TM-T70II User`s Manual - Epson America, Inc.
Contents
1. Epson recommends cleaning the thermal head periodically generally every 3 months to maintain receipt print quality TM T70II User s Manual 9 Specifications 80 mm paper width model 58 mm paper width model Printing method Thermal line printing Printing direction Unidirectional with friction feed Roll Paper single ply Size 79 5 mm 0 5 mm 3 13 Size 57 5 mm 0 5 mm 2 26 0 02 0 02 Maximum outside diameter 83 mm 3 27 Roll Paper spool diameter Inside 12 mm 0 47 Outside 18 mm 0 71 Thermal paper type Specified NTPO80 80 Specified NTP058 80 Interface compatible Serial RS 232 Parallel IEEE1284 Ethernet 10BASE T 100BASE TX Wireless LAN IEEE802 11b USB Compliance USB 2 0 Communication speed Full soeed 12 Mbps USB Plus Power Communication speed Full speed 12 Mbps Bluetooth Receive buffer 4 KB 45 bytes Cash drawer function 2 drives Power supply DC 24 V 7 Current consumption at 24V Mean Approx 1 8 A Temperature Operating 5 to 45 C 41 to 113 F Storage 10 to 50 C 14 to 122 F except for paper Humidity Operating 10 to 90 RH Storage 10 to 90 RH except for paper Overall dimensions 114 x 125 x 194 mm 4 49 x 4 92 x 7 64 H x W x D Weight mass Approx 1 7 kg 3 74 lb Excludes roll paper Be2. Epson Corporation shall not be held liable for any damage resulting from electromagnetic interference that occurs from the use of any interface cables other than those designated as Epson approved products EPSON is a registered trademark of Seiko Epson Corporation Exceed Your Vision is a registered trademark or trademark of Seiko Epson Corporation All other trademarks are the property of their respective owners and used for identification purpose only NOTICE The contents of this manual are subject to change without notice Seiko Epson Corporation 2014 All rights reserved 2 TM T7O0II User s Manual Important Safety Information This section presents important information intended to ensure safe and effective use of this product Read this section carefully and store it in an accessible location Key to Symbols The symbols in this manual are identified by their level of importance as defined below Read the following carefully before handling the product A WARNING Warnings must be observed carefully to avoid serious bodily injury A CAUTION Cautions must be observed to avoid minor injury to yourself damage to your equipment or loss of data Safety Precautions This section describes the warnings and cautions intended to ensure safe and effective use of the TM T7OII Other warnings and cautions on handling of this product for its safe and effective use are described in other sections of the manual A WARNING If
3. that the paper is set between the paper guides TM T70II User s Manual 7 5 Close the printer and make sure that the roll paper is properly installed between the paper guides Troubleshooting No lights on the control panel Check whether the DC cable and AC cable are correctly connected to the printer and the power outlet ERROR LED on not flashing with no printing If PAPER OUT is on the roll paper is not installed or is used up If PAPER OUT is off the printer cover is not closed properly ERROR LED flashing with no printing and no paper jam Printing stops if the thermal head overheats and resumes automatically when it cools If overheating is not the cause turn the printer off and after 10 seconds back on 8 TM T70II User s Manual Removing Jammed Paper A A CAUTION Do not touch the thermal head because it can be very hot after printing 1 Turn the printer off and press the cover open lever 2 Remove jammed paper reinstall the roll and close the printer cover Cleaning the Thermal Head A A CAUTION After printing the thermal head can be very hot Do not touch it and to let it cool before you clean it Do not damage the thermal head by touching it with your fingers or any hard object Turn off the printer and open the printer cover Clean the thermal elements of the thermal head with a cotton swab moistened with an alcohol solvent ethanol or IPA Thermal head
4. EPSON EXCEED YOUR VISION T7010 TM User s Manual All rights reserved No part of this publication may be reproduced stored in a retrieval system or transmitted in any form or by any means electronic mechanical photocopying recording or otherwise without the prior written permission of Seiko Epson Corporation No patent liability is assumed with respect to the use of the information contained herein While every precaution has been taken in the preparation of this book Seiko Epson Corporation assumes no responsibility for errors or omissions Neither is any liability assumed for damages resulting from the use of the information contained herein Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages losses costs or expenses incurred by purchaser or third parties as a result of accident misuse or abuse of this product or unauthorized modifications repairs or alterations to this product or excluding the U S failure to strictly comply with Seiko Epson Corporation s operating and maintenance instructions Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or any consumable products other than those designated as Original Epson Products or Epson Approved Products by Seiko Epson Corporation Depending on the area the interface cable may be included with the product If so use that cable Seiko
