FM-9 Manual - Techni-Lux
Contents
1. until after contacting your dealer for assistance SETUP e Remove all packing materials from shipping box check that all foam and plastic padding is removed especially in the nozzle area e Place fog machine on a flat surface and remove fog liquid tank cap e Fill with fog liquid or other high quality water based fog fluid Any other types of fluid can damage that unit When filled place cap back on liquid tank Techni Lux ELITE fogging fluids are available to create many different types of effects It is highly suggested that you use ELITE fogging fluids for best performance e Firmly attach remote control cable to the proper input on the rear of the machine Labeled REMOTE CONTROL OPERATION e Plug power cord into a grounded electrical outlet If necessary turn power switch on rear of unit to 1 On position warm up is complete when green lamp lights up on remote unit e To emit fog press the appropriate button on the remote for the desired length of time e The remote unit s lamp will cycle on and off as the machine re heats to the proper operating temperature When the unit goes below a particular operating temperature it may stop producing fog output until it reaches its ideal temperature again e For further information on operating your Fog Machine see the section titled Remote CONTROL OPERATION e If your model includes a mounting bracket designed for overhead installation it may be installed at floor level2. or suspended overhead If the unit is to be mounted using the bracket it is important that the fog does not shoot directly at anyone s face Whatever installation method you choose do not allow the unit to have more than a 15 degree angle of inclination Important Always monitor tank fluid level as you are fogging running a fog machine with no fluid can permanently damage the unit If you experience low output pump noise or no output at all unplug immediately Check fluid level the external fuse remote connection and power from the wall if all of the above appears to be OKAY plug the unit in again The pump may make some noise while priming fluid for the first time or if out of fluid If fog does not come out after warm up and holding the remote button down for 30 seconds check the hose attached to the tank to make sure there is fluid going through the hose If you are unable to determine the cause of the problem do not simply continue pushing the remote button as this may damage the unit Return the machine to your dealer REMOTE CONTROL OPERATION FM 10 using remote ZC 2 e ZC 2 10 meter wired multi function remote controller with 5 pin XLR connector Its intuitive LCD enhanced interface provides manual and automatic controls as well as DMX address designation Remote can be used to set the Duration Interval and output fog Volume directly A Techni lux e To use the FM 10 machine via DMX set the start address on the
3. remote digitally It uses 3 channels of standard DMX protocol to control its functions Connect DMX to machine via the DMX IN 3 pin XLR connector located on the back of the unit Pass thru DMX out is provided via 3 pin XLR also DMX CHANNELS DMX VALUES gt gt FUNCTION Ch 1 Duration the on time 0 10 gt gt Off 11 240 gt gt Long to Short 241 255 gt gt Full ON Bump at 100 Ch 2 Output Volume 0 255 gt gt Low to Maximum Ch 3 Interval cycle time 0 255 gt gt Short to Long FM 9 using remote ZC 4 e ZC 4 10 meter wired timer remote on FM 9 provides the ability to set different cycle times Both the interval and duration may be adjusted using the two turn buttons It can operate in automatic timer mode or in manual mode Connection of remote is via a 5 pin DIN connector located on the back of the unit Cleaning your fog machine regularly will help reduce costly part replacement and repair charges and prolong its life Maintenance Do not allow the fog liquid to become contaminated Always replace the caps on the fog liquid container and the fog machine liquid tank immediately after filling After every 40 hours of continuous operation It is recommended to run a cleaning solution composed of 80 distilled water 20 white vinegar through the system to prevent the accumulation of particulate matter in the heating element The recommend cleaning regimen is as follows 1 While unit is unplugged and cool if removal nozzle ty
