Reusable Roof Anchors User Manual
Contents
1. UES R a GID LIFELINES User Instruction Manual r L tie r cS 22 CE CC ISO 9001 2008 Registered 3 m En S 5 lt S E o Le z o A w General Safety Information Under Penalty of Law This User Instruction Manual is not to be removed except by the user of this equipment Current User Instruction Manuals must always be available to the user m Read and understand these instructions before using equipment Do not throw away these instructions Misuse or failure to follow warnings and instructions may result in serious personal injury or death Users must read and understand the User Instruction Manual provided with the product and be properly trained by their employer prior to use per OSHA 29 CFR 1910 66 and 1926 503 or applicable local standards Compliant fall protection and emergency rescue systems help prevent serious injury during fall arrest For instructions about proper use refer to supervisor User Instruction Manual or call Rigid Lifelines at 844 467 4443 Rigid Lifelines Reusable Roof Anchors Manual 844 467 4443 2 Purpose The Rigid Lifelines Reusable Roof Anchor RL 01 A is designed to be used as part of a personal fall arrest system to help limit the forces associated with fall arrest Instructions For Use Personal fall arrest system MUST limit the maximum arrest force to 900 pounds or less Failure to foll2. If this warning is not followed the anchorage connection will be weakened and serious injury or death could occur in the event of a fall Attach to the D ring only with a locking snap hook locking carabiner or other Rigid Lifelines approved connector or connecting device m Anchors must be installed at the roof peak and located a minimum of 5 feet inward from leading edge Additional Rigid Lifelines Reusable Root Anchors RL 01 A may be installed along roof peak as needed m Each Rigid Lifelines Reusable Roof Anchors RL 01 A must be fastened to the roof structure using 16D 3 inch nails Secure the Rigid Lifelines Reusable Roof Anchors RL 01 A to the roof rafter in the center row of holes Remaining outer holes must be secured to the plywood sheathing m Use all holes provided when securing the Rigid Lifelines Reusable Roof Anchors RL 01 A to the structure For installation onto pre existing structures inspect rafters from inside of the building to ensure that the roofing material is structurally sound and not showing signs of deterioration Rigid Lifelines Reusable Roof Anchors Manual 5 844 467 4443 When installed as an anchor point on a flat surface or on one side of a peaked roof the connecting fall arrest subsystem must not extend over the peak of the roof to the other side For work on the opposing roof surface installation of an additional Rigid Lifelines Reusable Root Anchors RL 01 A is r
3. equired on that side Anchor must be positioned to apply load in the long axis of the anchor bracket After removal of the Rigid Lifelines Reusable Roof Anchors RL 01 A roof Surface may require repairs It is the responsibility of the installer to make applicable repairs to the roof materials Training Employers are responsible for providing training to any employee who may be exposed to fall hazards Training will enable an employee to recognize and reduce fall hazards Training must be conducted by a Competent or Qualified Person Trainer and trainees must not be exposed to fall hazards during the training course Inspection If inspection reveals any defect inadequate maintenance or unsafe condition remove from service immediately Any equipment that has been subjected to the forces of arresting a fall must be removed from service immediately Note Only manufacturer or entities authorized in writing by the manufacturer may make repairs to the product Otherwise equipment must not be altered in any way Frequency All equipment must be inspected prior to each use according to the manufacturer s instructions Annual inspections must also be performed by an OSHA defined Competent Person other than the user All equipment should be inspected by a Qualified Person on a regular basis All equipment must be free of corrosion chemical attack alteration excessive heating or extreme wear All markings must be legible a
4. er or invoice number and warranty authorization number after authorized corrections have been made A credit memo will be issued by accounting after the invoice has been received and approved Warranty charges ARE NOT to be deducted trom outstanding open account invoices under any circumstances Any field corrections made prior to an authorization by Rigid Lifelines will not be accepted as a warranty charge or the responsibility of Rigid Lifelines Any modification to the equipment made without prior approval of the seller will void all warranties A verbal authorization for modification may be obtained in which event a warranty authorization number will be assigned for the specific modification A confirming written authorization will be forwarded to the distributor Rigid Lifelines Reusable Roof Anchors Manual 7 844 467 4443 One Year Equipment Warranty Rigid Lifelines warrants all Rigid Lifelines fall protection soft goods devices connectors and accessories to be free from defects in material and workmanship for a period of one 1 year commencing on the date of shipment to the first retail purchaser Purchaser Rigid Lifelines is dedicated to offering superior service and quality products to all of our customers If you would like to contact a customer service representative please call the following number 1 844 467 4443 We will be happy to assist you in any way that we can These warranties do not extend to equ
