INFRARED Electric Stove User Manual
Contents
1. at least 3 3 feet 1 meter from the front and sides of the unit Do not use this unit in areas where gasoline paint or other flammable liquids or their associated vapors may be present 4 Do not use this unit for drying any wet objects such as clothes toys etc 5 Do not operate the unit if it is damaged or has malfunctioned For indoor use only Do not use or install this unit in areas prone to dampness or where it may come in contact with water This unit is not intended for use in bathrooms laundry areas or other locations where water may be present 8 To reduce the risk of fire do not place or install this unit in areas where the ventilation or circulation ducts may become blocked Do not use on soft surfaces like a bed where openings may become blocked Make sure there are at least 4 10 15 cm of space between the back of your heater and the wall Keep a minimum distance of 2 5 08 cm on each side of your heater free 9 Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater 10 The unit s power cord must be connected to 120V outlet To reduce the risk of fire avoid running the power cord under rugs carpets etc Keep the power cord away from high traffic areas where it may pose a tripping hazard 11 Alway plug heaters directly into a wall outlet receptacle Never use with an extension cord or relocatable power ta2. household glass cleaner The front glass panel should always be completely dried with a lint free cloth or paper towel Storage When not in use unplug the unit from the power supply and store it in a dry dust free location CAUTION DO NOT USE ABRASIVE CLEANERS ON THE GLASS PANEL DO NOT SPRAY LIQUIDS DIRECTLY ONTO ANY SURFACE OF THE UNIT WARNING AN AUTHORIZED SERVICE REPRESENTATIVE SHOULD PERFORM ANY OTHER SERVICING TROUBLESHOOTING WARNING Turn off the appliance unplug and let cool for at least 10 minutes before attempting to service Only a qualified professional should attempt to service or repair the appliance IF YOU EXPERIENCE DIFFICULTIES PLEASE DO NOT RETURN THIS PRODUCT TO STORE For assistance with this appliance please call our customer service department PROBLEM POSSIBLE CAUSE SOLUTION Turn all controls off unplug the appliance allow to cool for at least 10 min plug back in and restart 1 Turn all controls off unplug the appliance allow to cool for at least 10 min plug back in and restart 2 Reset house circuit breaker Turn all controls off unplug the appliance when the button allow to cool for at least is pushed to 10 min plug back in ON and restart 1 Dimmer control knob No warm air is Coming from the heater The overheat protection device in the appliance has been triggered The appliance turns off and will not turn back on 1 The overheat protection device
3. or to products used commercially This warranty does not cover light bulbs The duration of all implied warranties on this particular purpose are limited to the one 1 year duration of the express warranty period specified above Inno event will A G l be liable for any incidental or consequential damages including loss of profits arising from the use of this product Some jurisdictions do not allow limitations on how long an implied warranty lasts or do not allow the limitation or exclusion of incidental or consequential damages so these implied warranty limitations may not apply to you This limited warranty gives you specific legal rights You may also have other rights which vary from jurisdiction to jurisdiction Repair or replacement at A G l s option of a defective product is your sole remedy under this limited warranty In no event will A G 1 s maximum liability exceed the purchase price of the product paid by the consumer purchaser Any legal action taken as a result of any alleged breach of this limited warranty or arising out of any use of this product must be commenced in the State of California A G l makes no other additional warranties express or implied with respect to this product or its component parts except those express limited warranties described above No dealer of this product nor any retail establishment selling this product has any authority to make any warranties or to promise remedies in addition to or inconsistent with
4. those stated above If replacement parts are needed or to obtain performance of any obligation under this limited warranty phone A G s Customer Service Department prepared to provide evidence of purchase date and proof of purchase model number of your A G l product part number and defective part You must pay all expenses incurred in obtaining performance of any obligation under this limited warranty including transportation postage and other incidental service costs If defective part or parts are requested by Customer Service Department you must make the product available to us free and clear of all liens and other encumbrances A G l reserves the right to change prices specifications and designs and to discontinue models without notice and without incurring obligations NOTES NOTAS
