Techniku IR Tilt Motor Programming Instructions for
Contents
1. Techniku INNOVATION IN AUTOMATION TH950 INSTALLATION AND USER MANUAL IMPORTANT Program each blind immediately after connecting power battery case power supply to the Intelligence Interface Blind Installation Install the blind per manufacturer installation instructions During installation the blind should be in a raised and locked position Check that the blind is well aligned and installed with all brackets so there is no stress to effect the automation assembly s torque for tilting Lower the blind If necessary re position the IR Eagle Eye receiver Remote Control Overview The infrared remote control can operate the blind within a 50 range of the IR Eagle Eye receiver Because it is infrared the Eagle Eye receiver MUST be in direct line of sight with the remote control The remote control has six different channels buttons 1 6 with CHANNEL function lt or gt and an ALL channel A or V Using the remote control the user can e Operate six blinds individually program one blind on each of the six channels e Operate an unlimited number of blinds by programming multiple blinds on the same channel i e east facing blinds on Channel 1 west facing blinds on Channel 2 etc Each channel will operate all of the blinds programmed on that channel in direct line of sight at the same time The six programmable channels can operate up to SIX groups of one or more blinds e2. ALL channel does NOT need to be programmed separately If you accidentally program to ALL or any other undesired channel refer to Reprogram the Blind to Remote Control Reprogram the Blind to Remote Control If a blind is not programmed to the desired channel reprogramming is simple 1 Pointing the remote control at the IR Eagle Eye receiver press and hold the P button for 5 seconds be within 1 of the remote control to the IR Eagle Eye receiver Decide and press the selected channel 1 6 you wish to program the blind followed by the lt or gt CHANNEL button The blind is now programmed to that channel The blind can be reprogrammed as many times as necessary It does NOT need to be reprogrammed after changing batteries in the blind or the remote control Page 5 Part Number 7951027MWM Intelligence Interface Revision Date 02 01 05
3. Operate all blinds direct line of sight with the ALL Channel Buttons 1 6 for Channel Selection P Channel Program ALL Channel Channel Function for Channel Selection 1 6 Insert two AAA batteries in the proper orientation as shown in the battery case of the remote control Page 4 eee Part Number 7951027MWM Intelligence Interface Revision Date 02 01 05 O ii Techniku INNOVATION IN AUTOMATION THO950 INSTALLATION AND USER MANUAL Limits do NOT need to be set on the automation assembly Once the motor reaches its full range of tilt slats closed in either direction the motor will stop It will NOT over rotate the slats IMPORTANT When programming be within 1 of the remote control to the IR Eagle Eye receiver Program each blind immediately after connecting U power from the Intelligence Interface to the power E source battery case power supply Point the C remote control at the IR Eagle Eye receiver be within T from the remote control Press and hold the P button for 5 seconds Decide and press the selected channel 1 6 you wish to program the blind followed by the i lt or gt CHANNEL button DO NOT PRESS S THE ALL CHANNEL FIRST Once you have c assigned the channel the blind is programmed to operate from that channel only and will not respond to the other channels except for the ALL channel The
Download Pdf Manuals
Related Search