Photocell P5200 user manual（V8）
Contents
1. be more than 50cm 4 2 2 End user should install the photocell receiver on the back of the direct sunlight or other strong light source 52 to keep photocell work well steadily 4 2 3 Avoid installing other infrared photocell emitters within the effective distance of receiver 4 2 4 If the end user need to install other photocells in one same straight line the receivers could be installed in the two ends and the emitters could be back to back installed 4 2 5 Stable installation could avoid the signal of emitter and receiver skewing due to lightly vibrate and the malfunction 4 2 6 When the product is installed in some place with angle end user could adjust the PCBA to make the installation better 4 2 7 Connect the power after the inspection when short circuit cap at NO emitter module LED turns on receiver module LED turns on receiver module contact NC NO at ON when make the cap of emitter and receiver in alignment receiver module LED is off NC NO is off when something or someone shelter the sensor receiver module LED will turn on NC NO contact is ON When short circuit cap at NC the state of NO NO is opposite to the above phenomenon V Installation Pictures 1 Open the package and 2 Stick the holder 3 Drill holes and 4 Connect take out the accessories location map where fix expansion wires you need sleeve 6 Release screw NO 4 amp 5 5 Fix the screws NO 7 Install the top sc cumaaaave adjust the appropr2. Photocell P5200 user manual V8 Technical Specification Working voltage 12 24VAC DC Working current 24VDC emitter lt 8mA receiver lt 30mA Photocell wavelength 940nm Angle of emission lt 52 Receiving range 212m Angel adjustment of PCBA 902 Working temperature 202 60 C Relay contact loading capacity 1A 30VDC Size 100 40 35mm po Ne oe oe Se Safety Instruction For security please read the user manual carefully before initial operation This photocell is without any fuse so Please make sure the power is off before installation Only used this system that do not cause any danger life or property during the running failure or its security risks eliminated Please guarantee the products used in effective working range Picture Display FRS5200W 8 Procuuy s E cg Inftaed indicator I lt Power indicator Q LETH Receive Emitter MHO NC ontactor for nfrared switch mie le 2e4VAC IDC NCAN C 12V 24V 12V 24V AC ite Contactor AC DC output Wiring diagram IV Installation instruction 4 1 Receive module J4 in above picture PR5200 is the option switch for NO and NC of photocell switch 4 1 1 When the short circuit cap on NO it is normally open 4 1 2 When the short circuit cap on NC it is normally closed 4 2 Installation 4 2 The photocells should be installed more than 20cm above the ground to avoid reflection and the distance between emitter and receiver should
3. iate angle PR5200 j cover and fix the 1 2 3 with the base of PCBA 90 then fix ver 1X screw screws NO 4 5 is the same 9
Download Pdf Manuals
Related Search