1. IS 3000 User Manual Making a roll into a poly bag Cut a roll as long as you want Cut the roll considering enough margin up to 6cm more space than the size of the content to be packaged Open the cover and put the roll on the heating line pushing the a buttons on either side until clicking Put the roll on heating line and then close Vacuum sealer cover Insert the power plug to an outlet Put the vacuum sealer IS 3000 on the table and turn on power switch and then put the roll for sealing ELE Se ase rent Tap the sealing button Push sealing button and finish one side sealing of the roll Make sure that the sealing part of the roll is still hot right after the sealing procedure IS 3000 User Manual Vacuuming Put the content to be stored inside the poly bag Please not too much or big to be filled in Upon pushing the vacuum removal button on the both edges of the cover open the cover and take out the sealed bag Put the other side which is not yet sealed in the below part of the chamber and close the cover and tap the both buttons on the both edges in turn until clicking Without pushing the vacuum removal button you cannot open the cover Check out whether the poly bag is tightly sealed or not End of bag should be located in the center of Chamber IS 3000 User Manual Vacuuming Press the automatic button The sealing lamp turns into orange red 2. into green during the vacuuming and sealing Upon turning orange light into green Vacuuming is not yet completed If you would like to stop in the middle of the vacuuming process push the automatic button to halt it and open the cover to rerun the procedure all over again It take up to maximum 45 seconds to vacuum it packaged once and stop automatically after vacuuming process finished Se Pushing the 1 vacuum removal button press the 2 cover release buttons on both ends of above cover and open the cover to take out the poly bag Make sure that the poly bag is entirely sealed