"user manual"
Contents
1. 512 Use the and button to adjust the DMX address which can be set from 1 to 512 Note 1 5 When the unit is under Ready To Haze state press the 4 button four times the LCD screen will show DOOR SENSOR ON It means that the sensor on the hazer outlet door is activated At this state press the button to switch off the function of this sensor After switching off the door sensor DOOR SENSOR OFF p YoRUME will be shown on the LCD screen Press the button to switch on the sensor again Note 2 6 When the unit is under Ready To Haze state press the button five times the LCD screen shows Direct Haze The unit can enter Direct Haze mode by pressing the button once Under this mode hazer can start to produce haze directly by switching on the power When the unit is in this mode the LCD screen will flicker slowly When LCD screen shows Direct Haze by pressing the button once can leave Direct Haze mode After leaving this mode the LCD screen will stop flickering Note 1 The control of the master unit will override the control of the panel controller when connecting the haze machine via DMX Note 2 When the hazer is under DOOR SENSOR ON mode if the haze outlet door is not opened properly and user try to make the hazer work the buzzer will beep to warn and DOOR CLOSED will be shown on the flickering LCD screen and hazing working will be stopped until the door is open firmly On the other hand if2. tank and contaminate the haze liquids Please do not allow magnetic equipments to be close to the haze outlet door of hazer Magnetic equipment could cause wrong action of the door sensor 5 Control panel operation There are 6 buttons on the control panel runeron Function button Up Down button Timer button 5 gt m Volume button The function and operation of the controller is as following 1 When switching the Haze 500 FT PRO on the characters Ready To Haze will be displayed on LCD screen button again will cease hazing and the LCD screen will display Ready To Haze Under Ready To Haze mode to keep pressing the button can make the hazer produce haze LCD screen shows Working while releasing the button will stop hazing LCD screen shows Ready To Haze Finally under this mode press button the timer will be triggered 2 When the unit is under Ready To Haze state press the J button once the LCD screen shows Interval Set Use the and button to adjust the interval of timer which can be set from 1 to 200 seconds 3 When the unit is under Ready To Haze state press the button twice the LCD screen shows Duration Set Use the and button to adjust the duration of timer which can be set from 1 to 200 seconds 4 When the unit is under Ready To Haze state press the button three times the LCD screen shows DMX
3. Before beginning initial setup of your ROBE Fog Machine make sure that there is no evident damage caused by transportation In the event that the unit s housing or cable is damaged do not plug it in and do not attempt to use it until after contacting your ROBE distributor for assistance 4 Operation and filling Haze liquid 1 Place the unit on a flat surface Plug power cord into a grounded electrical outlet 2 Remove the fluid tank cap and pour the Robe Haze liquid into the tank slowly and carefully Fill with only an original liquid recommended by ROBE distributor Filling suggestion please add 2 litres haze liquid in the first time of refill Since second refill add 1 litre haze liquid for every refill Make sure the liquid level does not exceed the mark on the tank 3 Please refill haze liquid slowly Otherwise the haze liquid may overfill and damage machine Basically every refill process of 1 litre haze liquid must be separated into 5 times It means after refilling about 200c c haze liquid you have to stop refilling and check the tank Usually it takes about 10 seconds for 200 c c haze liquid to go through the filter 4 Please open the square door on the top of the flightcase before operation in order to let the haze come out smoothly 5 Set the power switch to ON on the control panel of the machine Make sure to that the red indicator light is on 6 There is an intake hole in the back of the flight case There are a met
