FEISOL Tripod CT-3371 / CT
Contents
1. User Manual gt FEISOL CT 3371 and CT 3471 A Mount and Center Column Installation For exchanging mounts flat Ball Head mount Center Column mount Leveling Base on the tripod unscrew the three counter sunk screws on top of the mainframe using the included Alan key see picture insert desired mount and re tighten the three screws To avoid possible damage to the screws or tripod please do not over tighten them B Leg Tension Adjustment Insert the two hexagonal wrenches included into the two screws at the base of the leg see picture and tighten or loosen them to the desired friction by turning the wrenches in opposite directions 6 F601 ne us WWW FEISOL NET _ C Leg Extension In order to extend a leg section turn the twist lock approximately one half turn in counterclockwise direction Note If the twistlock is turned too far the leg section may fall out and compression rings may become lost or damaged To firmly lock a leg section into place turn the twist lock approximately one half turn in clockwise direction Please do not over tighten D Weight Hook Installation To increase tripod stability during windy conditions a Weight Hook is included allowing for heavier objects backpack weight bags to be attached to the tripod The hook can be screwed onto the bottom plate of the pre installed Center Column see picture 6 F601 ne us WWW FEISOL NET _ E Ball Head optional Installation Wh2. en using the flat mounting plate pre installed on models CT 3372 and CT 3472 screw the Ball Head into the mounting screw by turning the Ball head clockwise until it fits snugly Please do not over tighten When using a Center Column making sure that the Center Column is securely locked screw the Ball Head onto the mounting screw by turning the Ball Head clockwise see picture Please do not over tighten a FEISOL Carbon Fiber Ballhead CB 50DC 6 F601 ne us WWW FEISOL NET _ F Spike optional Installation Remove the rubber caps on the end of the legs by inserting a wooden stick or similar object between the rubber cap and the aluminum ring at the end of each leg see picture By pushing forward around the ring the rubber cap can be removed exposing a thread into which the spike can be screwed and locked tightly into place with the included wrench Once the spike is in place it does not need to be removed again because the metal tip of the spike can be receded into its rubber sleeve when desired for use on scratch sensitive surfaces Please note that damage to your tripod s Carbon Tubes or Aluminum parts can occur when they dropped squeezed overloaded or forced downward eg into sand dunes or snowbanks Please exercise care to avoid such conditions 6 F601 ne us WWW FEISOL NET S
Download Pdf Manuals
Related Search