G2K Wireless Manual - William Stump & Associates, LTD.
Contents
1. For each click clockwise watch the number of flashes from the green LED light e1 Green Flash TEST 15 Seconds e2 Green Flashes 2 5 minutes e3 Green Flashes 10 5 minutes e4 Green Flashes EOT End of Tape eSolid Red Transmitting eFlashing Red Low Battery2. PURCHASER MAY CHOOSE TO CONNECT TO THE PRODUCT LIMITATION OF LIABILITY THE LIABILITY OF THE MANUFACTURER IF ANY AND PURCHASER S SOLE AND EXCLUSIVE REMEDY FOR DAMAGES FOR ANY CLAIM OF ANY KIND WHATSOEVER REGARDLESS OF THE LEGAL THEORY AND WHETHER ARISING IN TORT OR CONTRACT SHALL NOT BE GREATER THAN THE ACTUAL PURCHASE PRICE OF THE PRODUCT WITH RESPECT TO WHICH SUCH CLAIM IS MADE IN NO EVENT SHALL THE MANUFACTURER BE LIABLE TO PURCHASER FOR ANY SPECIAL INDIRECT INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND INCLUDING BUT NOT LIMITED TO COMPENSATION REIMBURSEMENT OR DAMAGES ON ACCOUNT OF THE LOSS OF PRESENT OR PROSPECTIVE PROFITS OR FOR ANY OTHER REASON WHATSOEVER G2k Wireless TX RX pub Rev B Wiliam Stump amp Associates LTD Guardian 2000 Wireless Transmitter Receiver User s Manual G2K Wireless Transmitter Receiver INTRODUCTION Congratulations and thank you for purchasing the Guardian 2000 Wireless Transmitter Receiver Please read your Guardian manual completely before using this accessory In addition to the instructions within the Guardian manual the following additional information is provided Features include e 2 Weatherproof housings Video TX 100mW board level with 250mW apparent through antenna gain Channel frequency 2450 2483 MHz Data TX RX frequency 418 MHz User adjusted transmit time Current draw typ 500mA while transmitting As you read through this manual ple
3. The limited warranty stated herein is subject to all of the following terms and conditions TERMS AND CONDITIONS 1 NOTIFICATION OF CLAIMS WARRANTY SERVICE If Purchaser believes that the product is defective in material or workmanship then written notice with an explanation of the claim shall be given promptly by Purchaser to the Manufacturer but all claims for warranty service must be made within the warranty period No repair or replacement of any product or part thereof shall extend the warranty period as to the entire product The specific warranty on the repaired part only shall be in effect for a period of ninety 90 days following the repair or replacement of that part or the remaining period of the product parts warranty whichever is greater 2 EXCLUSIVE REMEDY ACCEPTANCE Purchaser s exclusive remedy and the Manufacture s sole obligation is to supply all labor necessary to repair any product found to be defective within the warranty period Purchaser s failure to make a claim as provided in paragraph 1 above or continued use of the product shall constitute an unqualified acceptance of such product and a waiver by Purchaser of all claims thereto 3 EXCEPTIONS TO LIMITED WARRANTY The Manufacturer shall have no liability or obligation to Purchaser with respect to any product requiring service during the warranty period which is subjected to any of the following abuse improper use negligence accident modification failure of the en
4. ase keep in mind your system has been rigorously inspected for utmost quality assurance prior to shipment About the G2K Wireless Transmitter The G2K Wireless uses a FCC approved Part 90 video transmitter and receiver The rugged weatherproof enclosure provides maximum outdoor protection The G2K Wireless Transmitter is specifically designed to be used with all Guardian 2000 surveillance systems Once an alarm from a Guardian sensor is received the camera is powered up Then video is transmitted back to the main Guardian unit This is the perfect solution where longer range equipment concealment and mission success are paramount Deployment of the G2K Wireless TX RX 1 For optimal performance place the transmitter and receiver units at least 3 4 feet off the ground and out of vegetations way These units are not designed to be buried It is also best to triangulate the placement of the alarm sensor wireless TX and Guardian box The alarm sensor has to send an alarm to both the Wire less TX and the Guardian box Typically your Guardian box should be placed around 300 ft from your camera This distance will very due to conditions around the set area Dense vegetation and or hilly terrain may require a closer set Clear line of sight transmission is possible up to 1000 ft The top of the wireless RX unit should be facing the wireless TX unit The internal batteries of the wireless transmitter unit will last for 180 transmis
