Contents Assembly Mains Lead Wiring Instructions Safety
Contents
1. Contents 1 x Smoke Machine 1 x IEC Mains Lead 1 x Hanging Bracket 1 x Remote Control 2 XSpacers 4 x1 Lite Fluid Bottles 2 x Locking Handles Assembly Assemble the hanging bracket using the spacers and locking handles as shown Remove the cap from one of the fluid bottles and discard Place the bottle in the compartment as per drawing Place the pipe that is attached to the smoke machine inside the botte and firmly screw down the cap Safety Always use a J EM MARTIN approved fluid other fluids could be dangerous and can cause damage to the machine Always check the voltage is conect for use with the machine the voltage is pnnted on the senal label Always read the instuctions for use before operating the machine smoke machines need to be operated carefully to avoid risk Never touch the nozzle at the front of the machine the nozzle can stay hot forup to 10 hours Mains input Fuse drawer OY MW g Do not remove the coverorattemptto repaira faulty machine an authonzed J EM dealershould be contacted in the event of a fault Always use smoke machines in well ventilated areas overuse could affect sufferers of asthma orother senous respiratory disorders Do not use the machine if there is a faulty mains lead orplug this could be dangerous Do not spill fluid overthe machine if fluid is spilt wipe down with a clean damp cloth An approved J EM dealer should be co2. ntacted for advice Keep the output of the machine at least 60cm 2 ft away from peope and surfaces v Martin Hanging Bracket Locking Handle Mains Lead Winng Instuctions Brown Live Blue Neutral Green Yellow Earth Always use the correct Fuse in the machine EU 5amp US 10 amp Note This appliance must be earthed Instuctons for use Connect the two leads into the sockets as indicated Tum the machine on the on off button and the remote control light will illuminate From cold the machine will take approxmately five minutes to reach operating temperature when the light on the remote contol has gone out the machine is ready to use If this is the first time the machine has been used orthe bottle has been changed the pump will require priming Press the button on the remote contol untill smoke emerges from the output nozzle this will take approximately five seconds When the light on the remote contol comes on again it indicates that the machine is reheating this will take approximately two minutes Olof Palmes Alle 18 DK 8200 Aarhus N Phone 45 87 40 00 00 Fax 45 87 40 00 10 Internet www martin dk
Download Pdf Manuals
Related Search