LED16 Canister Light Owner`s Guide - 12-4055-r01
Contents
1. JoLuis LED16 Canister Light System TABLE OF CONTENTS PAGE 3 Introduction 4 Warnings gt Getting Started 5 Charging Information 5 Pre Dive 6 Post Dive Transport 6 Technical Specifications 7 Records 8 Notes Service 9 Contact Introduction Thank you for choosing the Hollis LED16 Canister Light System To help ensure its high performance and reliability please take the time to review and understand this manual This User s Guide describes the unique functions and features of the Hollis LED16 Canister Light System The more acquainted that you become with your new light the more you will enjoy your diving experience By following the instructions in this guide you will understand how your light works allowing the best use of its features It is very important to first read the entire contents of this manual before attempting to use your new light The LED16 is manufactured with pride in the USA All Hollis products are tested for function and water integrity before leaving the factory Hollis products are constructed with the highest quality materials and utilize the latest computer aided design and manufacturing techniques to ensure their highest performance and reliability 1 CAUTION This denotes instances that if not handled properly could result in damage to the equipment NOTE Represents important information CAUTION e It is essential that the diver read this guide to familiarize themselves wi2. ally charged state but never fully charged as this could shorten the battery life or damage the battery Pre Dive Confirm your battery pack has been charged for a full 5 hours and remove from charger Inspect the O ring on canister lid and seat on canister body Confirm the O ring is in place and free of any contaminants Be sure to position the banana plugs on canister lid in contact with the canister battery connection Press canister lid onto the body and seal using the locking latches on both sides Use of LED lamp out of water is not suggested for more than 30 seconds however is suggested for Pre Dive inspection If used out of water for more than 5 minutes the LED can build excessive heat and will switch to a lower setting This setting can be reset by switching the light off then back on Take this time to inspect the glass surface and LED for any visible damage or loose particles Do not look directly into light Post Dive Transport 1 Remove canister lid from the body and wipe with clean towel This will help remove any possible gases and or moisture If any excessive moisture is present recheck the O ring 2 Detach the light head from battery canister for transport to help avoid accidentally turning the light on off possibly damaging the switch battery and or LED Technical Specifications The LED16 canister system offers the power of HID with the reliability durability and efficiency of LED techno
3. ent in writing from Hollis LED16 Canister Light System Doc No 12 4055 2009 Hollis 2002 Davis Street San Leandro CA USA 94577 TRADEMARK NOTICE Hollis and the Hollis logo are registered or unregistered trademarks of Hollis All rights are reserved OuLis LI M T 2002 Davis Street San Leandro CA 94577 Phone 888 383 DIVE 510 729 5110 Fax 510 729 5115 www hollisgear com E mail info hollisgear com International Support and Service www hollisgear com international asp Hollis 2009 Doc No 12 4055 11 17 09
4. ion e DONOT store the light in a discharged state or with the light head connected to the battery e Carry a cutting device and be prepared to free yourself from the light if necessary DONOT use any aerosols on the inside of the canister as it could damage internal components or cause a fire hazard Getting Started Please take the time to get familiarized with your new light Included inside the box will be the light head connected to the canister lid Canister body sealed battery and charger assembly Charging Information Remove canister lid from body exposing the canister battery connection 2 Attach the battery to the charger Red to Red and Black to Black ov Plug charger into wall outlet Universal LiPo Smart Charger automatically adjusts to 110 220V current and 50 60Hz frequency Always ensure the charger is not covered and is not in direct sunlight Charge for 5 hours and disconnect after a full charge the LED will display green DO NOT leave the charger attached to the battery for a prolonged period of time beyond the charging cycle as this could damage the battery and or charger NOTE The included 5 7 Amp 11 1V Lithium ion Polymer LiPo rechargeable battery has a high energy density very good cycle life and is environmentally friendly LiPo batteries can be stored for several months without significantly losing charge However Unlike NiMh batteries after use it is suggested to store in a parti
5. logy This system offers a concentrated beam that is preferred for exploration diving including underwater signaling Powered with a Lithium ion Polymer rechargeable battery the LED16 burns at 1000 lumens of brightness for 4 hours This single LED offers the advantage of a very long 20 000 hour life and a concentrated 6 beam Light Head 16 Watt LED Weight 21bs in water 41bs above water Beam Degree 6 Degree Burn Time Approx 4 hours Output 1000 Lumens Bulb Life 20 000 hour life Charging Time Approx 5 hours Service Interval Visually inspect o ring before and after every dive Battery Lithium Polymer 5 7A h 11 IDCv Maximum Operating Depth 500 Feet 152 Meters Records Date of Purchase Hollis Dealer Dealer Phone No Inspections amp Service Date Service Performed Dealer Technician Notes MANUFACTURER WARRANTY 1 Year Limited For details refer to the Product Warranty section on the Hollis web site www HollisGear com SERVICE Please refer to the link below for service issues with your LED16 Light http www lightmonkey us serviceform COPYRIGHT NOTICE This user s guide is copyrighted all rights are reserved It may not in whole or in part be copied photocopied reproduced translated or reduced to any electronic medium or machine readable format without prior cons
6. th the proper setup care and use of any Hollis LED16 Canister Light System If the instructions given in this guide are not understood and followed serious damage to the light can occur DO NOT interchange NiMh and LiPo batteries and or chargers The electronics on each model are designed specifically for that model s intended battery type Using the wrong battery may cause combustion and injury e Avoid exposing the light to heat exceeding 100 F 37 7 C such as in the trunk of a car furnace rooms engine rooms etc Prolonged exposure to heat will shorten the life of the batteries and possibly damage them DONOT use any chargers other than an authorized Hollis charger to recharge your light Doing so may cause severe damage to the battery and will void the warranty e DO NOT expose the charger to moisture salt air sand or dust Keep it clean and dry at all times e Prior to storage for any length of time it is critical to ensure that the power leads have been disconnected e Avoid storing the light with the housing assembled Allow the housing to vent by setting in place but not securing it onto the canister body e If moisture has entered the canister DO NOT attempt to operate or store it with the housing assembled Take the canister top off to dry If moisture has entered the light head or internal canister return to your Authorized Hollis Dealer immediately where it should receive a factory authorized service and inspect
Download Pdf Manuals
Related Search