Perfekt_Glide-30 User Manual
Contents
1. Filter For highest efficiency this filter should be removed and cleaned periodically Soak the filter in hot water and mild soap or detergent Rinse thoroughly and repeat if necessary The filter may be cleaned in the dishwasher Heavy grease buildup may not be cleaned easily thus the filter may need to be replaced Charcoal Filter Inspect this filter periodically This filter cannot be cleaned and must be replaced Light Bulb This model specifies 2 x 1W LED light bulbs Exterior surface Wipe the range hood exterior with a soft cloth and a mild detergent suitable for painted surfaces Do NOT use abrasive materials such as steel wool pads or scouring pads Repair or Replacement Parts Warning Disconnect range hood from the electrical power supply before servicing All parts may be obtained from Euro Parts 1 800 678 8352 When ordering parts please specify the range hood model number on the rating label which is located on the inside of the range hood 12 Page Trouble Shooting If any problem occurs please detach the plug from the socket and contact Euro Parts or a similarly qualified person in order to avoid a hazard Fan does not turn on but light turns on This is probably due to either a defective fan switch or a burned out fan motor Both can be replaced without removing the range hood from the wall or cabinet Use an ohm meter to determine which component is not working If the ohm meter reads that the fan swit2. explosion may result o Use a fire extinguisher only if a You know that you have a Class ABC extinguisher and know how to use it b The fire is small and contained in the area it started c The fire department is being called d You can use the extinguisher with your back to an exit 3 Page CAUTION Important observe all governing codes and ordinances o For general ventilation use only Do not use this appliance to exhaust hazardous or explosive materials and vapors To reduce the risk of fire use only metal duct work To avoid damage to motor or other components keep drywall spray construction dust etc off the power unit o Please read the specification label on product for further information and requirements o To reduce risk of fire and exhaust air be sure to duct air outside Do not vent exhaust air into space within wall or ceiling or into attic crawl space or garage CAUTION Grounding Instructions o This appliance must be grounded In the event of an electrical short circuit grounding reduces the risk of electrical shock by providing an escape wire for the electrical current This appliance is equipped with a cord having a grounding wire with a grounding plug The plug must be plugged into an outlet that is properly installed and grounded o Improper grounding can result in a risk of electric shock Consult a qualified electrician if the grounding instructions are not properly understood or if doubt exists
3. non ducted install a charcoal filter purchased separately When venting ductless you must remove the vent cover from the slots on the front of the range hood Save the vent cover for possible future use Use the 70mm rail instead of 40mm rail Cabinet Preparation for Hood Support The range hood should be mounted at a distance of 600mm from an electric or induction cooktop and 762mm above a gas cooktop for safety and optimum performance If you install the hood with a duct CC IT you will need to provide a hole for ie the duct Please use the template provided to locate the hole Use the diagram below for proper placement of ductwork and electrical cutout in cabinet For a non ducted installation DO NOT cut a duct access hole Warning When cutting or drilling into wall or cabinet be careful not to cut existing electrical wiring 1 If the bottom of the cabinet is recessed above the bottom of the cabinet door then it is necessary to install wood strips on each side of the recessed area on the bottom of the cabinet where the range hood will be mounted The wood strips should line up with the 4 keyhole slots on the top of the range hood 8 Page Fasten the wood strips with wood screws about 3 in from each end NOTE the thickness of the wood strips should be slightly more than the recessed dimension The length should be cut to size 2 Measure and mark the el
4. WAEG perfekt in form und funktion Perfekt Glide 24 Perfekt Glide 30 Built in Range hood Instruction Manual Thank you for the purchase of this product Please read the manual carefully before operating the appliance Contents Safety Precautions 2 5 Accessories 5 Features 6 Installation Preparation 6 Selecting Venting Direction 7 Cabinet Preparation for Hood Support 8 9 Preparation for Duct Connection 9 Hood Installation 10 Controls 11 Specifications 11 Use and Care 12 Trouble Shooting 13 14 Installation Diagram 15 Warranty Information 16 1 Page Safety Precautions READ AND SAVE THESE INSTRUCTIONS WARNING to reduce risk of fire electrical shock or injury observe the following O O O Read all instructions before using the appliance Use this appliance only for its intended purpose as described in this user manual Do not use any accessories not recommended by the manufacturer This unit must be grounded Do not use this appliance for commercial use Do not use with any solid state speed control device Installation work and electrical wiring must be done by qualified technicians in accordance with all applicable codes and standards including fire rates construction Sufficient air is needed for proper exhausting of gases of fuel burning equipment through the chimney to prevent back drafting Follow the heating equipment manufacturer s guideline and safety standards When replacing an existing range h
5. as to whether the appliance is properly grounded Do not use an extension cord If the power supply cord is too short have a qualified electrician install an outlet near the appliance 4 Page CAUTION o Do not operate any fan with a damaged cord or plug Discard fan or return to an authorized service facility for examination and or repair o Do not run cord under carpeting Do not cover cord with throw rugs runners or similar coverings Do not route cord under furniture or appliances Arrange cord away from traffic area and where it will not be tripped over Accessories Range hood accessories provided 1 x Range hood 4 x Range hood screws 4 x Washers 2 x Filters 1 x User manual O O O Check to make sure that all parts and accessories are present and in good condition If you find that they are not in good condition or missing please contact Euro Parts for assistance 1 800 678 8352 5 Page Features This appliance is manufactured from top quality materials and offers superb streamlined effects With high suction power and low noise it is designed to remove cooking fumes from your kitchen quietly and effectively Installation Preparation Note this procedure will require 2 people for easier installation General Preparation O Remove range from packaging and lay upside down on table covered with cardboard or paper to prevent scratching of the hood or table Be sure the power switch is set to OFF T