5. d user to follow the operating procedures outlined in the user s manual failure of the end user to follow the maintenance procedures in the service manual for the product attempted repair by non qualified personnel operation of the product outside of the published environmental and electrical parameters or if security seal has been defaced altered or removed The Manufacturer also excludes from warranty coverage products located outside the United States and consumable items such as fuses and batteries Items not manufactured by Backgrounds Unlimited Inc but included in system bought by Purchaser are limited to original manufacturer s warranty and will be repaired by Backgrounds Unlimited Inc on cost of material basis 4 PROOF OF PURCHASE The purchaser s dated invoice must be retained as evidence of the date of purchase and to establish warranty eligibility DISCLAIMER OF WARRANTY EXCEPT FOR THE FOREGOING WARRANTIES THE MANUFACTURER HEREBY DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING BUT NOT LIMITED TO ANY AND OR ALL IMPLIED WARRANTIES OF MERCHANTABILITY FITNESS FOR A PARTICULAR PURPOSE AND OR ANY WARRANTY WITH REGARD TO ANY CLAIM OF INFRINGEMENT THAT MAY BE PROVIDED IN SECTION 2 312 3 OF THE UNIFORM COMMERCIAL CODE AND OR ANY OTHER COMPARABLE STATE STATUE THE MANUFACTURER HEREBY DISCLAIMS ANY REPRESENTATIONS OR WARRANTY THAT THE PRODUCT IS COMPATIBLE WITH ANY COMBINATION OF NON MANUFACTURER S PRODUCTS
6. rdian has a clear picture Refer to the main Guardian manual for additional operation help 6 For analog Guardian systems set the PGM or Timer for unit to begin recording Refer to the main Guard ian manual for additional operation help Table of Contents General Pre Operation Operation of the Transmitter Operation of the Receiver Deployment Warranty Information General Our G2K wireless is a 2 part system As pictured on the cover the left unit is a video receiving unit This unit is powered up by the main Guardian box The second unit houses a video transmitter and a data receiver It is pow ered by 8 replaceable D cell batteries One cable is connected to a camera via the blue connector Pre Operation 1 Read this manual thoroughly 2 Doa sight survey Determine your environment know the who what when where and why 3 To install batteries remove the four outer screws lo cated on the top of the transmitter housing Remove the transmitter s top 4 Unplug the power connector and lift the battery holder from the housing 5 Insert batteries paying attention to the and signs Some brands of batteries are larger in diameter and stick inside the plastic battery pack not allowing the ends to touch their respective contacts Check batteries to insure the positive end is touching the con tact and the negative end is touching
7. sions at the 2 minute setting Total deployment time varies due to the sensor s alarm activity In a typical installation we recommend replacing the batteries every two weeks 4 To decrease transmitting time do the same proce dure but rotate the selector switch counter clockwise When setting the transmitter time keep in mind the wireless transmitter timer is reset during multiple alarms Thus only turning off after the last alarm plus your set time Operating the G2K Wireless Receiver 1 The receiver unit houses a 4 channel video receiver which channel set to match the transmitter unit 2 Power up main Guardian unit Remove 4 lid screws on the top of the video receiver unit The unit should be labeled with the set channel which has to match your transmitter unit A Red LED should match the labeled channel If not press the switch to change the channel until the correct LED is lit 3 The receiver has its own internal antenna and should be aimed in the direction of the transmitter in your target area 4 Point the top identified by the surface with four screws inserted towards the video transmitter 5 Using the Guardian handheld signal an alarm digital model only for analog systems refer to step 6 This should turn your wireless transmitter on and transmit the camera video to your main Guardian One alarm activation will transmit video for the pre set duration on the transmitter unit Verify that your Gua
8. the spring If they do not touch the contacts the transmitter WILL NOT operate 6 Reinsert the battery pack into housing 7 Plug up the power connector a LED will illuminate GREEN for approximately 5 seconds to indicate the unit is powered up and in test mode When not using the units unplug the power connector 10 Connect the receiver unit to the main Guardian box The re ceiver connects just like a camera One cable from the box is supplied with a blue connector Connect the blue con nect to the corresponding blue connection on the guardian box The receiver unit is powered by the guardian box On the receiver unit attach 2 supplied antennas Each an tenna has a different type of connector and will only attach one way The larger of the two connectors is the data an tenna and the smaller is the video transmitting antenna Antennas should be at a 90 degree angle DO NOT FORCE THEM You will also need to attach the data TX RX antenna to the main Guardian box Obtain the antenna omni directional right angle UHF connector and secure it in place by insert ing the connector into its receptacle located on the back of the Guardian 2000 unit Turn clockwise until secure Operating the G2K Wireless Transmitter 1 2 The transmitter unit is shipped in the test mode This pre sets the transmitting time to 15 seconds To increase transmitting time use a small slotted screw driver to rotate the selector switch clockwise
Download Pdf Manuals
Related Search