User Manual
Contents
1. USER INSTRUCTIONS 3 Starting up the boiler e Check that the boiler is power supplied and that the gas feed valve placed at the bottom of the boiler is open e Switch on the boiler by using MODE SELECTION BUTTON and select the functioning mode required 4 INFO Menu Press the INFO Button to display the boiler data Once pressed the parameter number will appear on the left side of the display and the associated parameter value will appear on the centre of the display Use and buttons of lll Heating Temperature setting to scroll the list of available data Press the INFO button to exit the display mode The list of available display data is the following Parameter Description doo D H W temperature sensor d01 Outdoor temperature sensor d02 Kd Thermoregulation value d03 Low temperature circuit sensor only with Zone PCB connected USER INSTRUCTIONS 5 Boiler functioning modes SUMMER mode N To switch boiler operation to SUMMER mode press the MODE SELECTION button u 3 fig 1 The boiler will only work for the D H W system the heating system is disabled The SUMMER mode setting of the boiler is signalled by the symbol E lit continuously on the control panel The automatic ignition system will light the burner every time there is a domestic hot water demand In this case the symbol E will flash on2. D H W temperature is regulated by using and buttons of E D H W temperature setting 5 fig 1 e Pressing button reduces the temperature e Pressing button increases the temperature The range of temperature settings for the D H W temperature runs from a minimum of 35 C to a maximum of 60 C USER INSTRUCTIONS 6 Filling the system In order to restore the water pressure of the system open the filling tap R fig 2 and check by means of a pressure gauge M that the pressure of the system reaches the middle part of the green zone which corresponds to 1 2 bar see fig 3 On completion close the filling tap R fig 2 7 Diagnostics Error codes This paragraph contains a list of error codes that the boiler may generate on the display together with the relative indications and the operations that the user can carry out to reset the boiler Code E01 lonisation malfunction Check that the gas valve on the boiler and gas meter are open and that there is gas in the mains supply Press Reset button on the control panel to reset the error When the error code on the display disappears the boiler will restart automatically A If the problem persists Call the Service Centre Code E02 Safety Thermostat tripped GREEN AREA 1 5 bar T a AU 1 2 bar H E wa oea 0 5 bar Press Reset butto
3. ation systems must comply with the requirements of national and local standards regardless of whether the boiler is installed indoors outdoors or in its own cabinet see section Reference standards User general warnings gt gt If there is any doubt as to whether the appliance has been tested by an authorised technician do not attempt to start it All maintenance and gas conversion operations MUST BE CARRIED OUT BY PROFESSIONALLY QUALIFIED PERSONNEL Should any part of the boiler freeze up do not attempt to light it under any circumstances but instead call the Service Centre immediately The appliance s combustion system must be checked every two years This check includes testing the efficiency of the boiler and must be carried out by authorised personnel possessing the qualifications as required by current law Do not obstruct the ventilation openings in rooms where there are gas burning appliances installed boiler cooker etc Do not allow the appliance to be used by persons including children with reduced physical sensory mental capabilities or with lack of experience and knowledge unless they have been viewed or educated on the use of the appliance by the person responsible for its safety or anyone unfamiliar with its operation The installation operation and maintenance manual forms an integral and essential part of the product and must be kept near the appliance always If you smell gas gt g
4. error code on the display disappears the boiler will restart automatically A If the problem persists Call the Service Centre Code E35 Flame detection malfunction Press Reset button on the control panel to reset the error When the error code on the display disappears the boiler will restart automatically If the problem persists Call the Service Centre Code E40 Electric power supply out of the operation range Call the Service Centre Code F08 Frost protection function central heating circuit ON Wait for the completion of the operation Code F09 Frost Protection function D H W circuit ON Wait for the completion of the operation Code F28 Legionella Prevention Function Wait for the completion of the operation 8 Switching OFF the boiler _ K OR To switch the boiler OFF press mom INFO button the word OFF appears on the display The central heating frost protection system remains enabled If the boiler was previously ON it is switched OFF and the fan overrun and pump overrun functions are enabled N B If the boiler is to be left unused for a long period of time the user must do one of the following Make the boiler safe by disconnecting all the power supplies electricity and gas and draining the heating system Leave the boiler in standby leaving the electricity and gas supplies connected and consequently the frost protection fu
5. n on the control panel to reset the error When the error code on the display disappears the boiler will restart automatically A If the problem persists Call the Service Centre Code E03 Air Pressure Switch Tripped Call the Service 4 Code E04 Water Pressure Switch Tripped amp low Centre Check the water pressure in the central heating circuit The reading on the pressure gauge M see fig 2 located on the lower part of the boiler must not be less than 1 2 bar f the pressure is less than 1 2 bar top up the system as described in paragraph Filling the system When the error code on the display disappears the boiler will restart automatically A If the problem persists Call the Service Centre Code E05 Heating Sensor malfunction Call the Service Centre Code E06 D H W sensor malfunction Call the Service Centre Code E18 Inadequate circulation Call the Service Centre 5 USER INSTRUCTIONS Code E21 General malfunction inside the printed circuit board Switch off the power supply at the main switch and then switch it on again When the error code on the display disappears the boiler will restart automatically A If the problem persists Call the Service Centre Code E22 Parameter programming request Switch off the power supply at the main switch and then switch it on again When the
