cutting units stop when the paper or CD container is full On machines with a separate CD cutting unit the level in the CD container see overview item 7 is monitored Empty the container after there is a signal on the operating and indicator element 16 HSM SECURIO P36 Fill the reservoir with cutting apparatus oil Only use HSM special oil Reservoir volume 250 ml Press the safety element and lift up the flap The oil filling opening is to the right of the feed chute You can fill the oil either through the small opening 1 take out the yellow plug or the normal opening 2 unscrew the red cap Automatic oiler cross cut only The cutting units are oiled for 1 5 seconds after e The cutting unit is in operation for 200 sec onds corresponding to 50 paper shreds e The cutting unit runs forwards after the re verse button has been pressed The Oil reservoir empty signal is automati cally deactivated after the reservoir is filled The shredder remains operational even when the oil reservoir is empty Metal detection optional The document shredde
3. The light barrier starts the cutting unit automatically Therefore with thin paper strips make sure the light barrier detects them Note Do not shred paper in the CD cutting unit This can cause damage gt 3 seconds after the light barrier in the paper feed opening is free again the cutting unit is switched off automatically and the shredder switches to standby Destroying CDs credit cards and floppy disks e Check whether your machine is certified for destroying these materials see Proper use english Other function modes e Permanent mode Application Destroying large quantities of CDs and paper Function Cutting unit runs continuously If no material is fed in within a period of 3 minutes the cutting unit shuts down and the shredder switches to standby Start Press the on off button for at least 4 seconds To cancel Press the on off button e Sleep mode Function Two minutes after the last paper feed operation all consumers that are not required are switched off automatically The Ready for operation indicator goes out briefly at regular intervals The shredder starts automatically when pa per is fed in e Automatic shutdown Function If the shredder is not used for one hour it shuts down completely and therefore does not consume any more electricity at night at the weekend Restart Press the on off button e For machines with a separate CD cutting unit optional put the mat
4. our customer service address es HSM 17 english 9 Technical data Cutting type Strip cut Cut size mm 45x30 1 9x15 0 78x11 1x5 Security level DIN 32757 1 Level 6 Cutting capacity sheets A4 70 g m 47 49 37 39 29 31 18 20 11 12 9 80 g m 39 41 31 33 25 27 15 17 9 10 7 Cutting speed See Power consumption with max number of sheets Operating mode Continuous operation Ambient conditions in operation Temperature 10 C to 25 C Relative humidity max 90 without condensation Height above sea level MSL max 2 000 m Dimensions W x D x H mm 580 x 550 x 936 Volume of the shredded paper container 145 Sound pressure level emissions 58 59 dB A 60 61 dB A Idle running load Cutting size of the separate CD cutting Order number C E Order number M N unit optional 3 9 x 40 mm 2 2 x 2 0 mm HSM specification The maximum number of sheets DIN A4 70 g m or 80 g m fed lengthways which can be cut in one cycle The performance data is determined when the motor is cold and the cutting device is freshly oiled A weaker mains voltage or a different mains frequency to the one specified could result in less sheet capacity and increased noise during op eration The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters The performance data in 80 g m is calculated KKK Identified by the letter after the 7 digit orde
5. 1 Proper use warranty Check the name plate on the back of the ma chine to find out the cutting width and mains voltage for your document shredder and ob serve the applicable instructions in the operat ing manual The shredder is designed for destroying paper Depending on the cutting type it can also han dle small quantities of the following materials Credtcaras felele le es o e Foys ee Its sturdy drive mechanism is not damaged by paper clips and staples Only on machines with safety level HS Level 6 1 x 5 mm can the pa per not contain staples or paper clips Note You can also shred CDs diskettes and credit cards in the separate CD cutting unit op tional without using the paper cutting unit The warranty period for the document shredder is 2 years There is a special warranty for the HSM solid steel cutting rollers in the document shredder which is provided independently of the guarantee and remains valid for the entire service life of the machine HSM Lifetime War ranty Exceptions to this are document shred ders with security levels 5 and HS level 6 This warranty and guarantee exclude wear and dam age caused by improper handling or actions taken by third parties 05 2012 SECURIO P 36 english 2 Safety instructions Classification Safety notice Explanation Failure to observe this warning can lead to serious or fatal injury Failure to observe this instruction can cause damage