5. EA1105J if you are assembling this unit for someone else give this manual to him or her to read and save for future reference KID Intertek 4001358 IMPORTANT SAFETY INSTRUCTIONS CAUTION BEFORE OPERATING THIS EQUPMENT PLEASE READ THESE STRUCTIONS CAREFULLY READ ALL INSSTRUCATIONS BEFORE USINGTHIS APPLIANCE 1 Before permanently placing your stove plug it into a convenient outlet to verify that the circuit breakers for the outlet are on 2 1 he heater may emit a slight harmless odor when first used This odor is normal and is caused by the initial heating of internal heater parts and will not occur again 3 If your electrical heater does not emit heat consult your owner smanual for further information A CAUTION _ RISK OF ELECTRICAL SHOCK DO NOT OPEN NOUSER SERVICEABLE PARTS INSIDE Y _ SA1965 HIGH TEMPERATURE SA1965 KEEP DRAPERY AND OTHER FURNISHINGS AT LEAST 3 3 FEET 1 METER FROM THE FRONT AND SIDES OF THE ELECTRICAL HEATER WARNING 1 RISK OF FIRE KEEP COMBUSTIBLE MATERIAL AWAY FROM THE FRONT OF THE ELECTRICAL HEATER 2 SERVICING SHOULD BE DONE ONLY WHILE THE ELECTRICAL HEATER IS DISCONNECTED FROM THE POWER SUPPLY SPECIAL CHARACTERISTICS A The smoldering glow of the flames can hardly be distinguished from that of a real fire This heater is ideal for use all year rou
6. a licensed electrician to complete any such work WARNINGS AND RECAUTIONS IMPORTANT SAFETY NSTRUCTIONS This symbol alerts you to potential hazards that can kill yt you and or others MN DANGER You can be killed or seriously injured if you don t immediately follow instructions All safety messages will tell you what the potential Hazard ls tell you how to reduce the chances of injury andtell you what can happen if the instructionsare not followed IMPORTANT SAFETY INSTRUCTIONS WARNING WARNING WHEN USING THIS PRODUCT W BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING THE FOLLOWING heater As with any electrical appliance and particularly with electrical heaters basic precautions must be followed in order to reduce the risk of fire burns electrical shocks and or other serious injuries or death Read all the instructions in your User s Manual before using this WARNING ANY OTHER USE RECOMMENDED OR DESCRIBED IN YOUR OWNER S MANUAL MAY CAUSE FIRE BURNS ELECTRICAL SHOCKS AND OR 2 The unit can become hot when in use To avoid accidental burns do not allow bare skin to come in contact with the hot surfaces of the unit EXTREME CAUTION IS NECESSARY WHEN THE HEATER IS LEFT OPERATING AND UNATTENDED KEEP CHILDREN INVALIDS AND PETS AWAY FROM THE UNIT WHEN IN USE 3 Keep combustible materials such as curtains drapes furniture pillows clothing linens bedding paper etc
7. ed on the front of the heater See Fig 1 A CAUTION TO AVOID INJURY AND OR DAMAGE ALWAYS OPERATE THE Heater Heater Low Heater Fig 2 DOOR SLOWLY TO THE OPEN AND Power Switch High CLOSED POSITION Switch b Flame Adjust FLAME OPERATION 1 To switch the flame effect of your heater flip the power switch on You will know that you have power when the flame effect is on 2 To adjust the brightness of the flame effect turn the left handed dial from bh Low to High until it ul reaches the brightness you desire controllable dimmer knob HEATER OPERATION Refer to Fig 2 1 Open the door of the unit to locate the control panel 2 Ensure the power switch is on You will know that you have power to the heater when the flame effect is on 3 Flip the second rocker switch to the right marked I This switch gives you 900W of power to your heater This switch is for low level heating For high level heating make sure that both and II rocker switches are on MAINTENANCE Tools Required Philips Screwdriver 1 JE REPLACING THE LIGHT BULB A WARNING THE UNIT MUST BE UNPLUGGED MN FROM THE POWER SUPPLY PRIOR TO ANY MAINTENANCE OR CLEANING IN ORDER TO REDUCE THE RISK OF ELECTRIC SHOCK OR FIRE CAUTION SHARP EDGES This comes with the following light bulb 2x 40W E12 Chandelier Light Bulb Candelabra Base See Fig 3 Fig 3 Replace this bulb only with identical
8. in the appliance has been triggered 2 House circuit breaker has been tripped The appliance does not turn on The overheat protection device in the appliance has been triggered 1 Turn knob clockwise is toincrease light set too low 2 Inspect light bulb and replace if necessary 2 Light bulb is burnt see Maintenance out section of this manual 3 Flame wand has 3 Remove screws come holding back access loose from bracket panel in place and remove back acess panel Secure end of flame wand back into the support bracket Flame is dim or not present 4 Flame wand motor is not functioning 1 YEAR LIMITED WARRANTY Each and every product that we manufacture is tested prior to being shipped to retail stores However certain damages can sometimes occur during transportation The following non transferable limited warranty is extended only to the original consumer purchaser of this Allen Group Int l Inc A G l product This product is only warranted against defects in material and workmanship subject to the normal and reasonable use and correct assembly if assembled by the consumer purchaser of the product for a period of one 1 year from the date of purchase This warranty does not apply to the normal wear and tear or to any failures or operating difficulties due to accidental damage abuse misuse alteration misapplication careless handling improper installation improper maintenance