4. use only Not designed for outdoor use Use 3 prong grounded electrical outlet only Prior to use take care to determine that the unit is installed at the rated voltage Always unplug your fog machine before filling its fluid tank Keep fog machine upright Turn off or unplug when not in use This machine is not water or splash proof If moisture water or fog liquid gets inside the housing immediately unplug the unit and contact a service technician or your dealer before using it again No user serviceable parts inside Refer to your dealer or other qualified service personnel DANGER OF BURNS For adult use only Fog machine must be installed out of the reach of children Never leave the unit running unattended Never aim the output nozzle directly at people Fog machine output is very hot Avoid coming within 60 cm of the output nozzle during operation Locate the fog machine in a well ventilated area Never cover the unit s vents In order to guarantee adequate ventilation allow a free air space of at least 20 cm around the sides and top of the unit Never aim the output nozzle at open flame The output nozzle becomes very hot during operation 300 degrees C Keep flammable materials at least 50 cm away from the nozzle Always allow your fog machine to cool down before attempting to clean or service it DANGER OF EXPLOSION Never add flammable liquids of any kind oil gas perfume alcohol to the fog liquid Pay attention
5. A Techni X FM 9 amp FM 10 FOG MACHINE INSTRUCTIONS Introduction Thank you for choosing a Techni Lux FM series fog machine You now own a powerful state of the art machine Prior to use we suggest that you carefully read all of the instructions By following the suggestions found in this user manual you can look forward to the reliable and satisfactory performance of your fog machine Fog machines are to be used to create a safe smoke effect and provide a medium for lighting to be enhanced Different fog effects may be created by using different types of water based fog fluid formulas The fluids used must be compatible with this machine Never use in a confined or non ventilated area THIS MACHINE IS DESIGNED TO USE WATER BASED FOG FLUID ONLY Specifications MODEL FM 9 FM 10 VOLTAGE 110V 125V 60Hz 110V 125V 60Hz POWER 1000W 1500W FUSE 10A 125V 15A 125V WARMUP SMIN 15MIN TIME SPRAY 5M 10M DISTANCE OUTPUT 15000 cuft min 25000 cuft min TANK 1 5L 6L CAPACITY SIZE L415XW217XH145mm L620XW300XH210mm WEIGHT 8 0Kg 15 0Kg Attached Controller FM 9 FM 10 ZC 1 NO NO ZC 2 NO INCLUDED ZC 3 NO NO ZC 4 INCLUDED NO DMX NO ON PC BOARD ADAPTOR Please follow these operation safety and maintenance instructions to ensure a long and safe use of your fog machine CAUTION Danger of electric shock A Techni lux Keep this device dry For indoor
6. pe unscrew nozzle at very front of unit and clean out debris with vinegar and a pipe cleaner making sure that the hole is free of any clogging 2 Empty all fog fluid from machine Rinse tank with clean water Add above cleaning solution to tank Plug unit in and begin warm up 3 Run unit in a well ventilated area until tank is empty 4 Replace nozzle 5 Cleaning is now complete refill with fog liquid Notes All fog machines are prone to clogging due to the thick consistency of fog fluid and the high temperature at which it vaporizes However a properly maintained fog machine should provide an extended term of reliable use Keeping the fluid container clean will also help prolong fog machine life Clean with a dry cloth only Store in dry place Before storing for a long period of time run distilled water through it Save these instructions
7. to all warning labels and instructions printed on the exterior of your fog machine Use only the high quality water based fog liquid that your dealer recommends Other fog liquids may cause clogging or spitting which could also cause slippery floors Techni Lux ELITE Fogging Waterbased fluids are highly suggested Always make sure there is sufficient liquid in the fog liquid tank Operating this unit without liquid will cause damage to the pump as well as over heating of the heater If your fog machine fails to work properly discontinue use immediately Drain all fog liquid from the tank pack the unit securely preferably in the original packing material and return it to your dealer for service Always drain tank before mailing or transporting this unit Never drink fog liquid If it is ingested call a doctor immediately If fog liquid comes in contact with skin or eyes rinse thoroughly with water UNPACKING amp INSPECTION Open the shipping carton and verify that call equipment necessary to operate the system has arrived intact refer to features section for information on what items are included with your model If any equipment is missing contact your dealer immediately Before beginning initial setup of your fog machine make sure that there is no evident damage caused by transportation In the event that the unit s housing or cable is damaged do not plug it in and do not attempt to use it _ ZO Techni lux
Download Pdf Manuals
Related Search