6. empty the waste con tainer Only use HSM special lubricating oil for the cutting unit to do this e Spray special cutting apparatus oil through DON T FORGET Nur Hersteller O1 verwenden Exclusive use with manufacturer oil ra ee a a a J the paper feed opening along the entire width on to the cutting rollers e Let the cutting unit run in the permanent mode for about 10 seconds without any pa per gt Paper dust and particles are shaken off 05 2012 SECURIO P 36 english 7 Disposal Recycling Electrical and electronic old devices contain a variety of valuable materi als but also hazardous substances which were required for function and safety Incorrect disposal or handling can be dangerous to your health and the environment Never dispose of old devices in the household waste Observe the current applicable regulations and use the collection points for returning and recycling electric and electronic devices Dispose of all the packaging materials also in an environmentally responsi ble way 8 Scope of delivery e Paper shredder ready for connection in car ton packing carton on pallet tied with strap ping tape e 5 bags for shredded material e Special cutting block oil cross cut e Operating instructions Accessories e 10 bags for shredded material order No 1 442 995 110 e Special cutting block oil 250 ml order No 1 235 997 403 See page 92 for
7. erial in the feed slot of this cutting unit This protects you from splin ters Otherwise use the paper cutting unit Switching off the shredder e Press the on off button gt The Ready for operation indicator goes out e Only US version Set mains switch at rear of paper shredder to 0 14 HSM SECURIO P36 05 2012 english Fault and function indicators Display Paperjam You have fed in too much paper Overload The cutting unit runs in reverse for a few seconds and pushes the paper back out again If necessary press the reverse button R to remove the stack of paper Take half the stack of paper Feed the paper in portions Note You can lift up the safety element in order to better remove paper To do this press the middle section of the front of the safety element and lift up the flap Continu ous lamp Note This indicator lamp also lights up when the motor is overloaded In this case let the shredder cool down for 20 minutes before using it again Flashing Paperand Do not use both cutting units at the same time but rather shred paper and light CD fed at CDs diskettes credit cards separately the same time Press safety The LED also flashes if you press the safety element or open the door while element there is a paper jam Paper e Empty the paper shredded material container p shredded Note material If you press the reverse button briefly before opening the doo
8. lude all the assemblies SECURIO 1 2 34 5 6 7 1 Feed slot for CDs floppy discs and credit cards optional Safety instructions Light barrier in the paper feed Safety element Operating and display unit Holder for operating manual and oil bottle Shredded material for CDs floppy discs and credit cards optional 8 Filler opening for cutting apparatus oil cross cut only NOOB W ND R button e Cutting unit runs in reverse e Error acknowledgement e Software version display for service technicians only Indicator door open 4 ee A Indicator oil reservoir empty or safety element not latched JA NY Function button On off start Indicator overload paper jam A Indicator paper CD container full im i Operating and display elements Note depending on the machine version not all functions may be available Indicator metal detection yi af J ya Indicator button lock GAS Indicator ready for operation Sleep down 05 2012 SECURIO P36 HSM 13 5 Operation WARNING A Before switching the machine on make sure that you observe all safety instructions Switching on the shredder e Only US version Set mains switch at rear of paper shredder to l e Check that no paper is in the paper feed slit e Press the on off button gt The Ready for operation indicator lights up Shredding paper e Feed the paper to the middle of the paper slot
