User Manual - WeatherConnection
Contents
1. e Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help The following information is not to be used as contact for support or sales Please visit our website at www2 oregonscientific com service for all enquiries We Name Address Telephone No Oregon Scientific Inc 19861 SW 95th Ave Tualatin Oregon 97062 USA 1 800 853 8883 declare that the product Product No Product Name Manufacturer Address RMR331ES RMR331ESU RMR331ESA ECO Solar Clock IDT Technology Limited Block C 9 F Kaiser Estate Phase 1 41 Man Yue St Hung Hom Kowloon Hong Kong 11 is in conformity with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference 2 This device must accept any interference received including interference that may Cause undesired operation2. as follows Solar panel facing North South if you reside in the Southern Hemisphere Northern Hemisphere e Do not scratch the solar panel s surface or wipe it with strong detergent e Do not expose the solar panel to rain snow or moisture e The duration of the rechargeable battery s charging or operating time is determined by either the intensity of sunlight or the position of the solar panel towards the sun e Do not overcharge the batteries EN 1 piece AAA battery In the case when the rechargeable battery is flat or nearly flat or when the solar panel has been detached the AAA battery can act as backup power supply for the main unit 1 Remove the battery compartment located at the base of the unit Insert the battery matching the polarity Press RESET after each battery change NOTE When the rechargeable battery power is exhausted or when the solar panel has been detached the backlight function will be disabled and the performance of the radio controlled clock may be affected Power adaptor not included The adaptor powers the unit and can also be used for charging the rechargeable battery When connected to the main unit x will be displayed NOTE The main unit and adaptor should not be exposed to wet conditions No objects filled with liquid such as vases should be placed on the main unit and adaptor REMOTE SENSOR To set up the remote sensor 1 Slide open the battery compartmen
3. may result in damage to its finish for which Oregon Scientific will not be responsible Consult the furniture manufacturer s care instructions for information e The contents of this manual may not be reproduced without the permission of the manufacturer e Do not dispose old batteries as unsorted municipal waste Collection of such waste separately for special treatment is necessary e Please note that some units are equipped with a battery safety strip Remove the strip from the battery compartment before first use NOTE The technical specifications for this product and the contents of the user manual are subject to change without notice EN NOTE Features and accessories will not be available in all countries For more information please contact your local retailer ABOUT OREGON SCIENTIFIC Visit our website www oregonscientific com to learn more about Oregon Scientific products If you re in the US and would like to contact our Customer Care department directly please visit WWWZ2 oregonscientific com service support asp For international inquiries please visit www2 oregonscientific com about international asp EU DECLARATION OF CONFORMITY Hereby Oregon Scientific declares that this ECO Solar Clock model RMR331ES RMR331ESU RMR331ESA is in compliance with the essential requirements and other relevant provisions of Directive 1999 5 EC A copy of the signed and dated Declaration of Conformity is available
4. on request via our Oregon Scientific Customer Service COUNTRIES RTTE APPROVED COMPLIED All EU countries Switzerland CH and Norway CND Lx ROHS COMPLIANT 10 FCC STATEMENT This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Reorient or relocate the receiving antenna
5. OreGcon Se 2 ew AP Ke STORE www OregonScientificStore com ECO Solar Clock BEE MEANS EE Oe 9 Model RMR331ES RMR331ESU Precautions ek oe s EE EE N NN 9 RMR331ESA About Oregon Scientific RR RR RR EER EE Ee 10 EU Declaration of Conformity cccccccceeseeeeeeeeeeeees 10 FCC Statement asses ERGER AR EER HA Re Ke 10 USER MANUAL Earth Friendly AE OE nenne 2 OVO WOW A E A E E 2 Front CW cose EE OR NE eN 2 TOPVIEW EE EE N EE NG EG nus 3 Bottom VIEW es De ee OO tite 3 S10 Fs gl aa RE EE EE EE EE 4 Remote Sensor EE KERKE KEER KS ED Ke Nee Ge KO D 4 Getting SAG rd Ro ee ee Re oe ee ee De ens 4 Solar Fanels id SEE Me Ed ee eg 4 Backup POWERED EKS ENE OES ERENS GE ENE ES EES Se EN ee ke Ge 6 Remote SONS OM se sa NKR GE RE NG RE GE AG EERS Ie 6 CIOCK and AICI AN issie Rds SKEER KS SEE 7 Clock Reception iss ER ik EN EE Ri id 7 Manually Set ClOCK ee ee ee ee 7 ED AE EE N EE NE EE aa aii 8 Temperature as OG KAR HERE eek NR SE Ged 8 BAC QUE EE EE EE EE nenene 8 1 EN EARTH FRIENDLY OVERVIEW The ECO line embodies our commitment to environmental concerns Aware of threats facing the world we live in Oregon Scientific has combined technological know how practicality and style to create this line of environmentally friendly products These products provide practical solutions while enabling you and us to fulfill our environmental responsibility _ QUT 4 rm E LIBE N Simpl
6. et unit to default settings CHANNEL switch OL ge O N GETTING STARTED SOLAR PANEL This product uses two AAA rechargeable batteries which should be charged via the solar panel For the batteries first charge it is strongly advised to charge it for at least 12 hours To charge the battery 1 Detach solar panel by exerting downward pressure and pulling at a 45 angle approx away from main unit 2 Insert 2 AAA rechargeable batteries in battery compartment located at the back of the solar panel IMPORTANT Place ONLY NiMH type rechargeable batteries in the solar panel battery compartment Do not charge non rechargeable batteries 3 Expose the solar panel directly to sunlight for approximately 5 6 hours to charge the battery The red CHARGING LED on solar panel will light up indicating there is sunlight and unit is charging TIP Press and hold TEST located at the back of the solar panel Green FULL LED indicates batteries have been fully charged 4 Align holes with protruding plastic Push solar panel towards main unit and snap into place 5 6 hours of battery charging will normally provide power to operate unit for 2 months When the rechargeable battery is nearly flat or when solar panel has been detached the green LED indicator on the main unit and amp will flash TIPS e For best results when charging the battery place the solar panel directly with view to sunlight e Direct solar panel
