20150507 ~ FORBO-EUROCOL-NL ~ 641-eurostar-special-el
Contents
1. eurocol 641 EUROSTAR SPECIAL EL Solvent free adhesive with a high initial grab for conductive floor covering Product Typification Basis Superior acrylic dispersion Colour Light grey Consistency Thick liquid Very low VOC emission Emicode EC 1 plus Non flammable Easy and safe to apply Multi purpose application High initial adhesion strength Favourable spreading capacity Roller castor chair resistant Electrical resistance lt 3 10 Ohm EN 13 415 Performances Specific weight 1 30 kg l Electrical resistance lt 3 105 Ohm measured in accordance with EN 13 415 Flammability Non flammable Consumption TKB S1 260 300 g m TKB S2 400 500 g m Application For the conductive installation of conductive PVC floor covering in sheets and tiles conductive rubber floor covering in sheets and tiles with a smooth back e g Noraplan or Norament EL conductive carpet For an optimal conduction apply 641 Eurostar Special EL in combination with a lattice work of 801 Copper strip or apply 041 Europrimer EL Before application consult the technical data sheet of 041 Europrimer EL and or regulations of the floor covering manufacturer Working Process Storage Store cool and free from frost Tools For rubber and PVC floor covering on porous subfloors use adhesive spreader TKB S1 For carpet adhesive spreader TKB S2 Latency Approx 10 minutes Drying time 48 hours Shelf Li2. fe 12 months in unopened packaging The mentioned values have been established in our laboratory and must be considered as guidelines in view of possible variations in climatic circumstances subfloor compositions and layer thickness Substrate e 641 Eurostar Special EL is suitable for any type of subfloor that has a good tensile and compression strength The subfloor should also be even clean permanently dry and free from grease and dirt according to the requirements of BS 8203 or DIN 18 365 e When installing on impervious subfloors apply a 2 mm levelling compound layer In advance always seek our technical data sheets In doubt about the application ask for technical advice User manual Working conditions Intended surrounding temperature 18 23 C Temperature for material and subfloor min 15 max 20 C Floor covering temperature Depending on type of floor covering consult manufacturer Relative humidity 40 80 Directions for use Stir the adhesive well before use Apply the adhesive with the recommended adhesive spreader TKB S1 for rubber and PVC floor covering and adhesive spreader B2 for Carpet On absorbent subfloors apply the floor covering after approx 10 minutes into the wet adhesive Check regularly to ensure there is a good adhesive transport on the back of the floor covering Roll the floor covering carefully Sheet ends and longitudinal joints are to be pressed firmly Rolling a
3. nd pressing should be repeated after approx 30 minutes Remove fresh adhesive spots immediately with water Underfloor heating systems 641 Eurostar Special EL can be applied on underfloor heating systems The startprotocol of the floorheating needs to be completly executed in accordance with the directives of the supplier Turn off the heater 24 hours before application Do not heat again until at least 24 hours after installation in steps of maximum 5 C water temperature per day Quality and guarantee Forbo Erfurt GmbH a Emissionsgepriftes Bauprodukt nach DIBT Grundsatzen 2 155 20 208 Environment and health Hazard Class None Safety and environment Safety data sheets of Forbo Eurocol products according to EEG guideline 91 155 MSDS Available on request DUBO Articles Article Definition Packaging EAN code 641 Eurostar Special EL 12 kg bucket 8 710345 486415 the strong connection
Download Pdf Manuals
Related Search