ML-6 User`s Manual - Unified Microsystems
Contents
1. HYI Unified Microsystems ML 6 User s Manual Revision 1 01 May 2013 Overview The ML 6 is a solid state replacement for the incandescent amp light illuminating Hy Gain HAM M HAM IV etc and CDE HAM M type rotor control boxes It is meant for control boxes with an incandescent lamp above the meter The ML 6 will provide more even illumination and longer life than the stock lamp In addition a trimmer allows LED light level adjustment Specifications Size 4 1 X 0 5 Power 24V AC internal rotor box supplied Approximately 60ma at full illumination Installation Warning High voltage is present inside the rotor control box Do not touch anything the inside of the case when power is on Follow these steps to install your ML 6 1 Unplug the AC power cable 2 Loosen or remove the screws holding the top cover on You can slip the cover off without completely removing the screws on the rotor boxes with plastic cases 3 Unplug the meter lamp 4 Remove the plastic cover on the Velcro pads 5 Orient the ML 6 LED side down over the meter The trim pot should be facing up and towards the middle of the control box 6 Press the ML 6 down against the top of the meter 7 Solder the two wires to the lamp socket tabs The Hy Gain HAM x type control boxes power the lamp with AC It does not matter which wire goes to which tab If you are using the ML 6 from a 24V DC source the red wire goes to the 24V side 8 Plug in2. the AC cord and turn the power on 9 Carefully adjust the trimmer on the top of the ML 6 to the desired light level 10 Turn the power off and unplug the AC cord 11 Replace the top cover and tighten the screws Note If the illumination over the meter is not even you can pull the board off and reposition it with the Velcro pads Warranty The ML 6 is warranted for 90 days from purchase date Unified Microsystems will at its option repair or replace defective units returned during the warranty period Unified Microsystems reserves the right to change specifications of it products at any time without notice Schematics user manuals and additional information can be found at www unifiedmicro com support Support is provided by email only w9xt unifiedmicro com Include ML 6 in the subject line for fastest response Unified Microsystems PO Box 133 Slinger WI 53086 www unifiedmicro com
Download Pdf Manuals
Related Search