SATA II PCI EXPRESS CARD User Manual
Contents
1. SATA II PCI EXPRESS CARD User Manual Features and Benefits Compliant with PCI Express Base Specification 1 0a Compliant with Serial ATA 1 0a specification with support for full complement of SATA II optional features PCI Express 1 lane x1 SATA Il adapter works with PCI Express slots with different lane width Installs in any available PCI Express slot and support data transfer rates up to 3 0Gbps 300MBps Supports Native Command Queuing NCQ Non zero offsets NCQ and Out of order date delivery NCQ Independent command fetch scatter gather and command execution Hot swapping feature allows you to attach detach SATA device without first powering your computer off Supports Windows 7 Vista XP 2000 Package Contents 1x PCle SATA II 300 Card 1x SATA Cable 1x SATA Power Cable 1x Driver CD 1x User Manual System Requirements Windows 7 Vista XP 2000 e PCI Express enabled system with an available PCI Express slot Hardware Description N N Jumper Settings Default Mode 2 3 close N 1 2 3 A SATA Connector 1 External B SATA Connector 2 Internal C Jumpers Jumper Settings J1 J4 t2close Enable SATA Connector 1 23close Enable SATA Connector 2 Note There are two SATA ports in PCle SATA II 300 Card We name these ports A and B Port A is external SATA port and B is internal SATA port Only one of them will work but not both at the same time Please set which port to work by ju2. llation To Verify Windows 2000 XP Server 20003 Installation Click on the Device Manager tab in System Properties which you access from the Windows Control Panel You should see an Silicon Image Sil 3531 SATA Controller installed under SCSI and RAID controllers item START gt Control Panel gt System gt Device Manager amp SCSI and RAID controllers amp Silicon Image Sil 3531 SATA Controller Hot Plugging A Hard Disk Drive To remove a drive from a powered up system do the following 1 Right click My Computer and click Manage 2 Select Device Manger 3 Click Disk Drives right click the target disk and select Disable Enable 4 You can now remove the target disk
3. mper setting By default Port B is working Hardware Installation 1 Turn off the power to your computer 2 Unplug the power cord and remove your computer s cover 3 Remove the slot bracket from an available PCle slot 4 To install the card carefully align the card s bus connector with the selected PCle slot on the motherboard Push the board down firmly 5 Attach your internal or external devices to the PCle SATA II 300 Card 6 Replace the slot bracket s holding screw to secure the card 7 Replace the computer cover and reconnect the power cord Driver Installation For Windows XP Server 2003 1 At the Found New Hardware Wizard XP w SP1 or earlier Server 2003 continue to step 2 XP w SP2 or later Server 2003 w SP2 or later Select No not this time then click Next 2 Please insert the driver CD into your CD ROM Drive select Install the software automatically Recommended and click Next 3 Accept the default entry then click Next 4 Click Finish 5 Repeat steps 1 4 6 Click Yes to restart to complete the installation For Windows 2000 1 At the Found New Hardware Wizard click Next 2 Select Search for a suitable driver for my device recommended then click Next 3 Insert the driver CD into your CD ROM Drive check CD ROM drives uncheck the other boxes click Next then click Next again 4 Click Next then Finish 5 Repeat steps 1 4 6 Click Yes to restart to complete the insta
Download Pdf Manuals
Related Search