9. lug is easily ac cessible Make sure that no water gets into the shred der Do not immerse the power cable or the power plug in water Never touch the power plug with wet hands Never pull the plug out of the socket using the power cable Always pull out the plug directly Only use the machine in a dry room indoors Never operate the machine in damp rooms or in the rain 12 HSM SECURIO P 36 english Check the machine and cable regu larly for damage Switch the shred der off if it is damaged or not work ing correctly or before relocating or cleaning it and disconnect it from the mains Keep the machine the plug and cable away from open fire and hot surfaces The ventila tion slots must not be blocked or covered and there must be at least 5 cm space be tween the shredder and any wall or furniture Service work may only be carried out by HSM Customer Service or by the service technicians of our con tractual partners See page 92 for our customer ser vice addresses Danger from improper use Notice Only operate this machine in accordance with the instructions outlined in Proper use 3 Commissioning Before starting up the machine for the first time open the door and remove the three wing nuts of the transport locks from the base plate under the cutting unit 05 2012 english 4 Machine components Note Depending on the version your machine may not inc
10. r part of the Continu container material is pulled back into the cutting apparatus ous lamp full i CD contain Empty the CD container To do so lift it upwards out of the bracket ight er full Door is e Close the door or latch in the safety element open or Note safety Movement of the safety element was detected during the shredding proce element not dure If your machine switches off without signalling an error pull the paper latched out of the paper slit and feed it back in again S Metal detec Press the reverse button and pull the paper put of the feed slot Remove any metal which is in the paper or on the safety element Acknowledge the error by pressing the R button 05 2012 SECURIO P 36 HSM 15 Cutting unit runs con tinuously even though e the machine is not in the permanent mode Display Several indicators are lit english The light barrier is soiled with paper dust Clean the light barrier in the paper feed using a dry brush or cloth The R button was pressed for more than 20 s Software version display for service technicians only Oil reservoir Nur Hersteller O1 verwenden Exclusive use with manufacturer oil Display Function A Button lock To activate or deactivate the button lock is activated Press and hold the reverse button e Press the on off button Release the on off button and then the R button Activate deactivate
11. r can be optionally equipped with a metal detector The automatic switch off allows damage to the cutting unit by paper clips or other metal objects to be avoided Safety element monitoring Movement of the safety element was detected during the shredding procedure If your ma chine switches off without signalling an error pull the paper out of the paper slit and feed it back in again 05 2012 6 Cleaning and maintenance WARNING Dangerous mains voltage Switch off the shredder and pull out the mains plug When cleaning only use a soft cloth and a mild soap water solution However no water must enter the equipment Check that the door switch is working properly WARNING If the following procedure cannot be performed switch off the document shredder disconnect the mains plug and contact customer service e Insert the mains plug and switch on the shredder e Feed in a sheet of paper and open the front door while the paper is being drawn in The cutting unit must turn off immediately and the door open indicator must light up e Close the door gt The cutting unit must not yet restart e Pull the paper out of the feed opening The light barrier must be clear e Switch off the machine and then switch back on The cutting unit starts when paper is fed in Strip cut only Oil the cutting unit when cutting performance de creases or the device be comes noisy or every time you
12. r number on the name plate on the back of the machine e g 1873111C gt gt cutting size 3 9 x 40 mm EC Declaration of Conformity The manufacturer HSM GmbH Co KG Austra e 1 9 88699 Frickingen Germany hereby declares that the ma chine referred to here as document shredder Securio P36 corresponds to the health and safety requirements of the following EC directives listed below due to its conception and design of the version in which it was put into circulation by us Low voltage directive 2006 95 EEC EMC directive 2004 108 EC Applied standards and technical specifications e EN 55014 1 2006 e EN 61000 4 2 1995 A1 1998 A2 2001 e EN 55014 2 1997 A1 2001 e EN 61000 4 4 1995 A1 2001 A2 2001 e EN 61000 3 2 2006 e EN 61000 4 5 1995 A1 2001 e EN 61000 3 3 1995 A1 2001 A2 2005 e EN 61000 4 6 1996 A1 2001 e EN 60950 1 2006 A11 2009 e EN 61000 4 11 1994 A1 2001 Frickingen 01 03 2010 Rolf Gasteier Technical Director 18 HSM SECURIO P 36 05 2012
Download Pdf Manuals
Related Search