yakima whispbar roof racks k478 fit kit installation
Contents
1. Prorack Loads of life GB Fitting Instruction for Accessory n Zi zs X2 11 04 251 Revision No 1 2 Fitting Kit WHD MAX kg MAX kg W P WHD W P WHD Dodge Avenger 4dr Sedan 08 US 75 75 Avenger 4dr Sedan 08 EU 75 75 Avenger 4dr Sedan 08 NZ 75 75 Avenger 4dr Sedan 08 AU 75 75 iugo Kit K478 First Time Installation Remove parts from packaging and check contents Contact your Prorack dealer if parts are missing or damaged Li Sa n ag This kit fits type A B C and D These instructions show type A crossbar fitted They also apply to type B C and D a am D NOTE Clamp images in these instructions may not be representative of the clamps in this kit Fitting Kit Use keys to remove covers Use hex screwdriver to reverse adjusting screw 10 turns Press adjusting screw and pull crossbar legs out Refer to the crossbar instructions for crossbar adjustment Ensure each end of the crossbar is adjusted equally Fitting Kit Remove locking screw Apply protective strip as shown Trim if required Letters refer to the part numbers stamped on clamps Clamp Part Number A 638 i be PN bi B 639 9 9 Fitting Kit Attach clamp to each leg NOTE clamps may have labels showing their positions on the vehicle For exa2. mple Front Right Refit locking screw so that it goes through the hole in the clamp Do not begin to tighten the locking screw Refer to the underside of the pad for the part number Fitting Kit Letters refer to the pad part numbers and position Pad Part Number A 11 04 250 B 11 04 251 Fit rubber pads supplied with fitting kit to foot Pad may vary in shape to that shown Make sure the pad fits into the holes underneath the foot Repeat for all legs Fitting Kit Fitment Place crossbar on vehicle Minimum recommended spacing between the bars is 700mm unless otherwise stated Clamps directly to edge of roof under the doors Please check the rear of this manual for information relating specifically to your vehicle Adjust the legs on the crossbar so that they are positioned equally from the ends of the crossbar and the clamps engage firmly on the body work of the vehicle Tighten adjusting screw to 5 Nm Fitting Kit Tighten locking screw on both legs evenly Check crossbar is securely attached to the vehicle Use keys to fit and lock covers
Download Pdf Manuals
Related Search