6. nction USER INSTRUCTIONS 9 Frost Protection The boiler is protected from freezing by electronic board settings and special functions that provide the starting of the burner to heat all the interested parts when their temperature drops below the minimum preset values This function is enabled if the boiler is electrically power supplied the gas supply is open the system pressure is that required the boiler is not locked out A In case of boiler parts locked out because of freezing do not switch the boiler ON and immediately call the Service Centre 10 Maintenance In order to ensure that the boiler operates efficiently and safely it is recommended that the appliance is inspected by a suitably competent technician at least once a year A regular maintenance is always source in management system savings 11 Recycling The appliance packaging is mainly made of recyclable materials The symbol indicates the inability to dispose of The appliance and all its accessories must be this product as domestic waste disposed of appropriately differentiated The correct disposal of this product will help to in compliance with the relevant standards prevent potential negative consequences for the environment and people health RADIANT BRUCIATORI s p a Via Pantanelli 164 166 61025 Loc Montelabbate PU Tel 39 0721 9079 1 fax 39 0721 9079279 e mail info radiant Internet h
7. so Heating technology since 1959 User Manual for model RSA 32 25 Wall mounted storage combi boiler premix condensing boiler Technical specification RADIANT BRUCIATORI S p A Monte labbate PU ITALY ENGLISH INDEX General warning pagina 1 Control Panel pagina 2 Starting up the boiler pagina 3 INFO Menu pagina 3 Boiler functioning modes pagina 4 Filling the system pagina 5 Diagnostics Error codes pagina 5 Switching OFF the boiler pagina 6 Frost Protection pagina 6 10 Maintenance pagina 7 11 Recycling pagina 7 o o No aA O NN a USER INSTRUCTIONS BOILER OPERATING INSTRUCTIONS 1 General warning A Make sure that the authorised technician who tested the boiler has stamped the guarantee booklet A The installation first start up regulation and maintenance operations must be carried out exclusively by qualified personnel e g Radiant authorised Service Cenires Incorrect installation can cause damage to property and injury to persons or animals for which the manufacturer will not be held responsible During the installation the technician must carry out the following checks The data on the data plate must correspond to that of the mains supply networks gas electricity water The boiler must be regulated according to its designed use and performance The flue gas exhaust and combustion air intake system must be correctly installed and operational The exhaust gas discharge and ventil
8. t gt gt DO NOT ACTIVATE ANY ELECTRIC SWITCHES TELEPHONES OR ANY OTHER DEVICE THAT MAY GENERATE ELECTRICAL DISCHARGES OR SPARKS OPEN DOORS AND WINDOWS IMMEDIATELY TO CREATE A CURRENT OF AIR THAT WILL RAPIDLY CLEAR THE ROOM CLOSE ALL GAS TAPS AND VALVES CALL FOR PROFESSIONALLY QUALIFIED PERSONNEL USER INSTRUCTIONS 2 Control Panel CONTROL PANEL KEY 1 HEATING TEMPERATURE SETTING BUTTONS 2 INFO BUTTON PRESS ONCE TO DISPLAY TEMPERATURES AND INFO KEEP IT PRESSED FOR 5 SECONDS IN OFF MODE TO DISPLAY THE LAST 5 ERRORS 3 MODE SELECTION BUTTON SUMMER ONLY WINTER ONLY SUMMER WINTER OFF 4 RESET BUTTON ERROR RESET FLUE TEST FUNCTION ACTIVATION CHIMNEY SWEEPER KEEP IT PRESSED FOR 7 SECONDS 5 DOMESTIC HOT WATER TEMPERATURE SETTING BUTTONS 6 TERMINAL BLOCK FOR EXTERNAL WIRING 7 LCD DISPLAY 7 S N _ HBH W bw OF A amp 0 AEN J J i F AVU wv i Fig 1 1 2 3 4 5 6 During the boiler operation the display can show 2 different power levels according to the flame modulation of the boiler see fig 2 50 100
9. the control panel WINTER mode To switch boiler operation to WINTER mode press the MODE SELECTION button 3 fig 1 The boiler will only work for the Heating system The WINTER mode setting of the boiler is signalled by the symbol m lit continuously on the control panel The automatic ignition system will light the burner every time there is a room heating demand In this case the symbol will flash on the control panel SUMMER WINTER mode To switch boiler operation to SUMMER WINTER mode press the MODE SELECTION button L V fig 1 The boiler will work for both central heating D H W systems The SUMMER WINTER mode setting of the boiler is signalled by symbols lit continuously on the control panel The automatic ignition system will light the burner every time there is a room heating or domestic hot water demand The functioning is signalled by the symbols flashing continuously on the control panel Regulating the heating temperature The heating temperature is regulated by using and buttons of Heating temperature setting 1 fig 1 e Pressing Oo button reduces the temperature e Pressing button increases the temperature The range of temperature settings for the central heating runs from a minimum of 30 C to a maximum of 80 C 25 C 45 C for under floor heating systems Regulating the D H W temperature The
10. ttp www radiant it THE TECHNICAL DATA AND MEASUREMENTS ARE PROVIDED FOR INFORMATION PURPOSES ONLY AND ARE NOT BINDING THE COMPANY RESERVES THE RIGHT TO APPLY VARIATIONS WITHOUT PRIOR NOTIFICATION NEITHER WILL THE COMPANY BE HELD RESPONSIBLE FOR ANY INACCURACIES IN THIS HANDBOOK DERIVING FROM PRINTING OR TRANSLATION ERRORS E OEALL RIGHTS RESERVED NO PART OF THIS DOCUMENT MAY BE REPRODUCED MEMORISED IN ANY FILING SYSTEMS OR TRANSMITTED IN ANY FORM WHATSOEVER INCLUDING ELECTRONIC MECHANICAL PHOTOCOPIES RECORDINGS OR ANY OTHER MEANS WITHOUT THE COMPANY S PRIOR WRITTEN APPROVAL RADIANT Heating technology since 1959
Download Pdf Manuals
Related Search