Model WMIC2A
Contents
1. 3 Painting this product is prohibited Do not paint this product Painting will affect it s normal use 4 Do not hit or drop the product Packing List Components 3 5mm Audio Cable Foam Quick Start Guide I Wireless Mic USB Cable Lanyard Collar Clip Mic Transmitter Instruction Speaker AUX OUT to other module DC IN AUX IN Audio in phone jack MIC in phone jack z p DC 5V power jack A gt Volume increase ON Power on Mic Audio switch lt Volume decrease OFF Power off Signal lights Mic Transmitter Caution Special note The center button on the mic transmitter switches the audio between the AUDIO IN port and the MIC IN port This could be the reason that the Mic is not heard Speaker assembl Installation 1 Put the foam pads on the inner side of speaker el S U x 1 i ee Connect main module and auxiliary module by metal hooks and locate on the pole Audio Source Connection Connect main module and auxiliary module audio cables Connect main module and projector by audio cable Power Connection power cord power cord Charging the MIC TRANSMITTER Battery The miniature MIC TRANSMITTER is charged using the cable with the USB connector and the small DC power connector pin which inserts into the top of the TRANSMITTER The USB end is plug2. Model WMIC2A Wireless Sound System User s Guide DUKANE iHear 13 00032 vO1 Introduction Thank you for buying this product e f you need service contact your dealer or call Dukane e Please read the User s Manual before using e Receiver Amp Electronic equipment specification Input DC19V 2A O 6 Rating 110V 240V e MIC Tx Electronic equipment specification Input USB DC 5V to charge the transmitter DUKANE CORP AV SERVICE DEPT 2900 Dukane Drive St Charles IL 60174 800 676 2487 Fax 630 584 5156 avservice dukane com www dukane com av service Notice FCC Radiation Exposure Statement The equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency RF Exposure Guidelines in Supplement C to OET65 The equipment has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio SAR 1 Changes or modifications are not expressly approved by the manufacturer could void the user s authority to operate the equipment Changes or modifications to the device may void FCC and CE compliance In frequently used radio links should be tested regularly to protect against undetected interference or fault 2 Operation is subject to the following two conditions 1 this device may not cause interference and 2 this device must accept any interference including interference that may ca
3. signal lights flash 3 Please make sure the speaker has power No signal light on the mic transmitter after it has been turned ON Please charge the mic transmitter Low voice sound when using the mic transmitter Manually adjust the volume button to increase volume The mic transmitter doesn t work when charging is attempted Please check to see if the power adapter is plugged in The system can t complete matching process 1 Please make sure the mic distance is within 10 feet of the speaker 2 Please make sure the power is ON How long can the mic be used The complete charging process requires at least 4 hours of continuous charging The mic can be used at least at least 8 hours The mic transmitter red LED will begin to slowly flash every 2 seconds once there is less than 1 hour of operating time remaining Special note The center button on the mic transmitter switches the audio between the AUDIO IN port and the MIC IN port This could be the reason that the Mic is not heard DUKANE CORP AV SERVICE DEPT 2900 Dukane Drive St Charles IL 60174 800 676 2487 Fax 630 584 5156 avservice dukane com www dukane com av service
4. ged into a powered USB port such as on a computer A constant on red LED indicates the battery is charging Please be sure the USB port remains active If the computer goes to sleep the port will go OFF and the port will discharge or drain the TRANSMITTER battery 10 Connecting Components Wireless microphone connection small Power Adapter USB port DVD USB cable External Mic Audio cable Collar Mic Clip the collar mic to the necktie or collar and point the mic toward the throat 11 Light Signal Specification Blue Light vokTashing Matching state km ow fashing Matoh successfull in connecing seis ow ashing MIG mode fash ore tme every 25s ow lasing Audio mode i fash wo times every 255 Charging red light tuns off automatically after charging complete Slow flashing LOW power and need to charge if flash one time every 2 5s Quick flashing NO signal connection between mic and speaker Matching Procedure 1 Turn on the mic frequency matching procedure needs 3 seconds 2 After the mic Red Blue LED s are alternately flashing a Beep Beep sound will be heard This means the mic and speaker receiver are paired matched 3 Matching distance is under 10 feet between mic and speaker 4 Make sure the bottom of mic transmitter is not blocked ON 5 Ifthe matching pairing of the system does not occur the MIC TRASMITTER may need to be reset Turn the MIC TRANSMITTER OFF The
5. n press and hold a button on the multifunction switch and turn ON the MIC TRANSMITTER Release the button after the red LED comes ON 12 13 Mode Setup Settings for the AUX AUDIO INPUT on the Speaker There are 3 modes of operation for the AUX AUDIO input on the top of the speaker unit This Input is located next to the DC INPUT The audio entering this port can be set to operate in one of 3 ways Mode 1 MIC Only Only sound from the Miniature MIC TRANSMITTER is amplified No AUDIO AUX it is turned Off Mode 2 Mixed audio The MIC TRANSMITTER and AUX AUDIO INPUT are mixed Mode 3 MIC priority operation The MIC audio when present will have the priority and turn off the AUX AUDIO Setting the mode The MIC TRANSMITTER is used to set the mode Start with it OFF Mode 1 Hold the MIC TRANSMITTER key1 Volume up button and turn ON the power Mode 2 Hold the MIC TRANSMITTER key2 Right key button and turn ON the power Mode 3 Hold the MIC TRANSMITTER key3 Volume down button and turn ON the power See the figure MIC TRANSMITTER QO 0 Speaker Top View connections AUX OUT Connected to the right speakers AUX IN For example PC MP3 Troubleshooting 1 A 6 Q A gt gt Oo FO FO FO The mic transmitter is ON but no sound is heard 1 Please make sure the mic transmitter is within 10 feet of the speaker unit 2 Please make sure the mic transmitter has power The LED
6. use undesired operation of the device Danger 3 Don t modify this product in any way Such action could cause a fire electric shock serious personal injuries or product damage Only a distributor or service center can provide maintenance and repair 4 Please keep away from flammable or explosive gases when using this product 5 If any liquid or object enters the product stop use of the product Please contact the distributor or a service center and don t continue to use the product 6 Operating this product with wet hands could cause electric shock 7 Don t use this product while in an aircraft Warning 1 For safety reasons please keep the product and accessories out of reach of small children or animals to avoid accidents such as swallowing the product or accessories If this happens please see a doctor immediately Some small parts of product could cause personal injuries 2 Do not place this product in a high temperature environment high or low temperature environments may negatively effect the internal parts or even result in fire Do not place in microwave oven radiator or refrigerator since this may cause the product battery to explode Caution 1 If a credit card is held near the speaker it will be demagnetized Please keep credit cards away from this product 2 A malfunction of this product will occur if using a power adapter that doesn t match the one supplied with the product
Download Pdf Manuals
Related Search