4. HAZE 500 FT PRO _ USER MANUAL F Tse ries Version 1 2 ROBE Lighting s r o e Czech Republice www robe cz HAZE 500 FT PRO Table of contents Introduction Cautions Unpacking amp Inspection Operation and filling Haze liquid Control panel operation Maintenace and storage Technical specifications NOO RO DND NOOO R R 1 Introduction Thank you for choosing an ROBE HAZE 500 FT PRO You now own a rugged and powerful state of the art machine Prior to use we suggest that you carefully read all of the instructions By following the suggestions found in this user manual you can look forward to the reliable and satisfactory performance of your ROBE HAZE500 FT PRO machine for years to come Please follow these operation safety and maintenance instructions to ensure a long and safe life for your fog machine 2 Cautions Risk of electric shock Disconnect the appliance from the electric supply before removing the cover Keep this device dry For inside use only Not designed for outside use Prior to use take care to determine that the unit is installed at the rated voltage Always unplug your ROBE HAZE Machine before filling its tank Keep fog machine upright Unplug the machine when not in use This machine is not water or splash proof If moisture water or fog liquid gets inside the housing immediately unplug the unit and contact a service technician or your ROBE dist
5. al net and a filter attached on the intake which can avoid the unit from clogging problem Please inspect and clean the metal net and filter periodically WARNING Use of any liquid other than original liquid recommended by ROBE distributor or modification or attempted to unauthorized repair of the HAZE500 FT PRO will immediately invalidate the warranty Always monitor and make sure there is sufficient haze liquid inside the tank during operation When the machine is operated for a longer period of time under open air conditions falling dust debris might attach to the metal net and filter on the intake hole The metal net and filter is serviceable which means those can be detached easily by screw driver Please use water to clean the metal net and periodically By doing this can avoid dust going into the hazers and prevent the clogging problem of hazers If you have followed the above operation steps and you still experience low output mechanical noise or no output at all unplug the unit immediately from the mains Check the fluid level the external fuse and the power cable from the wall If all of the above appears to be OK plug the unit in again If the hazer still does not function discontinue operation or it may result in permanent damage to the unit Please detach the cap on the tank if you want to clean the cap Do not wipe directly when the cap is attached on the tank By doing this you can avoid the dust fall into the fluid
6. hazer is under DOOR SENSOR OFF mode above situation will not occur ever mix oil based and water based hazer liquids Before switching the kind of hazer liquid in use ompletely drain the hazer s tank to avoid mixing 6 Maintenace and storage DANGER Disconnect from the mains before starting any maintenance work Do not allow the fog liquid to became contaminated Always replace the caps on the fog liquid container and the fog machine liquid tank immediately after filling Do not operate the fog machine without liquid at any time Clean with a dry cloth only Store dry Cleaning your fog machine regularly will help reduce costly replacement and repair charges 7 Technical specifications Power 230 240V AC 50 60 Hz or 100 120 V AC 50 60 Hz optionally Power consuption 500 W Tank capacity 2 5 Liter Output 3 000 cu ft Min Liquid used Premium Haze Fluid cons rate 20Hrs Liter DMX connection 5 pin XLR male female Dimensions mm L 490 x W 351 x H 338 mm Weight empty tank 31 5 kg Version 1 2 January 31 2011 Specifications are subject to change without specification 7
7. ributor before using it again Danger of Burn No user serviceable and modifiable parts inside Do not disassemble the housing and do any modification otherwise damage of the device or danger of burn may be caused For adult use only Hazer must be installed out of the reach of children Never leave the unit running unat tended Position the haze machine in well ventilated area Please leave about 20cm spaces surrounding the ma chine Never aim the machine at open flames or close to flammable items Never add flammable liquids of any kind oil perfume gas to the hazer liquid Use only distributor recommended ROBE high quality hazer liquid Please do not use any other liquid which may cause erosion of inner parts If your Haze 500 FT Pro fails to work properly stop using immediately Drain all hazer liquid from the tank pack the unit securely preferably in the original packing material and return it to your ROBE distributor for service Please note before sending the machine for transporting purpose make sure the haze fluid tank is empty Never drink haze liquid If it is ingested call a doctor immmediately If hazer liquid comes in contact with skin or eyes rinse thorougly with water Pay attention to all warning labels and instructions printed on the exterior of your HAZE 500 FT PRO 3 Unpacking amp Inspection Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact
Download Pdf Manuals
Related Search