7. hours To display alarm Press te TEMPERATURE To toggle temperature unit Press C F BACKLIGHT Press SNOOZE to activate backlight for 3 seconds RESET Press RESET to return to the default settings SPECIFICATIONS TYPE LxWxH Weight Signal frequency Power LxWxH Weight Transmission range Temperature range Power DESCRIPTION 126 x 80 x 57 mm 5 x 3 15 x 2 24 in 240 g 8 47 oz without battery 433 MHz 2 x UM 4 AAA rechargeable batteries 6V AC adaptor not included 1 x UM 4 AAA battery for backup 96 x 50 x 22mm 3 78 x 1 97 x 0 87 in 62 g 2 22 ounces without battery 30 m 98ft unobstructed 20 C to 60 C 4 F to 140 F 1 x UM 3 AA 1 5 V battery PRECAUTIONS Do not subject the unit to excessive force shock dust temperature or humidity Do not cover the ventilation holes with any items such as newspapers curtains etc e Do not immerse the unit in water If you spill liquid over it dry it immediately with a soft lint free cloth e Do not clean the unit with abrasive or corrosive materials e Do not tamper with the unit s internal components This invalidates the warranty e Only use fresh batteries Do not mix new and old batteries e Images shown in this manual may differ from the actual display e When disposing of this product ensure it is collected separately for special treatment e Placement of this product on certain types of wood
8. t Slide channel switch to select a channel 1 2 3 Insert the battery matching the polarities Press RESET after each battery change Close the battery compartment Press and hold SEARCH for 2 seconds to initiate a sensor search n e ER IM NOTE Use alkaline batteries for longer usage and consumer grade lithium batteries in temperatures below freezing The remote sensor reception icon will show the following status ICONS MEANING OUT _ QUT Main unit is searching for sensor s A sensor channel has OUT OUT gt OUT gt OUT gt been found OUT No sensor found TIP Ideal placements for the sensor would be in any location on the exterior of the home at a height of not more than 1 5 m 5 ft and which can shield it from direct sunlight or wet conditions for an accurate reading RMR331ESU UK MSF 60 signal within 1500 km 932 miles of Anthorn England RMR331ESA WWVB 60 signal within 3200km 2000 miles of Fort Collins Colorado To enable disable clock signal reception Press and hold to enable or W to disable clock signal reception NOTE Reception takes 2 10 minutes If the signal is weak it can take up to 24 hours to get a valid signal If signal reception is unsuccessful place your unit next to a window press and hold A to force another signal search Clock signal reception indicator STRONG SIGNAL WEAK NO SIGNAL CLOCK AND CALENDAR This prod
9. uct is designed to synchronize its clock To set the clock manually disable the clock signal reception automatically with a clock signal first 1 Press and hold RMR331ES EU DCF 77 signal within 1500 km 932 2 Press A VW to change the settings miles of Frankfurt Germany 3 p Ct i Press o confirm EN The settings order is time zone 12 24 hr format hour minute year calendar mode month day day month month day and language RMR331ES RMR331ESU Time zone offset sets the clock 23 hours from the received clock signal time If you have deactivated the clock signal reception do not set a value for time zone NOTE If you enter 1 in the time offset setting this will give you your local time plus one hour If you are in the US RMR331ESA set the clock to PA for Pacific time MO for Mountain time CE for Central time EA for Eastern time NOTE The language options are English E German D French F Italian 1 Spanish S and Russian R To select clock display Press to toggle between clock with seconds clock with weekday and calendar ALARM To set the alarm 1 Press and hold e to enter alarm setting 2 Press W to set hour minute 3 Press 9 to confirm Q indicates alarm is ON To activate deactivate alarm Press Q To silence the alarm e Press SNOOZE to silence it for 8 minutes OR e Press any key to turn the alarm off and activate it again after 24
10. y detach the solar panel and face it directly towards the sun for a few hours to receive the amount of energy necessary to power the device Together we can improve the world we live in CO NOUIP w 9 Remote sensor reception indicator Outdoor temperature Indoor temperature ss Main unit back up batteries low no battery Mr AC adaptor connected X Rechargeable battery is low solar panel detached N OD ee ee ME M Rechargeable battery level indicator 8 AM PM 9 Rechargeable battery status LED indicator 3 Change display set clock 4 tel View alarm status set alarm 10 LE Outdoor remote sensor battery low 11 Q Daily alarm is On 12 9 Alarm time is displayed BOTTOM VIEW 13 ZONE Time zone offset 14 Calendar Clock with weekday seconds 1 2 3 15 Clock signal reception indicator TOP VIEW 5 Q Activate deactivate alarm function 1 SEARCH Initiate sensor search 2 RESET Reset unit to default settings 3 C F Select temperature unit 1 SNOOZE Activate snooze alarm backlight 2 V increase decrease value of the setting activate deactivate clock reception signal SOLAR PANEL ae YS 1 23 CHARGING charging in process FULL batteries fully charged when TEST is pressed Solar panel TEST establish if battery is full Battery compartment REMOTE SENSOR LED status indicator Wall mount hole Battery compartment RESET Res
Download Pdf Manuals
Related Search