5. ipment which has been subject to misuse use in excess of rated capacity negligent operation use beyond Rigid Lifelines published service factors improper installation or maintenance adverse environments and does not apply to any equipment which has been repaired or altered without Rigid Lifelines written authorization This warranty is void for any product that is designed to deform or absorb energy during a fall event and needs to be replaced after a fall event has occurred Written notice of any claimed defect must be given to Rigid Lifelines within thirty 30 days after such defect is discovered Rigid Lifelines obligation and Purchaser s sole remedy under this warranty is limited to at Rigid Lifelines discretion the replacement or repair of the equipment at Rigid Lifelines factory or at a location approved by Rigid Lifelines THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES WHATSOEVER WHETHER EXPRESS IMPLIED OR STATUTORY SELLER MAKES NO WARRANTY AS TO THE MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OF THE EQUIPMENT AND MAKES NO OTHER WARRANTY EITHER EXPRESS OR IMPLIED Rigid Lifelines shall not be liable under any circumstances for any indirect special or consequential damages including but not limited to lost profits increased operating costs or loss of production This warranty shall not extend to damages including but not limited to lost profits increased operating costs or loss of production This
6. nd attached to the equipment Cleaning and Maintenance No cleaning or maintenance is required for this product If inspection reveals any defect remove from service and destroy immediately Rigid Lifelines Reusable Roof Anchors Manual 844 467 4443 6 Product Labels Instructions This anchor when installed in accordance with the manufacturer s instructions included at the time of shipment will provide an anchor point at the peak of the roof which is suitable for use with compliant fall arrest systems The roof peak anchor should be used in conjunction with roof bracket walk planks when installing conventional roofing systems on truss rafter and plywood sheathing construction Begin by placing the first anchor along the peak of the roof at a point 5 ft from the beginning of the roof line Additional anchors should be placed no more than every 10 ft with the last anchor 5 ft from the end of the roof line Remove ridge vents when attaching peak anchors Each anchor should be fastened to the roof using 16D 3 inch nails The center row of holes must be secured to the plywood sheathing Use all holes provided in nailing the anchor to the building structure Inspect rafter from the inside structure to ensure the wood is sound and free of RASID ns D0 NOT REMOVE THIS LABEL any deterioration When working on a flat surface the anchor can be installed by extending the two Reusable Roof Anchor flat plates out leaving the D Ring in
7. ng static loads applied in all directions permitted by the fall arrest system of at least 3 600 pounds 16 0 kilonewtons with certification of a qualified person or 5 000 pounds 22 2 kilonewtons without certification This equipment is designed to be used in temperatures ranging from 40 F to 130 F 40 C to 54 C Do not expose this equipment to chemicals or harsh solutions that may have a harmful effect Contact Rigid Lifelines with any questions Rigid Lifelines Reusable Roof Anchors Manual 3 844 467 4443 Use caution when working with this product near moving machinery electrical hazards sharp edges or abrasive surfaces as contact may cause equipment failure personal injury or death Minors pregnant women and anyone with a history of back and or neck problems should not use this equipment Do not use or install equipment without proper training from a Competent Person as defined by OSHA 29 CFR 1926 32 f Only Rigid Lifelines or entities authorized in writing by Rigid Lifelines shall make repairs or alterations to the equipment Connector Compatibility Limitations All Rigid Lifelines equipment must be coupled to compatible connectors OSHA 29 CFR 1926 502 prohibits snap hooks from being engaged to certain objects unless two requirements are met 1 It must be a locking type snap hook 2 It must be designed for making such a connection a Designed for means that the man
