Operating instructions - Andi
Contents
1. 5 sec onds after the last time you pressed the button and the actual temperature will be displayed The temperature can be set at between 5 C and 20 C Fan switch Thereby a climate which corresponds to that of a wine cellar is achieved inside the appliance Corks are prevented from drying out due to an increased level of humidity Switching on Press the Ven tilation button The symbol will light up b s Switching off Press the Ven eine Wehr tilation button again The lt symbol will go out Audible warning signal The audible warning signal helps to protect your wines against excessive temperatures It sounds when the door has been left open for longer than 60 seconds On Off Ventilation Alarm It sounds when the interior gets too warm or too cold The tem perature display will also flash The A symbol lights up The audible warning device is switched off by pressing the Alarm button The temperature display will continue to flash until the cause of the alarm has been rectified Interior light The interior light is fitted on the inside at the top The interior light can be switched on and off using the Light but ton The symbol lights up whenthe light is switched on Caution class 1M laser radiation When cover is removed do not look directly at light through optical instruments The lighting may only be replaced by the customer service technician or by compete2. dimensions mm min 200 cm 1 Remove the door 2 Unscrew the attachment 5 bracket min 200 cm Installing in a kitchen unit 1 Secure the stop brackets in the recess with screws 2 Connect the appliance to the mains 3 Move the attachment bracket to the right and screw into place 4 Rotate door by 180 3 Slide the appliance into the recess leaving a21 mmgap between the body of the unit and the front face of the door 4 Then secure the appliance with 4 x 14 chip board screws through the top bracket 5 Re attach the door 10 Setting up e Standard EN 378 specifies that the room in which you install your appliance must have avolume of 1 m per8 gofR 600arefrigerant used in the appliance so as to avoid the formation of inflammable gas air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance e Do not connect the appliance to the supply with other equipment using an extension cable risk of overheating Connecting to the mains Power supply AC and voltage at the operating point must comply with the details on the type plate which is located inside the appli ance on the left hand side The socket must be fused with a 10 A fuse or higher it must be away from the rear of the appli
3. hazard Climate rating The appliance is set to operate within specific ambient temperature limits according to its climate rating These temperature limits should not be exceeded The correct climate rating for your appliance is indicated on the type plate Climate rating Ambient temperature SN 10 C to 32 C N 16 C to 32 C ST 16 C to 38 C T 16 C to 43 C Description of appliance and equipment Operating and control elements Activated charcoal filter a Po Pull out shelves Type plate Safety instructions and warnings To prevent injury or damage to the unit the appliance should be unpacked and set up by two people e In the event that the appliance is damaged on delivery contact the supplier immediately before connecting to the mains To guarantee safe operation ensure that the appliance is set up and connected as described in these operating instructions Disconnect the appliance from the mains if any fault occurs Pull out the plug switch off or remove the fuse e When disconnecting the appliance pull on the plug not on the cable e Any repairs and work on the appliance should only be carried out by the customer service department as unauthorised work could prove highly dangerous for the user The same applies to changing the mains power cable Do not stand on the plinth drawers or doors or use them to sup port anything else This appliance is not intended for use by persons i
4. your dealer Changing the filter Take the filter by the handle Turn it 90 to the left or right and remove Inserting the filter Insert with the handle in avertical position Turn it 90 to the left or right until it clicks into place Defrosting The appliance defrosts automatically The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat Cleaning Before cleaning always switch off the appliance Pull out the mains plug or switch off or unscrew the fuse e Clean the inside equipment and outer walls with lukewarm water and a little detergent Do not use abrasive or acid cleaners or chemical solvents Do not use steam cleaners because of the risk of injury and damage e Ensure that no cleaning water penetrates into the electrical com ponents or ventilation grille e The dust should be removed from the refrigeration unit and heat exchanger metal grid at the back of the appliance once a year Do not damage or remove the type plate on the inside of the ap pliance It is very important for servicing purposes GB Malfunctions You may be able to rectify the following faults by checking the possible causes yourself e Appliance does not function Is the appliance switched on Is the plug correctly fitted in the mains socket Is the fuse intact e Loud running noise Is the appliance set up
5. Operating instructions Pages AA Wine storage cabinet 7081 179 00 WkKEes 309 Disposal notes e Keep packaging materials away from children polythene sheets and bags can cause suffocation e Please return the packaging to an official collection point Your old appliance This contains some reusable materials and should be disposed of properly not simply with unsorted household refuse e Discarded appliances should be disabled Remove the plug cut through the connection cable and render the catch unusable so that children cannotbecome trapped inside e Ensure that the refrigerant circuit is not damaged when the appliance that is no longer needed is taken away EEEEEEE for disposal e Details of the refrigerant can be found on the type plate e Appliances which are no longer needed must be disposed of ina professional and appropriate way in accordance with the current local regulations and laws Range of appliance use The appliance is suited only for storing wine In the case of com mercial food cooling the pertinent statutory regulations have to be observed The appliance is not suited forstoring and cooling pharmaceuticals blood plasma laboratory preparations or similar substances and products subject to the Medical Devices Directive 2007 47 EC Any misuse of the appliance may result in damage to or spoilage of the stored goods Furthermore the appliance is unsuited for use in areas exposed to an explosion