9. nd even when central heating has been turned off B This heater produces a hot current of air UNPACKING AND INSTALLING THE ELECTRICAL HEATER 1 Open the packaging carefully and remove the heater 2 Remove and discard the plastic bag 3 BE RESPONSIBLE HANDLING THE PACKING MATERIALS WARNING KEEP PLASTIC WRAPPING AWAY FROM CHILDREN 4 Keep the original packing for future transport and or storage 5 Keep the front of the unit through which the heat is radiated at least 3 feet 0 9 meter away from furniture curtains and other flammable objects materials at all times 6 Ensure there is a grounded socket nearby back of the appliance 7 The power cord must remain at the back of the appliance and must not be in contact with any hot element REPLACEMENT LIGHT BULB CAUTION REPLACEMENT SHOULD ONLY BE DONE WITH E12 TYPE CHANDELIER LIGHT BULB CANDELABRA BASE RATED 120V 40W MAXIMUM NOTE A dedicated power circuit is recommended for the unit but not required Additional appliances on the same circuit may exceed the current amperage rating for that circuit If after the installation of your unit the circuit breaker trips or the fuse fails on a repeated basis then a dedicated circuit will likely be required Any new wiring must be done in compliance with local and national codes and other applicable regulations in order to reduce the risk of fire electrical shock or other injuries It is strongly recommended that you hire
10. nit from the box Prior to installing the unit test to make sure the unit operates properly by plugging the unit s power cord into a conveniently located 120V grounded outlet CAUTION TO PREVENT ELECTRICAL SHOCK MATCH THE WIDE BLADE OF THE PLUG TO WIDE SLOT OF THE RECEPTACLE FULLY INSERT f i j a 2 3 Az Ti I H Y Vin ha ri 2 j Ji 7 i _ fi EN 3 M A AQ WARNING DO NOT OPERATE THE IF THE POWER CORD PLUG IS DAMAGED DO NOT OPERATE THE UNIT IF IT IS DAMAGED OR HAS MALFUNCTIONED IN CASE OF MALFUNCTION DISCONNECT THE PLUG IMMEDIATELY IF YOU SUSPECT THE UNIT IS DAMAGED ETURNING Refer to the Operating various controls and features of the unit Instructions regarding the NOTE This appliance comes equipped with an overheat protection safety device Should the appliance begin to overheat for any reason it will automatically turn all heater functions of the appliance off The appliance will have to be reset prior to continuing use To reset the overheat protection safety device turn all controls off and unplug the appliance Wait 10 minutes plug the appliance back in and turn on OPERATING INSTRUCTIONS CONTROL PANEL OPERATING PROCEDURES Once the unit has been properly connected to a grounded electrical outlet it is ready to operate Note Ensure the circuit breakers for the power supply are turned on an To access the control panel slowly open the door O locat
11. p outlet power strip 12 Do not run cord under carpeting Do not cover cord with throw rugs runners or similar coverings Arrange cords away from traffic areas where it will not be tripped over NO 13 Never operate the unit on a program switch timer or any other appliance for automatic operation 14 Always disconnect the unit from the power supply before performing any cleaning light bulb replacement maintenance relocating the electric heater or when the unit is not in use for long periods of time To disconnect the heater push the master power switch to the OFF position before removing the plug from the outlet 15 When transporting or storing the unit keep it in a dry location free from dust excessive vibration or other factors which may damage the unit 16 Always unplug the heater when not in use 17 A heater has hot and arcing or sparking parts inside Do not use it in areas where gasoline paint or flammable liquids are used or stored 18 Use this heater only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons SAVE THESE INSTRUCTIONS DANGER HIGH TEM PERATURES MAY BE GENERATED UNDER CERTAIN ABNORMAL CONDITIONS DO NOT PARTIALLY OR FULLY COVER OR OBSTRUCT THE FRONT OF THIS HEATER SPECIFICATIONS Technical Specifications Model EA1105J Voltage 120V Frequency 60Hz Power 1400W TESTING THE UNIT Carefully remove the u
12. size and wattage Figure 4 Unit with back panel removed Fig 4 Access Panel Screws LIGHT BULB MAY BECOME LOOSE DURING SHIPPING lf the simulated flame effect is dim or does not operate properly at first please ensure that the light bulb is properly secured in the socket bulb should be finger tight do not over tighten TO REPLACE FLAME EFFECT LIGHT BULB 1 Turn all controls to OFF 2 Unplug the unit from the power supply 3 Remove back panel by removing 4 screws as shown See Fig 4 4 Unscrew the light bulb turning counter clockwise and remove 5 Replace with new light bulb turning clockwise 6 Replace back panel and secure with screws 7 Plug the unit into the power supply 8 Turn the power switch to the ON position CLEANING YOUR HEATER WARNING BEFORE CLEANING THE EXTERIOR OF THE APPLIANCE DISCONNECT THE UNIT FROM THE POWER SUPPLY AND LEAVE UNTIL COOL You can clean the exterior of the heater with a soft damp lint free cloth Do not use cleaning or polishing products CLEANING THE FRONT GLASS PANEL WARNING BEFORE CLEANING THE EXTERIOR OF THE APPLIANCE DISCONNECT THE UNIT FROM THE POWER SUPPLY AND LEAVE UNTIL COOL Over time the front glass panel may become dirty or dusty Dust can be removed by lightly rubbing the glass surface with a clean lint free cloth or paper towel To remove fingerprints or other marks use a soft damp lint free cloth with a good quality
Download Pdf Manuals
Related Search