6. ch has 0 ohms of resistance then it is the motor that needs to be replaced If it reads anything other than zero then the switch must be replaced Fan only runs at once speed Please see above instructions Fan circulates air but does not vent outside If air is blowing through the front vent openings then your range has been installed for ductless operation In order to convert the system to vent outside a technician must install ductwork from the range hood through either an outside wall or the roof If air is not blowing from the front vent openings check inside the cabinet about the range hood If you see a duct leading away from the vent hood then you have a system that vents to the outdoors If you do not see a duct your unit may be venting through the back wall 13 Page Light does not turn on but fan turns on This could be because the bulb has burned out Try replacing the light bulb If the light still does not work either the light switch or the lamp holder socket is defective Both can be replaced without removing the range from the wall or cabinet Range hood does not turn on at all Check for a tripped circuit breaker or a blown fuse since the range hood is wired directly to your household electrical system NOTE All work must be performed by a qualified licensed technician 14 Page Installation Diagram Perfekt Glide 24 15 Page Warranty Information AEG Appliances are imported and d
7. ectrical wiring opening in the wall or the cabinet If the hood is to be vented also mark and measure the duct opening in the wall or cabinet Preparation for Duct Connection Remove the appropriate ducting knockout by inserting a screwdriver under one end and prying it up Then snip or break the attachment points Before installing the range hood please first fix the outlet on the air duct hole of the hood Hood Installation Lift the hood to the proper position in the cabinet fix the self tapping screw with washers Follow the middle four holes on the top shelf inside of the hood Caution Do not damage the parts inside the hood Duct connection Connect the ductwork on the hood using duct tape to make joints secure and air tight Power cord length 0 9 1 2m Your new range hood will operate at the highest efficient if the number of elbows and the length of the duct are kept to a minimum 10 Page Controls lamp switch motor switch o The hood is turned on when you pull out the slide o The lamp switch is located on the left side of the hood o The fan switch is located on the right side o The fan has 3 settings off low speed and high speed Specifications Perfekt Glide 24 Power Supply 115V 60Hz Rated Input Power 140W Lighting Power 138W 300 CFM Perfekt Glide 30 Power Supply 115V 60Hz Rated Input Power 140W Lighting Power 138W 300 CFM 11 Page Use and Care
8. istributed in North America by Euro Line Appliances Inc For more information visit www euro line appliances com or contact EURO LINE APPLIANCES INC 2278 Speers Road Oakville ON Canada L6L 2X8 1 800 421 6332 Euro Line Appliances Inc 1 800 ELA WEST Euro Line Appliances West marketing euro line appliances com All AEG Appliances are backed by a comprehensive 2 year parts and labour warranty Information on service and parts available from Euro Parts at 1 800 678 8352 AEG perfekt in form und funktion 16 Page
9. ood with your new AEG Perfekt Glide range hood turn OFF the electrical power to the existing unit before removal Unplug the unit before cleaning or servicing Do not repair or replace any part of the appliance or attempt servicing Note if for any reason this product requires service please contact Euro Parts 1 800 678 8352 When cutting or drilling into wall or ceiling be careful not to damage existing electrical wiring and other hidden utilities Ducted fans must always be vented to the outdoors 2 Page WARNING to reduce risk of cooktop grease fire o Never leave cooking unattended at high settings Boil overs cause smoking and greasy spillovers may ignite Heat oils slowly on low or medium settings o Always turn the hood on when cooking at high heat or when cooking flaming food i e Crepes Suzette Cherries Jubilee Flamb s o Clean ventilation fans frequently Do not allow grease to accumulate on the fan or filter o Use proper sized pans that correspond to the size of the stove and the amount of food being cooked WARNING to reduce risk of personal injury in the event of a cooktop grease fire o Smother flames with a close fitting lid metal tray or baking sheet Then turn the burner OFF BE CAREFUL TO AVOID BURNS If the flames are not put out immediately evacuate and call the fire department NEVER pick up a flaming pan DO NOT use water including west dishcloths or towels to put out a fire A violent steam
10. ools needed for installation O O O O O O 0 O Drill 1 8 drill bit for pilot holes 1 1 4 wood bit for drilling electrical wiring access hole Phillips head screwdriver Flat head screwdriver Pliers Pencil ruler and level for marking range hood location Hand saw or jig saw for cutting the wall or cabinet openings Duct tape Electrical tape Connector clamp 6 Page Selecting the Venting Direction The range hood can be used for either vertical or ductless air discharge It is set up for vertical discharge Vertical Discharge Vertical discharge is the most common method of hood t installation If your kitchen has an attic space above the ducting may be run j through the cupboard and the attic to a roof cap Use a 7 round duct not included Another option if your kitchen has a soffit above the cabinet is to run the duct up into the soffit and then discharge the air horizontally through the outside wall to a wall cap Ductless In ductless installations air is vented back into the kitchen through 4m the opening in the range hood grille If j you do not anticipate heavy cooking this method is preferable Ductless installation requires the use of charcoal filters to remove odors which should be replaced at regular intervals depending on use Check with your local retailer or dealer for replacements Note This filter is not dishwasher Safe If hood is to be installed
Download Pdf Manuals
Related Search