HyperJet RC Helicopter™
Contents
1. the direction stick right After approximately 8 seconds the helicopter should be synced with a steady red light on both the helicopter and the remote control As with any aircraft this is a precision flying machine Treat it well and enjoy all the fun it has to offer flight after flight Included Parts Helicopter Remote Control Push up on the left control throttle stick To Fly Upward Open the cover to the battery case and insert 6 AA batteries according to indicated polarities Pic 1 Close the cover Each transmitter can operate on 1 of 3 frequencies The band selector on the front of the transmit ter is the means by which you select the frequency The helicopter will detect the frequency that the controller is set to For example if the controller is set to band A then the helicopter will automati cally detect that frequency Battery cover TE l F b Avoid using near other remote control toys c Avoid direct sunlight in flight area T T p O Pic 1 Helicopter Remote Control 6 pcs AA batteries PROTOCOL2. to offer We strongly recommend that you take the time to read this manual thoroughly It contains many tips and instructions on how to get the most out of this aircraft and maintain it for long life A Fly this helicopter in an indoor environment with calm air conditions Beware of air circulation from an air conditioner or fan B It is recommended to fly this helicopter in a space over 20ft wide x 20ft long x 10ft high C Please keep the flying space clear of objects such as fans lamps etc Please keep the helicopter clear of other people as you are flying it Flying Your Helicopter c irous esnpoNng To Fly ao oL Push down on the left DA Py 1 Rotors won t move Downward Land Epa control throttle stick 5 igi a Make sure the power switch is on b Recharge the battery 2 The helicopter suddenly stops and crashes in mid flight a Recharge the battery Turning on the Helicopter N a 3 The helicopter isn t responding to the remote control Place the helicopter on the ground with the tail pointing towards you and the nose facing away To Fly Left oe Move the direction stick left Lele 6 a Reset the A B C selector to the correct band from you Make sure the transmitter is OFF Set the throttle to MINIMUM Turn the transmitter to ON Then set the ON OFF switch on the helicopter to ON and the power indicator will flash a red light Push the throttle all the way up and then all the way down To Fly Right ee Move
3. will affect its lift off Slowly increase the throttle Rotating counter clockwise DO NOT look at the transmitter but focus on the helicopter As soon as the helicopter leaves the ground reduce the throttle slightly GENTLY add the throttle if the helicopter goes down too far Flight Adjustments and Safety Precautions GENTLY reduce the throttle if helicopter goes up too high For turning give short and small inputs to the direction stick Most beginners will over control the helicopter Power indicator Direction stick Power switch Please read the entire User s Manual before using your helicopter Please use your helicopter only as described in this manual Please keep small parts out of the reach of small children Supervise the charging of the battery to avoid overheating Do not dispose of LIl Polymer battery in fire or flame Keep face fingers eyes hair and loose clothing clear of rotors when in use Do not make changes to the circuit board Replace batteries after long periods of disuse Avoid rough or crash landings as they can damage the helicopter and shorten its lifespan Throttle stick Trimmer Charging indicator Flight Environment Using Your Controls Cover and charging wire Thank you for your purchase of Protocol s HyperJet RC Helicopter You are about to experience Band selection the best of what remote control flight has
4. 6182 2M HYPERJET_IM Instruction Manual for HyperJet RC Helicopter Stabilizer Please read instructions before flying helicopter AGES 14 Charging the Batiery If flying more than one helicopter simultaneously make sure that the transmitters and helicopters Flight Adjustments Warranty are paired to ensure that they detect different frequencies LIMITED WARRANTY Main rotor blade Connecting shaft Main rotor blade iy Tail rotor Charging through the Transmitter A Turn the transmitter on B The cover to the charging wire is located on the front of the transmitter Pull out the charging wire and plug into the slot on the helicopter as indicated in Pic 2 C The green charging light on the transmitter will turn on to indicate the helicopter is charging The helicopter will be fully charged after approximately 30 minutes for approximately 6 minutes flying time D The green charging light will turn off once the helicopter is fully charged The first pilot sets desired frequency on their transmitter and turns it on The first pilot then turns on their helicopter The second pilot sets desired frequency on their transmitter and turns it on The second pilot then turns on their helicopter The third pilot sets desired frequency on their transmitter and turns it on The third pilot then turns on their helicopter 1 If the helicopter rotates clockwise in fli
5. ght push and release the left side of the trimmer repeatedly see diagram until the helicopter flies straight At Protocol we re dedicated to bringing you innovative and well designed products that make living fun and easy We stand behind all of our products and warrant this to be free from defects in workmanship and materials for 30 days from the date of purchase The warranty does not cover transportation damage misuse accident or similar events Specific legal rights pertaining to this warranty may vary by state CAUTION Do not fly multiple helicopters in a small room or cramped location Make sure there is plenty of space for all helicopters 2 If the helicopter rotates counter clockwise in flight push and release the right side of the Lift Off Procedure trimmer repeatedly see diagram until the helicopter flies straight For service claims or questions please consult our website ProtocolNY com Recharge the battery when the helicopter cannot lift any higher than 12 foot off the ground q p Charging Through USB if provided 1 Place the provided USB wire into the USB port on the computer and insert it into the charging slot on the helicopter The wire will light up 2 Charging time is approximately 30 minutes 3 The light on the USB wire will turn off once charging is complete Place the helicopter on a smooth surface Uneven floor surface
Download Pdf Manuals
Related Search