CSM Link for Philips VOI - Manual
Contents
1. CSM Link for Philips VOI Danmeter A S Part number 56 26 00 001 Version 2 The Cerebral State Monitor CSM monitors the level of consciousness of a patient under anaesthesia or sedation The CSM Link for Philips VOI provides the monitor with an EEG wave default on and the following numerics CSI BS default on default on EMG default on SQI default off White sensor impedance default off Black sensor impedance default off HI CSI alarm default off LO CSI alarm default off only valid for CSM SW 2 x and above For further description of the numerics see CSM user manual Note Information in Philips Monitor is delayed a few second typically 3 5s compared to the information in the CSM display due to transmitting the data from CSM to the Philips Monitor Setup Install VueLink AUX Plus Type B as described in Philips M1032A VueLink Module Handbook Set Vuelink to Open interface as described in Philips M1032A VueLink Module Handbook Connect CSM Link for Philips VOI to VueLink module via interface cable M1032 61699 Connect power to CSM Link for Philips VOI It is recommended to connect the power for CSM Link for Philips VOI to the same power as the Philips monitor so the CSM Link for Philips VOI is turned on at the same time as the Philips monitor Turn on the CSM and connect CSM to CSM Link for Philips VOI as described in CSM user manual After a few seconds the da2. lat line in bottom of window No communication between CSM and CSM Link for Philips VOI Establish communication see CSM DFU AUXPLUS CHK Cable Numerics are removed EEG Wave is removed Cable between VueLink and CSM Link for Philips VOI Not connected to VueLink module Connect cable if faulty then replace Vuelnk check setup Numerics are removed EEG Wave is removed No power supply on CSM Link Connect power to CSM Link for Philips VOI VueLnk Check conf Numerics are removed EEG Wave is removed Cable between VueLink and CSM Link not connected to CSM Link Connect cable to CSM Link for Philips VOI Alarms Alarm message What to do indication CSI too low CSI lower than low limit CSI blinking other numerics shown as normal EEG wave as normal CSI too high CSI blinking other numerics shown as normal EEG wave as normal CSI higher than high limit only valid for CSM SW 2 x and above See VueLink INOP Messages in Instructions for use for the actual monitor
3. ta will appear in the Philips Monitor Switching wave and individual numerics on and off To switch the CSI measurement on or off In the setup AUXPLUS menu select CSI to toggle between on and off To switch individual numerics on or off In the setup AUXPLUS menu select actual numeric to toggle between on and off EEG curve The EEG curve shows 6s of processed EEG data EEG range 180uV EEG frequency band 2 35Hz Changing the scale of the EEG wave Changing the scale only changes the visual appearance of the wave It does not affect the signal analysed by the monitor or printed in reports or recordings INOPS INOP Message Indication What to do Sensor Alarm CSM Numerics shown with EEG Wave will be flat line in 0 One or more sensors have no skin contact Replace sensors remember proper skin preparation Patient cable might be disconnected Reconnect patient cable Repl CSM Battery Numerics shown as normal EEG wave as normal Battery in CSM is almost empty replace battery or connect to mains Artifact CSM Numerics shown with EEG wave as normal The measured signal is too noisy to be included in calculations Might be seen when diathermia is used Impedance too high Numerics shown with EEG wave as normal The impedance for one or more sensors is above the valid range Replace sensor remember proper skin preparation Communication CSM Numerics shown with EEG Wave will be f
Download Pdf Manuals
Related Search