8. ow all instructions and limitations on the use of this equipment may result in serious personal injury or death Before using a personal fall arrest system employees shall be trained in accordance with the requirements of OSHA 29 CFR 1910 66 in the safe use of the system and its components Prior to each use inspect all personal fall arrest system equipment for wear damage and other deterioration Defective components must be removed from service immediately in accordance with the requirements of OSHA 29 CFR 1910 66 and 1926 502 Thoroughly evaluate and plan all elements of your fall protection system s before using your equipment Make sure that your system is appropriate for your needs and facility Also be sure to calculate fall clearance and swing fall clearance Users must have a rescue plan and the means to implement it This plan must provide prompt employee rescue or assure that employees have the ability to rescue themselves in the event of a fall Store this equipment in a cool dry and clean environment that is out of direct sunlight when not in use After a fall occurs this equipment must be removed from service and destroyed immediately Limitations For Use Rigid Lifelines Reusable Roof Anchors RL 01 A are designed for a single user including clothing tools etc with a capacity up to 310 pounds 140 kilograms Rigid Lifelines Reusable Roof Anchors RL 01 A must only be used on structures capable of supporti
9. the middle This roof anchor must be visibly inspected before each use and also inspected by a competent person at least every six 6 months from the date of e if roof anchor has any si ks corrosion de purchase Do not us or has any signs of cra bending Meets ANSI Z359 1 2007 A10 14 OSHA 1910 1926 Model RL 01A Anchor Point Must Capacity 310 Ibs withstand 5000 Ibs per User 1 Person Max worker attached nts deformities or DO NOT REMOVE THIS LABEL Service Policy 1 Obtain as much information as possible concerning the problem through personal observation by yourself or other authorized personnel familiar with the job and equipment include model serial and or part numbers voltages speeds and any other special identifying features Be prepared to discuss the situation in detail All authorized labor charges will be based on straight time Hourly rates estimated man hours and not to exceed total dollar amount required for corrections are to be agreed upon before authorization is given There will be no allowances for overtime except in dire emergencies and then only with prior approval A verbal agreement may be reached immediately on both the method of correction and the approximate cost A warranty authorization number will be assigned for the specific incident A confirming written authorization will be torwarded to the distributor The distributor must send an itemized invoice showing our release numb
10. ufacturer of the snap hook specifically created the snap hook to be used to connect to the equipment in question The following conditions can result in rollout when a non locking snap hook is used Avoid the following connections Direct connection of a snap hook to horizontal lifeline Two or more snap hooks connected to one D ring Two snap hooks connected to each other A snap hook connected back on its integral lanyard A snap hook connected to a webbing loop or webbing lanyard Improper dimensions of the D ring rebar or other connection point in relation to the snap hook dimensions that would allow the snap hook keeper to be depressed by a turning motion of the snap hook a LN Rigid Lifelines Reusable Roof Anchors Manual 844 467 4443 4 Rollout A process by which a snap hook or carabiner unintentionally disengages from another connector or object to which it is coupled ANSI Z359 0 2007 Performance Rigid Lifelines Reusable Roof Anchors RL 01 A have a minimum tensile breaking strength of 5 000 pounds 22 2 kilonewtons when statically tested in accordance with the requirements of the ANSI Z359 1 07 standard Part Connection Approximate Standard Number Length Opening Weight Regulation RL 01 A a 2 1 4 in 1 6 lb ANSI Z391 1 07 Installation Fill all holes with 16D 3 inch nails to attach the RL 01 A roof anchor All nails must pass through the sheathing and into a support structure
11. warranty shall not extend to any components or accessories not manufactured by Rigid Lifelines example casters with the exception of the components systems or accessories involved with XSPlatforms and purchaser s remedy for such components and accessories shall be determined by the terms and conditions of any warranty provided by the manufacturer of such components and accessories Rigid Lifelines 730 Hemlock Road Suite 104 aa Morgantown PA 19543 GID Toll Free 844 467 4443 a RoS Local 610 286 8030 FELINES 610 286 6108 RigidLifelines com info rigidlifelines com 2014 All rights reserved Specifications subject to change without prior notice RLL RRA0114V1
Download Pdf Manuals
Related Search