5. M T70II User s Manual 5 Important Notes on Installation D Fora serial interface you must use a null modem cable also called a cross cable 1 Fora parallel interface use a cable that meets the specifications for an IEEE 1284 compliant cable Q Fora USB interface install the printer driver before connecting the printer Installing the Printer You can install this printer only horizontally Fix the printer so that it does not move around when you open the printer cover and cut roll paper A tape for fixing the printer is available as an option Install the printer with a maximum tilt of 3 Installing the printer with a tilt of more than 3 may cause the following problems e Roll paper near end cannot be detected e The printer cover will not close after installing roll paper e Roll paper cannot be taken out allowance within 3 Using the Power Switch Cover A WARNING If an accident occurs with the power switch cover attached unplug the AC cable immediately Continued use may cause fire or shock The enclosed power switch cover ensures that the power switch is not pressed accidentally To use this cover install it as shown below 6 TM T70I User s Manual Installing Roll Paper 1 Press the lever to open the printer cover 2 Remove the used roll paper core 3 Install the roll paper The correct direction of the paper is shown below 4 Pull out some roll paper so
6. n equipment nuclear power control equipment or medical equipment related to direct medical care etc please make your own judgment on this product s suitability after a full evaluation Purpose of This Manual This manual provides information to operators of the TM T7OII printer to describe basic operations to enable safe and correct use of the printer 4 TM T70II User s Manual Downloading Drivers Utilities and Manuals Drivers utilities and manuals can be downloaded from one of the following URLs For customers in North America go to the following web site http www epsonexpert com and follow the on screen instructions For customers in other countries go to the following web site http download epson biz com service pos Unpacking The following items are included with the standard specification printer If any item is damaged contact your dealer I Printer Q Roll Paper 1 Power switch cover Q AC adapter 1 AC cable Q TM T7OII Software amp Documents Disc I Setup Guide May not be included depending on the printer model Part Names Cover open lever O Paper O Error i Power switch Pi Control Panel FEED button This button feeds paper Power LED This LED is on when the printer is on ERROR LED This indicates an error PAPER OUT LED On indicates a paper near end or out Flashing indicates standby Printer cover Control panel T
7. sure to use a safety standards applied power source that meets the following specifications Rated output 24 V 2 0 10 0 A Maximum output 240 VA or less 10 TM T70II User s Manual
8. t Equipment may fall or collapse causing breakage and possible injury Take care not to injure your fingers on the manual cutter e When you remove printed paper TM T70II User s Manual 3 e When you perform other operations such as loading replacing roll paper To ensure safety unplug this product before leaving it unused for an extended period Before moving this product be sure to unplug it and all the cables connected to it Caution Labels The caution labels on the product indicate the following precautions AA CAUTION The thermal head can be very hot during printing and immediately after printing Touching it may cause burns Be sure to do cleaning and other work after the thermal head cools down Also be careful of the autocutter blade near the thermal head Autocutter blade i lt MO Q F O Thermal head IN Q lo TES Restriction of Use When this product is used for applications requiring high reliability safety such as transportation devices related to aviation rail marine automotive etc disaster prevention devices various safety devices etc or functional precision devices etc you should use this product only after giving consideration to including fail safes and redundancies into your design to maintain safety and total system reliability Because this product was not intended for use in applications requiring extremely high reliability safety such as aerospace equipment main communicatio
9. the TM T7Oll produces smoke a strange odor or unusual noise shut down the TM T7OIl unplug the AC cable immediately and then contact your dealer or an Epson service center for advice Continued use may lead to fire or electric shock Never attempt to repair this product yourself Improper repair work can be dangerous Never disassemble or modify this product Tampering with this product may result in injury or fire Be sure to use the specified power source Connection to an improper power source may cause fire Do not allow foreign matter to fall into the equipment Penetration by foreign objects may lead to fire If water or other liquid spills into this equipment shut down the TM T7OIl unplug the AC cable of the TM T70II immediately and then contact your dealer or an Epson service center for advice Continued use may lead to fire or shock Do not use aerosol sprayers containing flammable gas inside or around this product Doing so may cause fire CAUTION Do not connect cables in ways other than those mentioned in this manual Different connections may cause equipment damage or fire Be sure to set this equipment on a firm stable horizontal surface The product may break or cause injury if it falls Do not use this product in locations subject to high humidity or dust levels Excessive humidity and dust may cause equipment damage or fire Do not place heavy objects on top of this product Never stand or lean on this produc
Download Pdf Manuals
Related Search