User Manual
Contents
1. 5411 71089G YeLialaler ADVANCED CAR RACKS Cargo Box BRA220R Installation Instructions These instructions are for the installation and use of the Inno carrier system attachment After reading this manual keep it in a safe place along with the installation instructions for the rest of your carrier system Leave Key in key cylinder until Box is closed to avoid locking it in the box Box lid p accidentally Insert Key into key cylinder and turn it clockwise to Open position Lift Box Lid by pushing release button PRECAUTIONS Do not overload your cargo box Maximum load capacity varies by vehicle Check the appropriate limits for your car in the Fit Guide and your vehicle owner s manual and determine your maximum loading capacity with the formula below Use the lower of the 2 options below Max load of Max load of Before driving the vehicle shake the rack in all directions to ensure that there is no looseness in any of the mounting knobs and screws Retighten any loose knobs or screws Unfasten Buckle and hang Straps on Strap Hooks to keep them out of the way while loading Load cargo Unhook Straps and fasten it to secure cargo from moving while To close lid make sure that Key is in the OPEN position Make sure that Hooks line up with latches and close Box all the way driving cargo box vehicle or m Cargo box 110 Ibs cross bar Strap Hook The Cargo box includes the parts listed below Verify that they are inc2. Kit Instruction Manual ae eee ee ee ee m Front Place plugs into the 6 unused holes to seal Rear Trim Molding to the proper size and insert into slot Warning Make sure to tighten the right and left knobs evenly so that the U bolt sits square with the Cargo Box ar If U bolt is not tightened correctly it may allow the box to come loose a m Cross Bar U Bolt U Bolt Cut Molding to this size Push Box in all directions to make sure that there is no loosenesss If you notice any play in the box retighten 8 Knobs Contact Information If you have any questions or comments please contact us at the service center listed below CarMate shall not be held liable for any accidents or incidental losses arising from improper installation or use nor for those arising from installation or use after the customer has made any change to the system s original configuration or specifications 7 mno ADVANCED CAR RACKS Car Mate USA 383 Van Ness Ave Suite 1603 Torrance CA www innoracks com support rv inno com Thread Strap trough two Rings on each side of the box and fasten Attach Strap Hooks inside box lid just above Straps Buckle Ring BRA220R Important Notes on the Cargo Box Alaa ep ADVANCED CAR RACKS Read and understand this user s manual thoroughly before using your new cargo box and be sure to follow all usage instructions Keep this manual in a safe place so that it s handy for
3. away dust and dirt Do not component from being lost Avoid storage in use any thinner or solvents to areas subject to direct sunlight high clean any part of the carrier temperature or excessive humidity system 1 Worn screw threads 2 Key deformation 3 Holder deformation 4 Cracks in any of the components of the carrier system
4. luded with the carrier you have purchased In the event any of these is missing contact our service center as listed at the end of this manual If using an aftermarket base rack system make sure that it is installed properly according to the procedures described in the installation instructions for that rack N CAUTION The distance between the front and rear crossbars should be at least 60cm 2 feet Temporarily put the Box on cross bars And Insert key turn clockwise and push button to open the Box push button Try to lift the lid at the latch points shown below to make sure that the hooks have full engaged with the latches Turn Key counter clockwise to the CLOSE position 2 EA Ex Adjust the location of the Box to align with holes at A Rooftop Box Check at these points Genuine Inno Replacement Parts ISP952 Strap The following genuine replacement parts are available for this Inno carrier system component Specify the part number when ordering parts from your dealer ISP682 Strap Hook 2 pack Specifications and the appearance of the carrier system and genuine replacement parts are subject to change without prior notice in the interest of product improvement Attach the Box to front cross bar with Plate U Bolt and Knobs Make sure that the ring on the Plate is on the side nearest the side of box ISP193 Molding ISP588 Hole Plugs 2 pack 4 pack A eS Key Verify Key number Fit
5. reference anytime If you have any questions regarding the information in this manual please contact the service center listed at the end of this manual AN Precautions While our box is designed to mount to a variety of crossbar types we have no control over non Inno rack quality We cannot guarantee the performance of our At least 1 7 feet 50cm carrier when mounted on a rack made by Cross bars ___ l 7 another manufacturer sla L Go X N Ss Do not attempt to modify the box in any way E When loading spread your cargo Make sure before driving that the box is Front Center Rear evenly throughout the box Avoid securely closed and locked If it is not 10kg 2 kg 13kg loading more than 10 kg 22 Ibs C securely closed or unlocked it may 22 Ibs 60 Ibs _ 28 Lbs inthe front area of the box N x open accidentally and you may lose Unbalanced loading may result in i your cargo or cause a serious accident safety problems There should be a distance of at least 1 7 feet 50cm between the front and rear crossbars Obey posted speed limits Under Avoid loading the following types of cargo high wind or poor road condtions PTE 1 Highly pressurized spray cans drive at a lower speed 2 Flammable goods 3 Sensitive or delicate machines and Do not expose the cargo box to SYVE electronics hurricane or gale force wind 4 Pet animals conditions 5 Perishables Direc
6. t sunlight on the box can elevate the temperature inside the box and damage or harm the above items Do not apply lubricants oil or grease to Make sure that the box does not damper hinges or box surface as they may interfere with opening of the rear damage the box A damaged box may be door structurally weaker and may not perform If you cannot avoid interference safely NZ apply a protective pad to avoid damage to either the Box or car body Avoid loading gear that you do not want Pay close attention when opening to get wer While the box is water gt and closing the box under high resistance it is not waterproof Cargo f wind conditions may get wet when the box is used in a J gt The wind may cause the box to rainy conditions open or close more quickly than normal Be careful with your fingers in these situations The installed box increases the height Do not drive your cargo box of your vehicle Pay close attention to through a car wash this new height so that you do not hit AE x Always remove the carrier system objects such as signs trees or garage J before running your car through a ceilings and doors If you do hit an lt car wash object with the rack check to ensure A Care and Storage Wash any mud off the carrier 2 After cleaning carrier check for any of the following Store all components of the carrier system system Use a damp towel to together in one place to prevent any wipe
Download Pdf Manuals
Related Search