6. ance and must be easily accessible Connect the appliance with a properly earthed fused plug and socket only The wires in the mains lead are coloured in accordance with the following code green yellow earth blue neutral brown live Warning This appliance must be earthed Operating and control elements The electronic control panel has the new touch capacitance technology Any function can be activated by touching the cor responding icon The exact contact point I is between the symbol and its label st Th Light Up On Off Ventilation Alarm Operating elements Appliance ON OFF Temperature setting buttons Interior light ON OFF Mute alarm Fan ON OFF Temperature display Control elements Interior light ON symbol Alarm symbol Child lock activated symbol Fan ON symbol Switching the appliance on an off Switching on Press the On Off button so that the temperature display lights up flashes Switching off Press the On Off but ton for approx 3 seconds so that the temperature display goes out Setting the temperature To reduce the temperature Press the Down button To increase the temperature Press the Up button While you are entering the tem perature the set temperature will flash on the display You can change the settings in increments of 1 C briefly pressing the button again The electronic controls will switch over automatically about
7. firmly on the floor Does the appliance cause nearby items of furniture or objects to vibrate Please note that noises caused by the refrigerant circuit cannot be avoided e The temperature is not low enough Is the temperature setting correct see Setting the tempera ture Does the separately installed thermometer show the correct read ing Is the ventilation system working properly Is the appliance set up too close to a heat source If none of the above causes apply and you cannot rectify the fault your self contact the nearest customer service department stating the type designation service number and appliance number as indi cated on the type plate The type plate is located inside the appliance on the left hand side TAMA x kg 24h Shutting your appliance down If your appliance is to be shut down for any length of time switch it off and disconnect the plug or switch off or unscrew the fuse Clean the appliance and leave the door open in order to prevent unpleasant smells The appliance complies with the relevant safety regulations and EC Directives 2004 108 EC and 2006 95 EC 13
8. ncluding chil dren with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance Avoid prolonged skin contact with cold surfaces or chilled frozen food This could cause pain numbness and frostbite In the case of prolonged skin contact protective measures should be taken e g gloves should be worn e Do not consume food which has been stored for too long as it could cause food poisoning e If you have a lockable appliance do not keep the key near the appliance or within reach of children Do not store explosives or sprays using combustible propellants suchas butane propane pentane etc in the appliance Electrical components might cause leaking gas to ignite You may identify such sprays by the printed contents or a flame symbol Do not allow naked flames or ignition sources to enter the appli ance When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged In the event of damage make sure that there are no ignition sources nearby and keep the room well ventilated e Do not use electrical appliances inside the appliance IMPORTANT Remove all transportation safety components GB Changing over door hinges Installation
9. nt skilled personnel Furthermore the brightness of the lighting can be adjusted Press and hold the Light button and at the same time press the temperature setting buttons to increase or decrease the bright ness Down darker Up brighter GB Setup mode The following functions can be activated in setup mode E child lock y display brightness E Child lock The child lock is designed to protect the appliance from being switched off accidentally Activating the child lock e Activate setup mode by pressing the onds lt button for 5 sec Ventilation The display reads IZ e Press the A button Ventilation 1 The display reads IZ f e Press the button again Ventilation The FO symbol will light up to indicate that the child lock is acti vated e Exit setup mode by pressing the hed button Deactivating the child lock e Activate setup mode by pressing the onds 4 button for 5 sec Ventilation The display reads IZ e Press the lt button Ventilation The display reads hm l h e Press the button again Ventilation The symbol will go out indicating that the child lock is deac tivated e Exit setup mode by pressing the kd button Display brightness Adjusting the display brightness e Activate setup mode by pressing the onds lt button for 5 sec Ventilation e Press the x button until H appears in the display Press the 4 bu
10. tton Ventilation The display reads h5 e Press the A buttons and set the brightness between Up m h D minimum and h 5 maximum e When you reach the desired level press the 4 button Ventilation l e Exit setup mode by pressing the O button On Off e Close the door The new setting will activate after about 1 minute 11 12 Storing wine Equipment If you are storing wine for long periods of time itshouldbe stored Pull out grid shelves at a temperature of between 10 C and 14 C a The pull out grid shelf allows bottles of wine This is the temperature wine cellars are kept at and it is justright to be removed more easily to allow wine to mature properly The following drinking temperatures are recommended for the various types of wine Red wines 14 C to 18 C Ros wines 10 C to 12 C White wines 8 C to 12 C Sparkling wines Prosecco 7 C to 9 C Champagne 5 C to 7 C Storage diagram for 750 ml Bordeaux bottles Total 18 bottles Tall wine bottles can also be stored crossways in the appliance To ensure stable storage of the bottles click the retaining plates Air exchange with activated charcoal filter The way in which wines continue to mature depends on the ambient conditions The quality of the air is therefore decisive for preserving the wine We recommend that you replace the illustrated filter once a year Filters can be obtained from
Download Pdf Manuals
Related Search