M2-A Agitatore magnetico riscaldante analogico
Contents
1. 0 C LED Heating 4 Faults e In the event of instrument failure shut it down Fa e Turn off the main switch ON OFF for a few seconds and then switch on again Pee e The stirring function will continue to operate at the set speed before it happened the fault e The heating function will continue to operate at the set temperature before it happened Heating knob Stirring knob the fault Switch ON OFF e If the problem is not solved call your technical service center 5 Maintenance and Cleaning e Proper maintenance of the instrument guarantees the conditions and extend its life e Unplug the power cord before cleaning e When cleaning be careful not spray the cleaner inside the instrument e Use only mild detergent and do not contain abrasives e Before starting with any cleaning or decontamination the user must ensure that the method used does not damage the instrument e Wear suitable protection when cleaning with chemicals e If the instrument must be returned for service it is necessary a proper cleaning and decontamination by pathogens You should also put the instrument in its original packaging to send it to repair 6 Associated standards and regulations Construction in accordance with the following safety standards EN 61010 1 UL 3101 1 CAN CSA C22 2 1010 1 EN 61010 2 10 Construction in accordance with the following EMC standards EN 61326 1 Associated EU guidelines EMC guidelines 89 336 EWG2. ARGO LAB M2 A Analog Hotplate Magnetic Stirrer User Manual ARGO LAE 1 Safety instructions o Set the desired rotation speed between 0 and 1500 rpm The Stirring knob E 2 l function of agitation is activated deactivated by turning the knob Set the desired temperature between room temperature and e Read the instructions carefully before use Ensure that only qualified personnel using this tool Do not heat flammable or highly volatile substances Be very careful when you touch the heater plate It can pes knob 340 C The function of agitation is activated deactivated reach a temperature of 340 C Pay attention even when the by turning the knob When the heating function is activated the heating LED is LED Heating switched on o When the function is activated the stirring LED is switched LED Stirring on Switch ON OFF Turns on or turn off the instrument Observe the minimum distance between the instruments and between the device and the wall minimum 10 cm 3 Operation power has been turned off because the plate stays hot even longer e Place the device on a stable surface make sure the temperature control knob is set at minimum and connect the power supply e Turn on the instrument Turn the control knob to set the speed of the rated rotary speed in the safe speed limit 0 1500 rpm e Turn the temperature control knob to set the required temperature in the safe limit 0 34
3. Machine guidelines 73 023 EWG 7 Technical data Hotplate material Stainless steel Hotplate diameter 135 mm Heating power 500 W Temperature range RT to 340 C Temperature indication Analog Dimensions L x P x A 280 x 160 x 65 mm Weight 2 8 kg Permitted ambient temperature 5 40 C Permitted relative humidity 80 Protection class IP IP42 Voltage Frequency 220V 50 60Hz Power 530W Max stirring quantity H20 20 liters Max magnetic bar 80 mm Motor type Brushless Speed range 0 1 500 rpm Speed indication Analog 8 Disposal Information regarding the disposal of electrical and electronic equipment European Union Electrical and electronic equipment marked with the symbol on the side cannot be disposed of in landfills In accordance with EU Directive 2002 96 EC the European users of electrical and electronic equipment have the opportunity to give back to the distributor or manufacturer upon purchase of a new one The illegal disposal of electrical and electronic equipment is punished with an administrative fine
Download Pdf Manuals
Related Search