Guide to accompany Class II Setup Software
Contents
1. if yours is provided If it is listed select it as this will automatically change the other relevant settings If your ISP country are not listed you will need to make sure the Protocol VCI VPI and MTU and any other settings that your ISP may specify are correct 4 Next enter the ISP username and password exactly as they have been given to you by your ISP These are case sensitive so ensure that CAPS LOCK is off Some ISPs issue only a username in which case the password should be left blank Once those four stages are complete click on Setup and the software will take care of the rest of the process After the settings have been applied and the router has been rebooted a message will appear and ask if you wish to open the router s web interface in your default browser Users who wish to set up further aspects of the router not covered by the setup software may wish to do so The web interface can also be opened at any time by clicking on the Web UI button Page 1 of 3 Extra options Instead of clicking on Setup immediately after stage 4 some users may wish to change further settings beforehand To do this one can click on Next or Back to go between these extra settings tabs Router amp ISP details DHCP amp NAT DNS Frosy User Details The DHCP start and end addresses define the range over which the router can provide IP addresses to devices connected to the router Enable DHCP DHC2. P start IP address 197 16812 DHCP end IP address 1921681254 DHCP lease time seconds 3600 Enable MAT DHCP amp NAT User Details Router amp ISP details DAIS Provy The router is able to automatically detect the DNS servers set by your ISP enabled You may also enter your own ONS server addresses or disable DNS on the router altogether DNS Proxy DAS Server d 0 DAS Server 2 DAS Server 3 nnr Page 2 of 3 Router amp ISP details DHCF amp WAT DNS Proxy User Details f you would like to change the router log in username please enter a new one here otherwise leave the box EMPTY New Username What these settings actually do should be fairly obvious to the user If not then the specific terms can be looked up in the user manual and on the Internet on forums such as RouterTech Org When you are happy with the settings you can click on Setup to complete the process and wait for the router to be set up and rebooted NOTE Before running the software it is assumed that you will have already connected the router to the PC on which the software is run and will have switched the router on The exact details of this should be found in the instructions that come with your router Page 3 of 3
3. Self Install Wizard for AR7RD AR7WRD routers Class lI Router Setup Guide by Neo at RouterTech Org When you run the setup software you should be presented with a window that looks something like the following isi Self Install Wizard for AR RD AR7WRD routers 1 0 12 S er alech Router amp ISP details DHCP amp NAT ONS Proxy User Details Please check the details are correct for your router and ISP You may access more advanced settings by clicking Mext or simply set up the router by clicking Setup 1 IF Address 192 168 1 1 Username Admin Password Connection namel ISP amp Count UK UK Most ISPs ISP Username nametaisp corn ISP Password sx Protocol ppp as VCR vefa VPI 1 From here you should enter the router details The router IP address this will normally be something in the form of 192 168 x x or 10 0 x x and it should be printed in your manual or on a label The username and password needed to access your router this is typically Admin and again this should be found in the literature that accompanies your router 2 Atthis point you should enter a connection name for the Internet connection you are about to create It doesnt matter what this name is but it would be useful to identify the connection at a later point Usually it can be named after your ISP e g ISP connection 3 The next step is to look through the list of ISPs and countries to see
Download Pdf Manuals
Related Search