Inspire Installation & User Manual
Contents
1. Ensure the heater is firmly secured to the fixing plain to prevent it from falling forward Use a suitable fireguard to protect both the infirm and young children who could come into contact with the heater DO NOT COVER Appliance Data Supply Voltage 230V ac 50Hz Fuse Rating 13 Amp Heating Element 2 x 500W Mains Cable 1 x 1 8M PVC 1mm2 Illumination 2 x 20W Low Energy Bulb The Flavel Electric Heater is manufactured by CFM Europe Limited Trentham Lakes Stoke on Trent Staffordshire ST4 4TJ Installation Requirements The Flavel Electric heater is supplied with a moulded three pin plug 13 Amp and approximately 1 8 metres of flexible mains cable 1mm3 The appliance and surround should therefore be located close to a suitable mains socket to enable connection The electrical socket MUST be easily accessible to allow disconnection This heater MUST be earthed If in any doubt consult a suitable competent person Connections L Brown N Blue E Green Yellow Replacement fuses should be approved and conform to BS 1362 The rating plate is located at the bottom of the product alongside the on off switch The model number and serial number of the product will be required when booking a service visit Before use ensure that the supply voltage matches that marked on the appliance The mains cable should be routed from the heater to the socket connection without being trapped or being liable to damage If the2. supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid hazard The heater is suitable for fixing directly onto a wall by using the supplied hanger D B A E Dimensions 615 910 145 300 min shelf height 250 min from floor moou gt Unpacking The Appliance The Flavel Electric heater is supplied in a single pack carton All Instructions should be read prior to unpacking or installing the appliance Ensure all parts including loose items have been removed prior to discarding the packaging Product Checklist 1 off Flavel Electric Heater Main Body 1 off Remote Control Handset with Battery 1 off Trim Assembly in polythene bag 1 off Mounting Hanger 1 off Fixing Kit 1 off Instruction Guarantee Literature 2 off Pebble Pack 2 off Infill Panels supplied with 4 off fixing screws Appliance Fixing The heater must be fixed to a suitable wall using the mounting hanger provided Heater Assembl Laying the Pebbles Before assembling the trim to the appliance lay the pebbles onto the plastic front form to give the best decorative effect Trim Assembly Locate the hooks on the trim to the hook bracket on the top front ofthe appliance Place the 6 magnets onto the base section of the trim as shown below Position of 6 off _ AA magnets Fitting the Trim Infill Panels Locate the trim infill panels to the left hand and
3. ECTRICAL SUPPLY IF INDOUBT SEEK THE ASSISTANCE OF A SUITABLY QUALIFIED PERSON It is advisable to use genuine Flavel replacement parts available from your supplier or direct from CFM Europe Ltd Contact details on the rear of this booklet Bulb Replacement Disconnect the appliance from the mains supply Remove the decorative trim assembly Remove the pebble and emberbed Removable panel Remove the removable panel by unscrewing the 4 screws Remove the coloured filter from the bulb and release the bulb from its housing Re assemble in reverse order Spare Parts List 20W energy saving bulb B 62450 Pebble pack B 81770 Coloured filter B 84560 CONTACT INFORMATION Technical Queries 01782 339000 Service Fault Enquires 08700 101187 The Following Information May Be Required When Contacting Flavel For Advice Address Postcode Model No Serial No Fault The products serial number and model number can be found on the rating plate which is affixed to the bottom L H side of the front panel behind the ashpan cover Due to our policy of continual improvement and development the exact accuracy of descriptions and illustrations cannot be guaranteed Part No B 94650 Issue 2 FLAVELL CFM Europe Ltd Trentham Lakes Stoke on Trent Staffordshire ST4 4TJ Telephone 01782 339000 www cfm europe com
4. FLAVEL INSTALLATION AND USER INSTRUCTION GUIDE Inspire Model No s FWR OR FWR ER Denotes fuel effect type and trim colour Denotes trim type 0 Denotes UK model E denotes European model Electric Heater This guide should be used to install and care for your Flavel Electric heater Read all information carefully prior to installation and use Installation IMPORTANT Please read the instructions below before installation or use of this Flavel Electric Heater NEVER use this heater where it may come into contact with water i e bathroom shower room kitchen NEVER leave unsupervised children where the heater is left switched ON or is left unguarded NEVER use this heater beneath a fixed socket outlet NEVER cover or obstruct the fan outlet as this will cause the appliance to overheat NEVER install the heater close to combustible materials i e curtains or similar Allow a minimum of one metre around the heater NEVER route the mains cable beneath carpet NEVER use aerosols or similar close to the heater NEVER use the heater to dry clothes or similar NEVER use the heater by means of an automatic control or timer as this may cause risk of fire if the heater is moved or covered NEVER fit the heater directly onto carpet or similar material It should be fitted onto a suitable non combustible hearth The appliance MUST be disconnected from the mains supply before commencing cleaning or maintenance
5. right hand sides of the trim and secure to the trim with the screws provided 2 off screws to left hand side and 2 off screws to right hand side Infill Panel Operation Of The Heater Fire on flame effect only reer Low heat on off High heat on off The heater is operated via the use of a remote control handset A master ON OFF switch it situated underneath the appliance on the left hand side This is used to turn the appliance completely off Switch Marking Operation Master ON OFF O On Off Depress to this supplies power to the appliance and places it in a standby mode All further operations are carried out by using the remote control handset a Ensure that the appliance is plugged in and switched on b To turn fire on press the fire on flame effect button c For low heat ensure that the flame effect is on and then press the low heat button once To turn the low heat off press the low heat button a second time The fire will now be running with flame effect only d For high heat ensure that the flame effect and low heat settings have been switched on then press the high heat button The high heat button will only work if the flame effect and low heat have already been switched on To turn high heat off press the high heat button a second time The fire will now be running with low heat e To place the fire in a standby mode at any time press the fire off button IMPORTANT Safety C
6. ut Out This appliance is fitted with an automatic safety cut out This operates if the air outlet at the top of the product becomes covered or blocked This will prevent the fan heater from operating In order to RESET the appliance the following procedure should be followed Switch OFF the appliance and disconnect the appliance from the mains supply Leave the appliance disconnected for a MINIMUM of 10mins Check the appliance is free from all obstructions and remove safely Switch ON the appliance at the mains supply socket Operate the appliance as shown on the previous page If the appliance fails to operate repeat the above procedure ENSURING the appliance is disconnected from the mains supply at the wall socket If after repeating this procedure the appliance fails to operate CHECK the fuse within the wall socket plug If after carrying out both of the above procedures the appliance still fails to operate then call a suitably qualified person or CFM Europe Ltd Service Centre on the number shown on the rear cover of this booklet Care and Cleanin Always disconnect the appliance from mains supply and allow to cool before any cleaning operation begins Metal painted parts may be cleaned using a clean damp cloth Never use any abrasive cleaners and chemical agents as damage may occur to the paint finish Maintenance WARNING BEFORE CARRYING OUT ANY MAINTENANCE ENSURE THAT THE APPLIANCE IS DISCONNECTED FROM THE MAINS EL
Download Pdf Manuals
Related Search